brake light AUDI A6 1998 C5 / 2.G 01E Transmission Clutch Mechanism Service Workshop Manual
Page 14 of 27
30-14
12 -
Plastic slave cylinder
Do not operate clutch pedal after slave
cylinder has been removed Brake fluid must not be allowed to get onto
the transmission Lightly grease to install Fig. 1When installing push in until the securing
bolt can be fitted. With plug-in connection for hose/line
assembly Disconnecting hose/line assembly Fig. 2Follow correct sequence of work when
bleeding Page 30
-25
.
13 -
Bleeder valve
Tighten to 4.5 NmFollow correct sequence of work when
bleeding Page 30
-25
A broken off bleeder valve can be removed
using a 3mm hex socket wrench
Pa
ge 14 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1
Page 18 of 27
30-18
Note: - Unscrew both nuts -A-.
- Lift E-box off studs at the rear and then pull it out of securing point -B-.
In the following procedures, make sure that no brake fluid escapes
into the plenum chamber or onto the transmission below. If this does
happen, clean the affected areas thoroughly. When performing work in the footwell, put cloths on the carpet to
protect it from possible brake fluid spills.
- Clamp supply hose -A- from brake fluid reservoir using special tool
3094. Pull hose off master cylinder and plug hose.
- Remove rubber grommet for compensation hose above connecting line
from transverse wall.
- Pry out retaining clip -C- using a screwdriver and pull line -B- out
slightly.
Pa
ge 18 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1