ECU AUDI A6 1998 C5 / 2.G 01E Transmission Clutch Release Mechanism Workshop Manual

30-29


10 -
Clutch slave cylinder
Bleeding clutch system Page 30
-25
Removing and installing Page 30
-32
When installing, push on until the securing
bolt can be fitted
11 -
Bolt, 20 Nm Self-lockingAlways replace
12 -
Bracket for hose/line assembly Engage in clutch slave cylinder
13 -
Push rod Coat contact surface of push rod with
copper grease, e.g. Z 381 351 TE
Pa
ge 3 of 9 Clutch release mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.2

30-33


Installing
Installation is carried out in the reverse order, when doing this note the
following:
Note: - To disconnect line, first pry out retaining clip -A- with a screwdriver until
it disengages audibly. Line can then be pulled out.
Do not allow brake fluid to come into contact with the transmission. If
necessary, clean the transmission housing. If the clutch slave cylinder is inserted off-line there is a danger that the
push rod will be guided past the clutch release lever. To facilitate installation, engage 6th gear (6-speed transmission) or
4th gear (5-speed transmission) before fitting the slave cylinder. Pre-tension the clutch slave cylinder far enough for the securing bolt
to be easily inserted. Always replace securing bolt.
Pa
ge 7 of 9 Clutch release mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.2