wiring diagram AUDI A6 1998 C5 / 2.G AEB Engine Motronic MFI And Ignition System
Page 116 of 135
24-85
      
Checking fuel pump relay signal  
     
Fuel pump relay -J17- removed 
     Fuses 28, 29 and 34 removed from fuse 
panel 
    
If the LED test light does not light up while cranking the starter, check 
wiring as follows.  -  Connect VAG 1527B LED voltage tester between relay socket 
terminals 28 (B+) and 29. 
   LED test light must light up (dimly).
-  Briefly crank starter; LED test light must continue to light up (dimly).
    
If resistance is NOT OK:  -  Connect VAG 1598/22 test box to ECM harness connector   Page 01
-
56
 . (Numbers marked on ECM connector match those on test box). 
-  Connect multimeter US 1119 (Fluke 83 or equivalent) to check for open 
circuit between relay socket terminal 29 and test box socket 4. 
  
Specified value: max. 1   -  Repair wiring using applicable wiring diagram.
Pa
ge 116 of 135 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU02.24.1 
Page 117 of 135
 Electrical Wiring Diagrams, Troubleshooting & Component Locations.   
Pa
ge 117 of 135 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU02.24.1 
Page 119 of 135
24-87
      
Fuel injector actuation, checking
 
      Triggering fuel injectors via output Diagnostic 
Test Mode (DTM)   Page 01
-42
   
     
Required special tools and test equipment  
     
VAG 1598/22 test box 
     Multimeter US 1119 (Fluke 83 or equivalent) 
     VAG 1527B LED voltage tester 
     VW 1594 connector test kit 
     Wiring diagram 
     
Test requirements  
     Fuse for fuel injectors OK 
     Engine speed (RPM) sensor OK 
     Fuel pump relay OK 
Pa
ge 119 of 135 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU02.24.1 
Page 121 of 135
24-89
       If LED does not flicker:  
     
-  Switch ignition off.
     
-  Connect VAG 1598/22 test box to ECM harness 
connector  Page 01
-56
 . 
     
-  Check wiring for open circuits between ECM/test 
box and fuel injector harness connectors: 
     
 
Cyl. 1 fuel injector terminal 2 to ECM/test 
box socket 73 
     
 Cyl. 2 fuel injector terminal 2 to ECM/test 
box socket 80 
     
 Cyl. 3 fuel injector terminal 2 to ECM/test 
box socket 58 
     
 Cyl. 4 fuel injector terminal 2 to ECM/test 
box socket 65 
     
 Specified value: max. 1.5 
     
-  Check wiring for open circuit between fuel 
injector connector terminal 1 and relay panel, 
according to wiring diagram. 
Pa
ge 121 of 135 Motronic Multi
port Fuel In
jection 
(MFI
) and i
gnition s
ystem
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU02.24.1