ignition AUDI A6 1999 C5 / 2.G 01E Transmission Clutch Mechanism Service Workshop Manual

30-1


Clutch mechanism, servicing

Note:

For vehicles with coded radio, obtain and note
the radio code.
Disconnect battery Ground strap with the
ignition switched off.
Lubricate all bearings and contact surfaces with
G 052 142 A 2 polycarbamide grease.
Before working on pedal cluster, remove cover
below dash panel:

Repair Manual, Body Interior, Repair Group
68


Make sure that no brake fluid escapes into the
footwell, the plenum chamber or onto the
transmission below. If this does happen, clean
the affected areas thoroughly.
When performing work in the footwell, put
cloths on the carpet to protect it from possible
brake fluid spills.
Pa
ge 1 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1

30-17

Master cylinder, removing and installing


Special tools, testers and auxiliary items

Removing
Remove E-Box from plenum chamber as follows:
Hose clamp 3094
- If installed, remove cover above plenum chamber.
- Disconnect battery Ground (GND) strap with the ignition switched off.

Repair Manual, Electrical Equipment, Repair Group 97
- Pull off clip -1- and lift wind grill -A- slightly. Now remove screw (arrow -
2-).
- Remove remaining screws (arrows) and remove cover.
- Remove engine control unit and 8-point relay carrier (if fitted)
- Unplug connector in connector station.
- Pull engine wiring harness together with rubber grommet out through
opening in electronics box.
Pa
ge 17 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1