ECU AUDI A6 1999 C5 / 2.G 01E Transmission Final Drive Pinion And Ring Gear Adjustment Workshop Manual
Page 15 of 38
39-156
- Secure retainer 3304 with two M8 x 30 hex bolts.
- Support final drive when tightening nut (e.g. using universal support
V.A.G 1359/2 in conjunction with transmission jack V.A.G 1383 A).
- Fit a new drive pinion nut.
- Tighten drive pinion nut just far enough so that no play can be felt at
drive pinion.
- Gradually increase tightening torque, checking friction torque at regular
intervals, unti specified friction torque is obtained.
The following friction torques should be set: 1) run at least 50 km (30 miles) A - Torque gauge, commercially available, 0-600 Ncm
B - Extension with 32 mm socketNew bearings
Used bearings
1)
200-250 Ncm 30-60 Ncm
Pa
ge 15 of 38 Drive
pinion and rin
g gear, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.19