tow AUDI A6 2000 C5 / 2.G 01E Transmission End Cover Service Workshop Manual

34-106


Fig. 1 Pulling cylinder roller bearing for input shaft out of end
cover
A - Internal puller 37-46 mm, e.g. Kukko 21/6
B - Spindle from counter support Kukko 22/2

Fig. 2 Pressing cylinder roller bearing for input shaft flush into
end cover
Tube VW 415a with shoulder towards press tool VW 412
Pa
ge 4 of 9 End cover, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.8

34-107


Fig. 3 Removing ball bearing for input shaft from end cover
- Position screwdriver as illustrated, drive into baffle plate (arrow) and
pry out.
- Remove circlip.
- Take out bearing, remove peening indentations if necessary.

Installation position of circlip:
Note:
The thickness of the circlip must be re-determined if the bearing or the
end cover are replaced. Fig. 4 Installing ball bearing for input shaft in end cover
Ends of circlip (arrows), point towards needle bearing
Pa
ge 5 of 9 End cover, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.8