lock AUDI A6 2000 C5 / 2.G 01E Transmission Remove And Install Workshop Manual
Page 16 of 21
34-33
Installing
Installation is carried out in the reverse order,
when doing this note the following:
- Always replace all seals and gaskets.
- Always replace all self-locking nuts.
- Check whether dowel sleeves for aligning
transmission with engine are in engine flange.
Insert if necessary Page 34
-36
.
- Clean input shaft splines and (in the case of
used clutch plates) hub splines. Remove
corrosion and apply only a very thin coating of
grease G 000 100 to splines. Do not grease
guide sleeve.
- Check clutch release bearing for wear and
replace if necessary.
- Coat area -a- of collar with lithium grease G 052 150 A2 before
mounting slave cylinder into transmission housing.
- Coat contact surface for clutch slave cylinder push rod with a thin layer
of copper grease, e.g. Z381 351 TE.
Pa
ge 16 of 21 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.2
Page 17 of 21
34-34
- On vehicle with V6 bi-turbo engine, fit
intermediate plate on dowel sleeves on engine
flange.
- Two hex socket head bolts M 10 x 60 must be replaced by new hex
bolts M 10 x 55 (Part No. N 104 684 01) so that two bolts (arrows) can
be tightened with a torque wrench after installing transmission.
- Before installing transmission, tie electrical wiring off to one side so that
it cannot be trapped between engine and transmission.
Repair Manual, 2.7 Liter V6 5V BiTurbo Engine Mechanical, Engine
Code(s): APB, Repair Group 26
- Lift transmission until clutch slave cylinder with bracket for line/hose
can be installed (arrow).
- Align exhaust system free of stress.
- Before installing, use a tap to clean threads in drive flange for
driveshaft on transmission to remove traces of locking compound.
- Replace gaskets on drive axles and on front of driveshaft Page 39
-
65
.
Pa
ge 17 of 21 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.2
Page 18 of 21
34-35
- Bolt on driveshaft Page 39
-71
.
- Check adjustment of selector rod and push rod;
readjust if necessary Page 34
-12
.
- Check oil level in transmission Page 34
-39
.
- After connecting battery, enter anti-theft code for
radio
Radio operating instructions
- Close windows fully using electric window
switches.
- Operate all electric window switches again for at
least one second in "close" direction to activate
automatic one-touch function.
- Set clock to correct time.
Pa
ge 18 of 21 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.2