coolant temperature AUDI A6 2000 C5 / 2.G AEB ATW Engines Cylinder Head Remove And Install Workshop Manual
Page 4 of 35
15-5
CAUTION!
Part numbers are listed here for reference only.
Always check with your Parts department for
the latest information. 12 -
Cylinder head cover gaskets
Replace if damaged or leakingBefore installing, seal contact surfaces with
sealant D 454 300 A2 Fig. 3
and
Fig. 4
13 -
Coolant flange
With coolant temperature sensor
14 -
Bolt 10 Nm (7 ft lb)
15 -
O-Ring Always replace
Pa
ge 4 of 35 C
ylinder head, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.15.2
Page 22 of 35
15-22
- Disconnect harness connector -1- at Engine Coolant Temperature
(ECT) sensor -G2-/-G62-.
- Disconnect harness connector -2- at temperature sensor II -G18-.
- Unclip all connections from cylinder head and move clear.
- Remove crankcase ventilation line -1-.
- Remove oil supply line at cylinder head -2-.
- Remove heat shield -3-.
- Unbolt turbocharger from exhaust manifold -4-.
- Disconnect coolant hose to heat exchanger at rear of cylinder head,
also detach retaining clamps at connecting flange.
- Remove upper toothed belt cover Page 13
-29
.
Pa
ge 22 of 35 C
ylinder head, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.15.2