ESP AUDI A6 2000 C5 / 2.G AEB ATW Engines Valvetrain Servicing Workshop Manual

15-63

- Thread VW653/3 pressure hose into spark plug
hole.

Note:
Lightly tap valve spring retainer to loosen stuck
valve keepers.

Intake and exhaust valves have different installation angles in cylinder
head. 3362 valve spring tool can be used in two different positions:
1 - Top position for the center intake valve
2 - Lower position for both outer intake valves and both exhaust valves
3 - Threaded bores with M6 x 25 retaining bolts on the left and right are
used to secure the lower bracket to cylinder head

- Using retaining bolts bolted into tool, secure 3362 valve spring tool to
cylinder head.
- Adjust tool to correct position for corresponding valve.
- Attach pressure hose to compressor.
Minimum pressure: 6 bar (87 psi)
- Using threaded spindle and 3362/1 pressure piece, press valve springs
downward and remove.
Pa
ge 39 of 51 Valvetrain, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.15.3

15-71

Valve seats, refacing


Note:
If a perfect contact pattern isn't obtained after
hand lapping valves, reface valve seats.

Special tools and equipment

Depth gauge
Valve seat refacing tool

Note:
When servicing engines with low compression
due to leaking valves, it is not sufficient to
reface or replace the valve seats and valves. It
is especially important to check valve guides for
signs of wear on high-mileage engines Page 15
-66
.

Only reface valve seats enough until a perfect
contact pattern is obtained.
Before refacing, determine maximum refacing
dimension.
If refaced dimension is exceeded, hydraulic
Pa
ge 47 of 51 Valvetrain, servicin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.15.3