brake AUDI A6 2000 C5 / 2.G Changing Clutch 5Speed Manual Gearbox

brake servo -arrows- to 25 Nm. ‒ → Screw in the bolt for the brake
fluid reservoir -1- and attach the
connector for fluid level.
All models: ‒ → Tighten the hexagon socket head
bolt -arrow B- for securing pedal
cluster to dash panel crossmember
to 25 Nm. ‒ Connect clutch pedal to master Page 5 of 65-Speed Manual Gearbox 01A 4WD4.3.2014vw-wi://rl/A.en-GB.4B-S-S01AA.wi::21141312.xml?xsl=2

cylinder. Clip pin onto clutch pedal.
‒ → Press retaining clip -C- home.
‒ Push pipe -B- into master cylinder
until it audibly locks in place.
‒ Insert rubber grommet -D- over
connection pipe/supply hose -A- into
the cross panel.
‒ Push supply hose -A- for the brake
fluid reservoir on to limit stop.
‒ Remove special tool 3094.
‒ After installing the master cylinder,
bleed the clutch system =>Page 30-30.
‒ If fitted, check the adjustment of the
clutch pedal switch -F 36 => Page
30-8.
‒ Install storage compartment for
driver's side: => General Body Assembly, Interior; Repair group 68; Storage compartments, covers; Removing driver's storage compartment Page 6 of 65-Speed Manual Gearbox 01A 4WD4.3.2014vw-wi://rl/A.en-GB.4B-S-S01AA.wi::21141312.xml?xsl=2

Servicing clutch mechanism Bleeding clutch system Special tools, testers and auxiliary items required
◆ Brake filler and bleeder unit V.A.G
1869
or
◆ Brake filler and bleeder unit V.A.G
1238 B
Notes:
◆ The clutch system must be bled after performing work on the hydraulic clutch mechanism.
◆ Top up brake fluid reservoir to "max"
marking with brake fluid before
bleeding clutch system.
◆ Open the bleeder valve before
switching on the bleeder unit.
◆ When performing the following steps,
ensure that no brake fluid escapes
onto the gearbox.
‒ Pull clutch pedal back to its normal rest position.
‒ Connect brake filler and bleeder unit
V.A.G 1238 B or V.A.G 1869, but do
not switch on at this stage.
‒ Remove shield, if fitted, from
underneath gearbox. ‒ → Connect bleeder hose -A- to slave
cylinder (arrow) and open bleeder
valve.
‒ Connect bleeder hose to pressure
hose of fluid collector bottle.
‒ Switch on the bleeder appliance and
allow about 100 cm3 of brake fluid to
drain out.
‒ Working pressure 2.5 bar
Note:
Ensure bleeder hose is correctly fitted during
bleeding operation.
‒ Close bleeder valve and tighten to 4.5
Nm.
‒ Depress clutch pedal several times
after completion of bleeding process.
‒ Bleed again if necessary. Page 1 of 15-Speed Manual Gearbox 01A 4WD4.3.2014vw-wi://rl/A.en-GB.4B-S-S01AA.wi::21141313.xml?xsl=2