service AUDI A8 1996 D2 / 1.G AHA ATQ Engines Cylinder Block Crankshaft And Flywheel Component Service Manual
Page 7 of 33
13-8
Ribbed belt, removing and installing
Lock carrier in service position page 13
-1
CAUTION!
Before removing ribbed belt, note direction of
rotation with chalk or felt-tip marker.
Reversing the direction of rotation of a used
belt can destroy the belt. When installing the
ribbed belt, make sure it is seated correctly
on the pulley.
Removing
- Remove engine cover (arrows).
- Remove noise insulation panel (arrows).
Pa
ge 7 of 33 C
ylinder block, crankshaft and fl
ywheel, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.2
Page 10 of 33
13-11
Vibration damper, removing and
installing
Lock carrier in service position page 13
-1
Ribbed belt, removing and installing page 13
-
8 .
Note:
To remove the vibration damper, it is not
necessary to remove the center bolt.
- Remove vibration damper.
- When installing, make sure notches (arrows) in vibration damper are
aligned with locating lugs on toothed belt sprocket.
Tightening torque (vibration damper to crankshaft): 20 Nm (15 ft lb)
Pa
ge 10 of 33 C
ylinder block, crankshaft and fl
ywheel, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.2
Page 11 of 33
13-12
Toothed belt, removing and installing
Removing
- Remove engine cover.
Ribbed belt, removing and installing page 13
-8 . - Remove noise insulation panel (arrows).
Lock carrier in service position page 13
-1
- Unclip toothed belt guard on both sides and remove.
Pa
ge 11 of 33 C
ylinder block, crankshaft and fl
ywheel, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.2
Page 17 of 33
13-18
Crankshaft seal, replacing
Toothed belt side
Lock carrier in service position page 13
-1
Ribbed belt, removing and installing page 13
-
8 .
Toothed belt, removing and installing page 13
-
12
.
- Remove sealing plug from left-side of cylinder
block.
- Turn crankshaft to TDC for cylinder 3. The TDC
mark on crankshaft must be visible or felt behind
bore for sealing plug.
- Install 3242 crankshaft holder in bore to secure crankshaft.
Pa
ge 17 of 33 C
ylinder block, crankshaft and fl
ywheel, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.2