automatic transmission AUDI A8 1997 D2 / 1.G ATQ Engine Electronic Engine Power Control Checking Workshop Manual
Page 36 of 41
24-160
If no malfunctions are found in wires:
- Replace accelerator pedal position sensor.
Repair Manual, Fuel Supply System, Repair
Group 20
Note:
For vehicles with automatic transmission, the
kick down function must be learned Page 24
-
161
.
Pa
ge 36 of 41 Electronic en
gine
power control
(E-Gas
), checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.5
Page 37 of 41
24-161
Kick down function, adapting
If the sensor for accelerator pedal position or the
Engine Control Module (ECM) is replaced on a
vehicle with automatic/variable transmission, the
kick down function must be learned by the ECM.
Special Tools and Equipment
Requirements
Procedure
VAS5051 with VAG5051/1
orVAG1551 with VAG1551/3BNo DTCs in DTC memory, check DTC memory Page 01
-15
.
Engine not running, ignition switched on.
- Connect VAS5051 tester or VAG1551 scan tool and select the control
module for engine electronics using "address word" 01 Page 01
-9 .
Ignition must remain switched on for this.
Pa
ge 37 of 41 Electronic en
gine
power control
(E-Gas
), checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.5