warning AUDI A8 1998 D2 / 1.G 01V Transmission Drive Pinion And Ring Gear Adjust Workshop Manual

39-178


- Pulling small tapered roller bearing outer race into housing.
- The outer race must be oiled and installed using VW408A punch and
30-205 thrust pad.

WARNING!
Wear protective gloves!
Notes: - Install drive pinion without spacer sleeve.
-
Heat up small tapered roller bearing inner race to approx. 100 C and
position on drive pinion.
Do not grease new tapered roller bearings additionally for friction
torque measurement. The bearings are already greased with a special
oil from the factory. Only install spacer sleeve if friction torque has been adjusted (Shim
S3 already determined).
Pa
ge 15 of 38 Drive
pinion and rin
g gear, ad
justin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.15