ignition AUDI A8 1998 D2 / 1.G AHA Engine Intake Manifold Tuning System Workshop Manual
Page 3 of 11
24-155
Intake Manifold Tuning (IMT) function,
checking
Note:
The following test should only be conducted if
performance deficiencies occur.
- Increase engine rpm clearly above 4500 RPM.
Intake manifold tuning vacuum solenoid must be
actuated (solenoid is located on intake manifold,
left-front, under the ignition coils).
If the vacuum solenoid is not actuated:
- Check intake manifold tuning valve -N156-
(change-over valve) page 24
-156
.
- Check vacuum system for leaks page 24
-
162
.
- Check that vacuum lines are correctly installed,
do not leak and are not blocked.
- Check change-over mechanism for ease of
movement (activate change-over linkage by
hand).
Pa
ge 3 of 11 Intake Manifold Tunin
g (IMT
) syste
m
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.3
Page 10 of 11
24-162
Vacuum system, checking for leaks
- Let engine run 2 to 3 minutes at idle (for vacuum
to build up).
- Switch ignition off.
- Remove 2-pin connector from intake manifold
tuning valve -N156- (change-over valve).
- Connect jumper wire (from VAG1594) from one terminal of -N156- to
engine ground.
- Use VAG1248/3A remote, adapter wire VAG1348/3-2 and auxiliary
wire to connect second terminal of -N156- to B+.
- Activate intake manifold tuning valve -N156-, using remote control
VAG1348/3A, for approx. 2 to 3 min.
The vacuum solenoid must remain actuated during this time.
Pa
ge 10 of 11 Intake Manifold Tunin
g (IMT
) syste
m
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.24.3