lock AUDI A8 1998 D2 / 1.G ATQ Engine Check DTC Memory And Erase DTC Memory Workshop Manual

01-40

DTC
DTC text
Corrective action
SAE
VAG


P1250 17658
Fuel level too low
4)
Repair Manual, Electrical Equipment, Repair Group 01, On Board Diagnostic
(OBD) of instrument cluster; Read Measuring Value Block
- Fill fuel tank with fuel
- Check wire connection between Engine Control Module (ECM) and instrument
cluster according to wiring diagram
- Check signal from sender for fuel gauge and fuel gauge
P1296 17704 Malfunction in cooling
system
1)
Repair Manual, Engine Mechanical, Repair Group 19; Cooling system
components, removing and installing - Check coolant temperature sensor Page 28
-23
- Check coolant regulator
1) For these malfunctions, ECM does not switch on the Malfunction Indicator Lamp (MIL) unless malfunction is recognized
again after another engine start. Meaning of Malfunction Indicator Lamp (MIL) Page 01
-3 .
4) The DTC "Fuel Level Too Low" is stored when there is/was too little fuel in fuel tank. The DTC is stored as a static
malfunction and is not switched to sporadic even if fuel tank has been filled with fuel (e.g. by the customer) in the meantime.
In this way, it can be determined that subsequent malfunctions were caused by lack of fuel, e.g. combustion misfires or
oxygen control related malfunctions.
Pa
ge 31 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2

01-51

DTC
DTC text
Corrective action
SAE
VAG


P1569 17977 Cruise control switch -E45-

Implausible signal Repair Manual, Electrical Equipment, Repair Group 01; On Board
Diagnostic (OBD) for cruise control system

P1570 17978 Engine Control Module
(ECM)
locked
Repair Manual, Electrical Equipment, Repair Group 01, On Board
Diagnostic (OBD) for immobilizer
- Adapt electronic immobilizer to Engine Control Module (ECM)
P1579 17987 Throttle valve control
module -J338-
Adaptation not started - Perform adaptation of throttle valve control module while maintaining test
requirements Page 24
-142

P1602 18010 Voltage supply, terminal 30

Voltage too low - Check voltage supply for control module Page 28
-30
Pa
ge 47 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2