tow AUDI A8 1999 D2 / 1.G AHA ATQ Engines Lubrication System Components Workshop Manual
Page 22 of 34
17-18
- Starting in center and moving toward outside,
tighten bolts to 10 Nm (7 ft lb).
- Install new seal on oil drain plug and tighten to
30 Nm (22 ft lb).
Notes:
When installing oil pan on removed engine,
make sure oil pan is aligned with cylinder block
on flywheel side.
After installing oil pan, allow sealant to dry for
approx. 30 minutes. Only after allowing sealant
to dry may engine oil be added.
- Install subframe.
Repair Manual, Suspension, Wheels,
Steering, Repair Group 40
- Install lock carrier.
Pa
ge 22 of 34 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.1
Page 26 of 34
17-22
Installing
Installation is the reverse of removal, noting the following:
Note:
Do not use glue or sealant. - Remove oil pump together with shorter oil supply line.
- Before installing oil pump, install short oil supply line together with O-
rings into pump and into oil pan (upper part).
- Clean both sealing surfaces on oil pan (lower part) so they are free of
oil and grease.
- Install new gasket on oil pan (lower part) and attach to oil pan (upper
part) with two bolts diagonal to each other.
- Tighten all bolts hand tight.
- Starting in the center and moving toward the outside, tighten bolts to 10
Nm (7 ft lb).
- Install new seal on oil drain plug and tighten to 30 Nm (22 ft lb).
Pa
ge 26 of 34 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.1
Page 34 of 34
17-29
Oil pump chain sprocket on crankshaft,
removing and installing
Removing
Front sealing flange and oil pump chain,
removing and installing page 17
-26
.
Installing
WARNING!
Wear protective gloves.
Note:
Installation position: wider collar of chain sprocket points toward engine. - Using puller -2-, remove crankshaft chain sprocket, while protecting
crankshaft end with appropriate washer -1-.
-
Warm chain sprocket in 220 C (428 F) oven for approx. 15 minutes.
- Using pliers, install chain sprocket on crankshaft end and slide onto
crankshaft to stop using 30-100 press tube. If necessary, carefully tap
with plastic hammer.
Pa
ge 34 of 34 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.1