air filter AUDI A8 2000 D2 / 1.G AHA ATQ Engines Lubrication System Components Workshop Manual
Page 8 of 34
17-5
Oil pump, oil pan, oil filter, oil cooler,
removing and installing
1 -
Bolt for dipstick tube
25 Nm (18 ft lb)
2 -
Dipstick tube Replace O-ring
3 -
Oil pan (upper part) No gasket is installed between engine
block and oil pan (upper part) Only use silicon sealant D 454 300 A2
4 -
Bolt M820 Nm (15 ft lb)
5 -
Bolt M615 Nm (11 ft lb)
6 -
Bolt M820 Nm (15 ft lb)Bolt is next to coolant drain plug
Pa
ge 8 of 34 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.1
Page 10 of 34
From pump to oil filter
17 -
Oil supply line From oil filter to engine oil circulation
Pa
ge 10 of 34 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.1
Page 11 of 34
17-7
18 -
O-ring
Always replace
19 -
O-ring Always replace
20 -
Oil filter
21 -
Hex nut 30 Nm (22 ft lb)Threaded pipe for oil cooler and oil filter
installed in oil pan (upper part) and
tightened to 20 Nm (15 ft lb)
22 -
Oil cooler When installing, make sure O-ring is
seated correctly
23 -
Oil pump Disassembling and assembling Fig. 1Driven by chain from crankshaftTightening torque (chain sprocket to oil
pump): 25 Nm (18 ft lb) Tightening torque (oil pump to engine
block): 25 Nm (18 ft lb)
Pa
ge 11 of 34 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.1
Page 16 of 34
17-12
- Set 10-222A engine support bridge together with 10-222A/3 engine
support adapter on fender mounting edges.
- Attach 2024A engine sling to mounting eyes at front and rear of engine.
- Using 10-222A engine support bridge spindle, lift up engine as far as
possible.
- Cut tie wraps (arrows), open bracket for starter wiring and remove
wiring.
- Remove torque support at front of engine.
- Unbolt coolant line at front of engine from oil pan.
- Disconnect harness connector from oil pressure switch on left-side of
oil pan.
- Disconnect coolant lines from oil cooler underneath oil filter.
Pa
ge 16 of 34 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.1