jump start terminals AUDI A8 2012 Owners Manual

18 Instruments and warning/indicator lights
If the indicator light turns on and the mes­
sage appears, there is a ma lfunction in the en ­
g ine start system.
Drive to your authorized Aud i dealer immedi­
ate ly to have the malfunction cor rected .
0 Air suspension
• Air suspension: system fault. Can contin­
ue slowly with max. 35 mph .
There is a malfunction that can result in re­
stricted driving stability .
Ca refully drive at a maximum speed of 35
mph
(60 km/h) to your authorized Audi dealer
or qualified workshop to have the malfunction
corrected .
• Air suspension: service mode. Vehicle
can only be moved with restrictions
Carefully drive to your authorized Audi dealer
or qualified workshop immediately to have
the service mode deactivated.
Ill Air suspension fault
There is a system ma lfunction that can result
in restr icted driving stability or reduced
ground clearance.
Drive to your authorized Audi dea ler immedi­
ate ly to have the malfunction corrected.
IIJ Air suspension: vehicle too low. Ground
clearance reduced
The ground clea rance is ve ry low due to a sys­
tem malfunct ion. Wait until the air suspen­
sion system has restored normal ground clear­
ance . Otherwise, conditions such as an uneven
road surface can lead to ve hicle damage.
~/ !f Safety systems
The fl (USA models) ;BI (Canada models) in­
d icator light monitors the safety systems e.g.
a ir bags, pretensioners and illum inates for a
few seconds each time you switch the ignition
on .
If the
I (USA models) ;BI (Canada models)
indicator light does not go out, or if it illumi- nates while you are driving, or if it starts to
blink,
then there is a malfunction somewhere
in the system.
If the light does not illuminate
when you switch the ign it ion on, th is also
means there is a malfunct ion.
A WARNING '"--
If you have a ma lfunction in the safety sys-
tems, contact your authorized Audi dea ler
imme diately. Otherwise the safety sys­
tems may not work properly in an acci­
dent.
fJJ [}, Electronic Stability Control (ESC)
This warning/indicator light monitors the
Electronic Stability Control.
When you switch the ignition on, the indicator
light
G1 turns on briefly to check the function.
If the
J.iJ ind icator lamp blinks wh ile driving,
the ESC or ASR (Anti-Slip Regulation) is active­
ly regulating.
If
the DJ ind icator lamp illuminates, the sys·
tern has switched the ESC off.
If the indicator light fi turns on, the ESC was
switched to ESC sport mode with the button
[!] c::, page 187. If this is case, you can reacti­
vate the ESC by switching the ignition off and
then on aga in. The warning/indicator light
should go out to show that the system is fully
functional again .
Stability program and ABS fault! See own­
er 's manual
If the indicator light DJ and the ABS indicator
li ght
m (USA models) ;II] (Canada models)
turn on and the message appears, there is a malfunction in the ABS system or electronic
differential lock. Th is also interrupts the ESC.
The brakes still funct ion wit h their normal
power, but ABS is not active .
Drive to your authorized Audi dealer immedi­
ately to have the malfunction corrected .
If the battery terminals were disconnected
and re-connected, the vehicle was jump start-
ed or the battery is very weak, the ESC sensor .,,.

2 70 Emergency situations
Emergency situations
General
This chapter is intended for trained emer­
gency crews and working personnel who
have the necessary tools and equipment to
perform these ope rations.
Starting by pushing or
towing
Q;) Note
Vehicles w ith an automatic transmission
cannot be started by pus hing o r tow ing.
Starting with jumper
cables
If necessary, the engine can be started by
connecting it to the battery of another vehi­
cle.
If the engine should fail to start because of a
discharged or weak battery, the battery can be
connected to the battery of
another vehicle,
using a
pair of jumpe r cables to start the en­
g ine .
Jumper cables
Use only jumper cables of sufficiently large
cross section to carry the starter current safe­
ly. Refer to the manufacturer's specif ications.
Use only jumper cables with
insulated termi­
na l clamps which are distinctly marked:
plus(+) cable in most cases colored red
minu s(-) cable
in most cases colored black .
A WARNING
Batteries contain electricity, acid, and gas.
Any of these can cause very serious or fatal
inju ry. Follow the instructions below for
safe handling of your veh icle's battery.
- Always shield you r eyes and avoid lean­
ing over the battery whenever possible.
- A discharged battery can freeze at tem­
peratures just be low 32 °F (0 °C). Before connecting a
jumper cable, you must
thaw the frozen battery complete ly, oth­
erwise it could explode.
- Do not allow battery acid to contact eyes
or skin . Flush any contacted area with
water immediately .
- Improper use of a booster battery to start a vehicle may cause an explosion.
- Vehicle batteries generate explosive gas­
es. Keep sparks, flame and lighted ciga­
rettes away from batteries.
- Do not try to jump start any vehicle with a low acid level in the battery.
- The vo ltage of the booster battery must
also have a 12-Volt rating. The capacity
(Ah) of the booster battery should not be
lower than that of the discharged bat­
tery . Use of batteries of d ifferent voltage
or substantially different "Ah" rating
may cause an exp losion and personal in­
jury.
- Never charge a frozen batte ry. Gas trap­
ped in the ice may cause an explosion.
- Never charge or use a battery that has
been frozen. The battery case may have
be weakened.
- Use of batter ies of different voltage or
substantially different capacity (Ah) rat­
ing may cause an exp losion and injury.
The capacity (Ah) of the booster battery
should not be lower than that of the dis ­
charged battery.
- Before you check anything in the engine
compartment, always read and heed a ll
WARNINGS¢
page 213, Engine com­
partment.
«I) Note
-Applying a higher voltage booster bat­
tery will cause expensive damage to sen­
sitive electronic components, such as
contro l units, relays, rad io, etc .
- There must be no electrical contact be­
tween the vehicles as otherwise current
could already start to flow as soon as the
positive(+) terminals are connected. ..,_