oil additives AUDI Q3 2017 Owner´s Manual

Page 167 of 236

00
00
......
"' ,....
"' ...... 0 0 :::,
00
increases the risk of catalytic converter and/
or engine damage. Do not start the engine. Contact an authorized Audi dealer or au­
thorized Audi Service Facility to have excess
engine oil extracted if necessary.
- Do not mix any additional lubricants into
the engine o il. Damage caused by such addi­
tives is not covered by the warranty.
@ For the sake of the environment
-Engine o il should never enter the sewer sys­
tem or come into contact with the ground under any circumstances.
- Pay attention to legal requirements when
dispos ing of empty oil containers.
@ Tips
The engine oil consumption may be up to
0.5 quart/600 m iles (0.5 liter/1,000 km), de­
pending on driving style and operating condi­
tions. Consumption may be higher during the
fi rst 3,000 miles (5,000 km). The engine o il
level must be checked regularly.
It would be
best to che ck each t ime you refue l yo ur vehi­
cle and before long dr ives.
Changing the engine oil
We recommend that have your oil changed by an
authorized Audi dealer or a qualified service sta­ tion.
B efore you check a nyth ing in the eng ine compart­
ment,
alw ay s read and heed all WARNINGS ~ .&.
in Working in the engine compartment on
page 159.
The engine oil must be changed according to the
inte rvals spec ified in you r Warranty
& Mainte­
nance booklet. This is very important because the
l ubri cat ing propert ies of o il diminish gradually
d uring normal vehicle use.
Unde r some ci rcumstances the eng ine o il should
be changed more frequently. Change oil mo re of ­
ten if yo u drive mos tly short distances, ope rate
the vehicle in dusty areas or under predominant ly
stop -and -go traffic condit ions, or have your vehi­
cle where temperat ures remain below freezing
for extended periods.
Ch eck ing and Filling
Detergent add itives in the oi l will make fresh oil
l ook dark after the engine has been running for a
short time . This is normal and is not a reason to
change the oi l more often than recommended.
Beca use of the problem o f proper disposal, along
with the specia l too ls and necessary expertise re­
quired, we strongly recommend that yo u have
your o il changed by an authorized
Audi dealer or
a qual ified service stat ion.
If you choo se to change you r oil yourself , please
note the following important info rmation:
A WARNING "--
To reduce the risk of persona l injury if you
must change the eng ine oil in your vehicle
yourself:
- Wear eye protect ion.
-
- To reduce the r is k of burns from hot engine
oil, let the engine coo l down to the touch.
- When remov ing the oil drain plug w ith your
f ingers, stay as far away as possib le. Always
keep your forearm parallel to the gro und to
he lp prevent hot oil from running down your
arm.
- Drain the oil into a container designed for
this purpose, one large enough to hold at least the tota l amou nt of oil in you r engine.
- Engine oil is poisonous. Keep it well out of
the reach of childre n.
- Continuous contact with used engine o il is
harmf ul to your skin. Always protect your
skin by wash ing oil off thoroughly with soap
and wate r.
«I) Note
Neve r mix oil additives with your engine oil.
These additives can damage your engine and
adverse ly affect yo ur Audi limited New Vehi­
cle War ranty.
@ For the sake of the environment
- Before chang ing yo ur oi l, first make sure
you know where you can properly d ispose of
the used oil.
- Always dispose of used engine o il properly .
Do not dump it on ga rden soil, wooded
165

Page 168 of 236

Check ing and F illing
areas, into open streams or down sewage
drains .
- Recycle used engine oil by taking it to a used
engine oil collection facility in your area, or
contact a service station .
Cooling system
Coolant
The engine coo ling system is filled wi th a mixture
of pur ified w ate r a nd coolan t addit ive at the fa c­
tory . T h is coo lant must not be not changed.
The coolant leve l is monito red throug h the . in­
d icator light~
page 13 . Howeve r, we do re com­
mend occasionally check ing the coo la nt level
manually.
I f you must add coolant, use a m ixt ur e of wa ter
and coolant addit ive. M ixing the coolant additive
with d istilled wate r is recommen ded .
Coolant additive
The coolant additive is made of a nti-freezi ng a nd
corros ion protection agents . Only use the fo llow­
i n g coolant add it ives. These additives may be
mixed w it h each other.
Coolant additive Specification
G13 TL774J
G12++ T
L 774 G
The amount of coo lant additive that needs to be
mixed wit h wate r depends on the climate where
the vehicle will be operated . If the coolant addi ­
tive percentage is too low, the coolant can freeze
and damage the engine.
Coolant Freeze protec-
additive tion
Warm reg ions min . 40% m in . -13 °F
max . 45% (
- 25
°()
Co ld regions min. 50% max
. -40 °F
max. 55% (-40 °()
0 Note
- Befo re the start of winter, have your author­
i zed Audi dealer or authorized A udi Service
Fac ility check if the coolant additive in you r
166
vehicle matches t he percentage app ropriate
for the climate . This is especially important
when driving in colder climates.
- If the app ropriate coo lant additive is not
available in an eme rgency, do not add any
other additive. You could damage the en­
gine. If this happens, only use water and re­
store the correct m ixture ratio with t he
specified coo lant add itive as soo n as poss i­
bl e.
- Only ref ill w ith new coolant.
- Radiator sealant must not be mixed with
the coolant.
· Adding coolant
Fi g. 14 3 En gin e compartment: coo lant expa nsio n ta nk
cove r
Observe the safety precautions ~.& in Working
in the engine compartment on page 159 .
Checking the engine coolant level
.. Park the vehicle on a level surface .
.. Switch the ignit io n off.
.. Read the coolant level on the coolant expansion
t ank ~
page 162, fig. 140. The coolant leve l
m ust be be twee n the m arkings when the en­
gi ne i n co ld. W hen t he engine is warm it can be
slightly above the upper mar king.
Adding coolant Requirement: there must be a residua l amount of
coolan t in the expansion tank ~(}).
.,. Let the engi ne cool down .
.. Place a clot h over the coolant expans ion tank
cap and unscrew the cap counte rclockw ise
~ .& -