AUDI Q5 2010 8R / 1.G Navigation System Instalation Manual

Page 1 of 5

Downloaded from www.Manualslib.com manuals search engine
AUDI A4  A5 Q5  User’s  manual  
1. It is  suitable  for  all  AUDI  NON  MMI system  A4/Q5/A5  from  2005  up  version.  
2. Built ‐in  CANBUS  with  car original  button  switch  
3. Built ‐in  FM  transmittion.  When  setting  Radio channel  into  FM87.9,  exteral  audio  will  be  sound  from  car  
original  speaker.  
4. With  OEM  cable  harness,  100% plug  and  play,  which  can avoid  damaging  the original  system.  
5. With  two  AV,  RGBS  input,  as  well  as  two  AV,  LV D S  output  Synsh  
6. Built ‐in  GPS  function  (optional,  when  place).  
7. Auto  switch  rear  camera  when  gear  in  reverse  backwords.  
 
GPS Technical  Dat: 
1. Main Control Processor: SiRF Atlas IV, and main frequency: 500MHZ
2. main storage: 64M ,128M (optional:DDR I)
3. Flash storage: 64M,128M,1G,2G (optional:Nand flash )
4. video output format: RGB,CVBS ,YC,digital: RGB565
5. Synch signal: composite sync signal, and sy nchronizing signal separation
6. video output system: NTSC,PAL
7. video output resolution: 320X240,400X234,480X234,800×480
8. GPS antenna power: 3-5V
9. Operation system: WINCE .NET 6.0 Core Version
10. Input voltage: 5V-24V
11. Touching panel connection: 4PIN S resistance touching function
12. Memory Card: SD/MMC/SDHC(SDHC)4GB~32GB

















Page 2 of 5

Downloaded from www.Manualslib.com manuals search engine
Installation video  interface: 
OEM  Cable  connection:  
 

Page 3 of 5

Downloaded from www.Manualslib.com manuals search engine
           
                                      The OEM cable harness: Green cable
Is for reverse light +12V

14PINS LVDS cable Instruction picture 14PINS LVDS cable to Video unit: LVDS out

NAVI Touch Panel connection & Operation:

Page 4 of 5

Downloaded from www.Manualslib.com manuals search engine



After you detached the front panel, you can also instal our filexible touch panel also in front the
Original monitor. And after finish the all installation, you can activate the GPS function first, when
Turn on power, can use igo8, Garmin NAVI MAP system.
DIP SET Instruction


Page 5 of 5

Downloaded from www.Manualslib.com manuals search engine

Three button of video Intehration is for adjusting Picture’s: Brightness, Saturate, Contrast.
Picture position: H, L
Switch operation:


The parts with the Video Integration:

RGB, AV, Speaker, FM connector GPS Antenna Oem cable harness for plug and pla
                             
Two LV D S  cables  and  flexible  film  touch  panel                             Unit and  parts  connection