oil AUDI S4 1996 B5 / 1.G 01E Transmission Bearing House And Torsen Differential User Guide
Page 34 of 38
34-85
- Install complete selector shaft.
- Screw locking bolts -A- for selector shaft into transmission housing.
- Aluminium and steel bolts must not be interchanged when installing.
Tightening torques: for aluminium locking bolts = 50 Nm, and for steel
locking bolts = 70 Nm.
- Lightly oil new O-ring for cover for selector shaft and fit.
- Fit cover for selector shaft.
- Apply sealing paste AMV 188 000 02 to bolts -B- (Qty. 3) before
installing and tighten.
- Slide Torsen differential onto splines of hollow shaft.
Parts catalog - Press Torsen differential in direction of arrow, and measure distance
between top edge of bolted end cover and front edge of outer race of
ball bearing for Torsen differential.
- Determine required shim(s) from following table.
Pa
ge 34 of 38 Bearin
g housin
g, Torsen differential, end cover, internal selector mechanism, in
put shaft, drive
pinion and hollow shaft, rem...
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.5
Page 37 of 38
34-87
- Insert spring plate -C- into bearing housing.
Installation position: larger diameter (concave side) towards the shims.
- Fit shims -B- as determined in table.
- Fit spring -A- to end of drive flange.
- Lightly oil new O-ring for bearing housing and fit.
- Oil small needle bearing in drive pinion.
- Insert complete bearing housing and pull home evenly.
- Tighten bearing housing using diagonal sequence.
- Fill new seal for drive axle between sealing lip and dust lip with sealing
grease G52 128 A1.
- Pull a thin protective hose tightly onto splines of input shaft.
- Drive on seal for input shaft.
Pressing-in depth (factory): 3.5 mm
Pressing in depth (repairs): 4.5 mm
Pa
ge 37 of 38 Bearin
g housin
g, Torsen differential, end cover, internal selector mechanism, in
put shaft, drive
pinion and hollow shaft, rem...
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.5
Page 38 of 38
34-88
- Remove protective hose.
- Install release bearing, clutch release lever and
guide sleeve from Page 30
-27
.
- Check that transmission can be shifted through
all gears.
- Fit connecting rod.
- Check oil level in transmission Page 34
-39
.
Pa
ge 38 of 38 Bearin
g housin
g, Torsen differential, end cover, internal selector mechanism, in
put shaft, drive
pinion and hollow shaft, rem...
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.5