light AUDI S4 1998 B5 / 1.G 01E Transmission Final Seal Grooved Ball Bearings For Flange Driveshaft Workshop Manual
Page 9 of 10
39-13
- Lightly oil outer circumference of seal -B-.
- Fill space between sealing lips and dust lips with sealing grease G52
128 A1.
- Fit seal with shim -A-, Part No. 016 311 391 B (1.7 mm thick) onto
punch 2005.
Installation position: open side of seal toward transmission.
- Drive in seal for drive flange.
- Remove shim after driving in.
Pa
ge 9 of 10 Seal and
grooved ball bearin
g for flan
ge for driveshaft on transmission, re
placin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.3
Page 10 of 10
39-14
- Press in drive flange.
- Fit circlip onto drive flange.
- Lightly oil O-ring and fit into bearing housing groove.
- Insert spring plate and shims into bearing housing.
Installation position: Page 39
-8
- Slide coil spring onto drive flange.
- Tighten securing bolts for bearing housing in diagonal sequence and in
stages to 25 Nm.
- Bolt on driveshaft Page 39
-71
.
- Top up oil in transmission and check oil level Page 34
-39
. Pa
ge 10 of 10 Seal and
grooved ball bearin
g for flan
ge for driveshaft on transmission, re
placin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.3