service AUDI TT 1998 8N / 1.G AEB ATW Engines Cylinder Head Remove And Install Workshop Manual

15-2


Cylinder head, removing and
installing

Note:

Replace cylinder head bolts.
Always replace self-locking nuts, bolts as well
as gaskets and O-rings.
After installing a replacement cylinder head with
camshafts attached, grease contact surfaces
between valve lifters and cam lubricating
surfaces.
Do not remove plastic covers protecting
exposed valves until immediately before
installing cylinder head.
When replacing the cylinder head or cylinder
head gasket, coolant must be completely
replaced.
Cylinder heads with small cracks between the
valve seats that are less than 0.3 mm (0.012
in.) wide and/or between one valve seat and
only the first 4 threads of the spark plug thread,
can continue to be used without reduced
service life.
Pa
ge 1 of 35 C
ylinder head, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.15.2

15-20

Cylinder head, removing


Engine installed
Lock carrier in service position Page 13
-1

Note:

Secure all hose connections with original
equipment clamps parts catalog.

All tie wraps opened or cut during removal must
be reinstalled at the same locations.

CAUTION!

BEFORE disconnecting the battery:
Stop the engine.
Be sure the ignition is switched OFF (also
applies when connecting the battery). Failure
to do so may damage the Engine Control
Module (ECM).
Determine the correct coding for the anti-
theft radio.
Pa
ge 20 of 35 C
ylinder head, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.15.2