lock AUDI TT 1998 8N / 1.G AEB ATW Engines Pistons And Connecting Rods Workshop Manual

13-54


5 -
Bearing shell
Verify correct installation positionDo not interchange used connecting rod
bearing shells (mark accordingly) Check for proper securing in retaining tabs
Axial play:New: 0.10-0.35 mm (0.004-0.014 in.)Wear limit: 0.40 mm (0.016 in.)

Measure radial play using Plastigage :New: 0.01-0.05 mm (0.0004-0.0020 in.)Wear limit: 0.12 mm (0.0047 in.)Do not turn crankshaft when measuring
radial play with Plastigage in place
- To measure radial play, tighten nut -1- to
30 Nm (22 ft lb) but not any further
6 -
Cylinder block
Check bore Fig. 4Piston and cylinder bore dimensions
Page 13
-60

Pa
ge 2 of 9 Pistons and connectin
g rods, disassemblin
g and assemblin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.13.4

13-59


Fig. 3 Checking piston diameter
- Measure approx. 10 mm (3/8 in.) from bottom edge, at points offset by
90 from piston pin axis. Deviation from nominal size: max. 0.04 mm (0.0016 in.)

Special tools and equipment
Inner bore gauge 50-100 mm (2-4 in.)
CAUTION!
DO NOT have the cylinder block mounted to the assembly stand
while measuring the cylinder bores. The block is deformed by its
own weight under these conditions and this stress will result in false
measurements that are not accurate after the tension has been
relieved. Fig. 4 Checking cylinder bore
- Measure at three locations diagonally in crosswise direction -A- and
lengthwise direction -B-.
Deviation from nominal size: max. 0.08 mm (0.0031 in.)
Pa
ge 8 of 9 Pistons and connectin
g rods, disassemblin
g and assemblin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.13.4