BMW 5 SERIES GRAN TURISMO 2017 Service Manual

Safety
informationWARNING
During no-touch activation, vehicle parts
may be touched, e.g., hot exhaust system.
There is a risk of injury. When moving your
foot, make sure you have a firm stance and do not touch the vehicle.'

whether the doors are also unlocked when unjlocking with the remote control. Changing setj
tings, refer to page 47
You can set whether the large tailgate or the small tailgate will be unlocked with the remote
control button.
Safety
information WARNING
Body parts can be jammed when operatj
ing the tailgate. There is a risk of injury. Make sure that the area of movement of the tailgateis clear during opening and closing.'

When adjusting the opening height, ensurethat there is a clearance of at least 4 in/10 cm
above the tailgate.1."Settings"2."Tailgate"3.Turn the controller until the desired openj
ing height is selected.4.Press the controller.
From
the
outside
'yWithout Comfort Access: unlock the vehij cle.
Press the button on tailgate's exterior, arj
row 1.'yPress button on the remote conj
trol for approx. 1 second.
As the case may be, the doors are also unj
locked. Opening with the remote control,
refer to page 36.
If the vehicle is stationary, the large tailgate
opens automatically to the adjusted opening height.
From
the
inside Push the button in the driver's floor
area.
If the vehicle is stationary, the tailgate opens
automatically to the adjusted opening height.
Maximum
opening
height
Press and hold this button on the inside of the
tailgate, arrow 2, to open the tailgate to the
maximum opening height.
Canceling
the
opening
operation The opening procedure is interrupted in thefollowing situations:
'yWhen the vehicle starts moving.'yBy pressing the button on the outside of
the tailgate.'yBy pressing the button on the inside of the tailgate.'yBy pressing the button on the remote conj
trol.'yBy pressing the button in the driver's foot
area.
Closing
General
information
An acoustic signal sounds when the tailgate is
closed.
From
the
outside
Press the button on tailgate's exterior.
Seite 43Opening
and
closingControls43
Online Edition for Part no. 01 40 2 972 554 - VI/16

From
inside
the
tailgate
Press button, arrow 1, on the inside of the tailjgate.
With Comfort Access:
Press button on the open tailgate.
The vehicle will be locked after closing the tailj gate. The driver's door must be closed for thispurpose and the remote control must be outj
side of the vehicle in the area of the tailgate.
Canceling
the
closing
operation
The closing procedure is interrupted in the folj
lowing situations:
'yIf the vehicle starts off with a jerky movej
ment.'yBy pressing the button on the outside of
the tailgate.'yBy pressing the button on the inside of the tailgate.Malfunction
Safety
information WARNING
With manual operation of a blocked tailj
gate, it can release itself unexpectedly from the blockage. There is a risk of injury or risk ofproperty damage. Do not operate the tailgatemanually if it is blocked. Have it checked by a
dealerss service center or another qualified service center or repair shop.'

Emergency
unlocking
Pull the handle inside the cargo area.
The tailgate is unlocked.
Automatic
Soft
Closing WARNING
Thanks to Soft Close the closing goes
into the lock automatically. Body parts can be
jammed. There is a risk of injury. Make sure
that the area of movement of the doors is clear
during opening and closing.'

'yActive Blind Spot Detection.'yNight vision.
Profile
management
Opening
profiles Regardless of the remote control in use, a difjferent profile may be activated. This allows youto call up personal vehicle settings if you did
not unlock the vehicle with your own key.
Via iDrive:
1."Settings"2."Profiles"3.Select a profile.'yAll settings stored in the called-up profileare automatically applied.'yThe called-up profile is assigned to the rejmote control being used at the time.'yIf the profile is already assigned to a differjent remote control, this profile will apply toboth remote controls.
Using
the
guest
profile
The guest profile is for individual settings that are saved in none of the three personal proj
files.
This can be useful for drivers who are using
the vehicle temporarily and do not have their
own profile.
On the Control Display:
1."Settings"2."Profiles"3."Guest"
The guest profile cannot be renamed. It is not assigned to the current remote control.
Renaming
profiles A personal name can be assigned to every projfile to avoid confusion between the profiles.
On the Control Display:1."Settings"2."Profiles"3.Open "Options".4."Rename current profile"
Reset
profiles
The settings of the active profile are reset to
their factory settings.
On the Control Display:
1."Settings"2."Profiles"3.Open "Options".4."Reset current profile"
Exporting
profiles Most settings of the active profile can be exjported.
This can be helpful for saving and retrieving
personal settings, e.g., before delivering the
vehicle to a workshop. Profiles can be taken to another vehicle equipped with the Personal
Profile function.
On the Control Display:
1."Settings"2."Profiles"3."Export profile"4.BMW Online: "BMW Online"
USB interface: "USB device"
Importing
profiles
Profiles exported via BMW Online can also be imported via BMW Online.
Profiles stored on a USB storage device can be
imported via the USB interface.
Existing settings are overwritten with the imj
ported profile.
Seite 46ControlsOpening
and
closing46
Online Edition for Part no. 01 40 2 972 554 - VI/16

On the Control Display:1."Settings"2."Profiles"3."Import profile"4.BMW Online: "BMW Online"
USB interface: "USB device"
Display
profile
list
during
start
The profile list can be displayed during each
start to select the desired profile.
On the Control Display:
1."Settings"2."Profiles"3.Open "Options".4."Display user list at startup"
Settings
General
information
Depending on the equipment and country-
specific variant of your vehicle, different openj ing and closing settings are available.
These settings are saved in the active driver profile, refer to page 45.
Unlocking
Doors
1."Settings"2."Doors/key"3. Select the symbol.4.Select the desired function:'y"Driver's door only"
Only the driver's door and the fuel filler
flap are unlocked. Pressing again unj locks the entire vehicle.'y"All doors"
The entire vehicle is unlocked.Large/small
tailgate1."Settings"2."Doors/key"3. Select the symbol.4.Select the desired function:'y"Tailgate"
The large tailgate is opened.'y"Tailgate + door(s)"
The large tailgate is opened and the doors unlocked.'y"Small tailgate"
The small tailgate is unlocked.'y"Small tailgate section + door(s)"
The small tailgate and the doors are
unlocked.
Confirmation
signals
from
the
vehicle
1."Settings"2."Doors/key"3.Deactivate or activate the desired confirj mation signals.'yWith alarm system:
"Acoustic sig. lock/unlock"
Unlocking is signaled by one honk of the horn.'y"Flash when lock/unlock"
Unlocking is signaled by two flashes,
locking by one.
Automatic
locking
1."Settings"2."Doors/key"3.Select the desired function:'y"Lock if no door is opened"
The vehicle locks automatically after a
short period of time if no door is
opened after unlocking.'y"Lock after start driving"Seite 47Opening
and
closingControls47
Online Edition for Part no. 01 40 2 972 554 - VI/16

The vehicle locks automatically afteryou drive off.
Headlamp
courtesy
delay
feature
1."Settings"2."Doors/key"3. Select the symbol.4."Pathway lighting"
Adjusting
the
last
seat,
mirror,
and
steering
wheel
position
1."Settings"2."Doors/key"3."Last seat position autom."
Unlocking the vehicle adjusts the last adjusted
positions for driver's seat, exterior mirrors, and steering wheel.
Alarm
system General
information When the vehicle is locked, the vehicle alarmsystem reacts to the following changes:
'yUnauthorized opening of a door, the hood
or the tailgate.'yMovements in the interior.'yChanges in the vehicle tilt, e. g., during atj tempts at stealing a wheel or when towing
the vehicle.'yDisconnected battery voltage.
The alarm system signals these changes visuj
ally and acoustically:
'yAcoustic alarm.'yBy switching on the hazard warning sysj tem.'yBy flashing the daytime running lights.
Switching
on
and
off
When you lock and unlock the vehicle with the
remote control or with Comfort Access, the
alarm system is switched on and off at the same time.
Door
lock
with
the
alarm
system
switched
on
The alarm system is triggered when the door is
opened, if the vehicle has been unlocked via
the door lock.
Switching off the alarm, refer to page 49.
Tailgate
with
the
alarm
system
switched
on
The tailgate can be opened even when thealarm system is switched on.
After the tailgate is closed, it is locked and monitored again provided the doors arelocked. The hazard warning system flashes
once.
Panic
mode
You can trigger the alarm system if you find yourself in a dangerous situation.
Press button on the remote control for
at least 3 seconds.
To switch off the alarm: press any button.
Indicator
lamp
on
the
interior
mirror'yThe indicator lamp flashes briefly every
2 seconds:
The alarm system is switched on.'yIndicator lamp flashes for approx. 10 secj onds, then it flashes briefly every 2 secj
onds:Seite 48ControlsOpening
and
closing48
Online Edition for Part no. 01 40 2 972 554 - VI/16

Interior motion sensor and tilt alarm sensor
are not active, as doors, hood, or tailgate are not correctly closed. Correctly closedaccess points are secured.
When the still open access points are
closed, interior motion sensor and tilt alarm
sensor will be switched on.'yThe indicator lamp goes out after unlockj
ing:
The vehicle has not been tampered with.'yThe indicator lamp flashes after unlocking
until the engine ignition is switched on, but no longer than approx. 5 minutes:
An alarm has been triggered.
Tilt
alarm
sensor The tilt of the vehicle is monitored.
The alarm system responds in situations such
as attempts to steal a wheel or when the vehij
cle is towed.
Interior
motion
sensor
The windows and the glass sunroof must be
closed for the system to function properly.
Avoiding
unintentional
alarms
General
information
The tilt alarm sensor and interior motion senj
sor can trigger an alarm, although no unauthorj ized action occurred.
Possible situations for an unwanted alarm:
'yIn automatic vehicle washes.'yIn duplex garages.'yDuring transport on trains carrying vehij
cles, at sea or on a trailer.'yWith animals in the vehicle.
The tilt alarm sensor and the interior motion sensor can be switched off in such situations.
Switching
off
the
tilt
alarm
sensor
and
interior
motion
sensor
Press the remote control button again
within 10 seconds as soon as the vehicle
is locked.
The indicator lamp lights up for approx. 2 secj
onds and then continues to flash.
The tilt alarm sensor and interior motion senj
sor are turned off until the vehicle is locked
again.
Switching
off
the
alarm'yUnlock the vehicle with the remote control or switch on the ignition, if needed through
emergency detection of remote control, rej fer to page 37.'yWith Comfort Access:
If you are carrying the remote control on
your person, grasp the door handle on the driver's or front passenger door comj
pletely.
Power
windows
Safety
information WARNING
When operating the windows, body parts
and objects can be jammed. There is a risk of injury or risk of property damage. Make surethat the area of movement of the windows isclear during opening and closing.'

'yEngaging selector lever position N.'yUsing vehicle equipment.
There is a risk of accidents or injuries. Do notleave children or animals unattended in the vej
hicle. Take the remote control with you when exiting and lock the vehicle.'