BMW 6 SERIES COUPE 2017 Repair Manual

Transporting
children
safelyVehicle
features
and
optionsThis chapter describes all standard, country-specific and optional features offered with theseries. It also describes features that are notnecessarily available in your vehicle, e. g., dueto the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and systems, the applicable laws and regulations
must be observed.
The
right
place
for
children
Safety
information
WARNING
Unattended children or animals can
cause the vehicle to move and endanger themj selves and traffic, e.g., due to the following acj
tions:'yPressing the Start/Stop button.'yReleasing the parking brake.'yOpening and closing the doors or winj
dows.'yEngaging selector lever position N.'yUsing vehicle equipment.
There is a risk of accidents or injuries. Do not leave children or animals unattended in the vej
hicle. Take the remote control with you when exiting and lock the vehicle.'

Safety
informationWARNING
Active front-seat passenger airbags can
injure a child in a child restraint system when
the airbags are activated. There is a risk of inj
jury. Make sure that the front-seat passenger
airbags are deactivated and that the PASSENj GER AIRBAG OFF indicator lamp lights up.'

Child
seat
security
The rear safety belts and the front passengersafety belt can be permanently locked to fasjten child restraint systems.
Locking
the
safety
belt1.Pull out the belt strap completely.2.Secure the child restraint system with the
safety belt.3.Allow the belt strap to be pulled in and pull it tight against the child restraint system.
The safety belt is locked.
Unlocking
the
safety
belt
1.Unbuckle the belt buckle.2.Remove the child restraint system.3.Allow the belt strap to be pulled in comj
pletely.
LATCH
child
restraint
fixing
system
General
information
LATCH: Lower Anchors and Tether for Chilj
dren.
Pay attention to the operating and safety inforj mation of the child restraint system manufacjturer when installing and using LATCH child
restraint fixing systems.
Mounts
for
the
lower
LATCH
anchors The lower anchors may be used to attach the
CRS to the vehicle seat up to a combined child and CRS weight of 65 lb/30 kg when the child
is restrained by the internal harnesses.
Safety
information WARNING
If the LATCH child restraint fixing sysj
tems are not correctly engaged, the protective
effect of the LATCH child restraint fixing sysj
tem can be limited. There is a risk of injuries or
danger to life. Make sure that the lower anj
chors are securely engaged and that the
LATCH child restraint fixing system fits sej curely against the backrest.'

Child
restraint
system
with
a
tether
strap
Mounting
points The respective symbol shows the anjchor for the upper retaining strap.
Seats with an upper top tether are
marked with this symbol. It can be found on
the rear seat backrest or the rear window shelf.
Safety
information NOTE
The mounting points for the upper rej
taining straps of child restraint systems are only provided for these retaining straps. Whenother objects are mounted, the anchors can bedamaged. There is a risk of property damage.
Only mount child restraint systems to the upj per retaining straps.'

DrivingVehicle
features
and
options
This chapter describes all standard, country- specific and optional features offered with theseries. It also describes features that are notnecessarily available in your vehicle, e. g., due
to the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and systems, the applicable laws and regulations
must be observed.
Start/Stop
buttonConcept Pressing the Start/Stop button
switches the ignition on or off
and starts the engine.
Steptronic transmission: the enj gine starts with the brake pedal
pressed when you press the Start/Stop button.
Ignition
on Steptronic transmission: press the Start/Stopbutton, and do not press on the brake pedal atthe same time.
All vehicle systems are ready for operation.
Most of the indicator and warning lights in the
instrument cluster light up for a varied length
of time.
To save battery power when the engine is off,
switch off the ignition and any unnecessary
electronic systems/power consumers.
Ignition
offSteptronic transmission: press the Start/Stopbutton again without stepping on the brake.
All indicator lights in the instrument cluster go
out.To save battery power when the engine is off,
switch off the ignition and any unnecessary
electronic systems/power consumers.
Safety
measures
When switching off the ignition, the selector
lever position P is selected automatically if the
selector lever position D or R is selected.
The ignition is switched off automatically in the
following situations while the vehicle is stationj
ary and the engine is off:'yWhen locking the vehicle, and when the
low beams are activated.'yShortly before the battery is discharged completely, so that the engine can still be
started.'yWhen opening or closing the driver door, if
the driver's safety belt is unbuckled and
the low beams are switched off.'yWhile the driver's safety belt is unbuckled with driver's door open and low beams off.
The low beams switch to parking lights after
approx. 15 minutes of no use.
Radio
ready
state
General
information
In the radio-ready state, certain power conj
sumers remain ready for operation.
ActivatingWith the engine running, press the Start/Stopbutton.
If the engine is not running and the ignition is switched on, the system automatically actijvates the radio-ready state when the door isopened if the lights are switched off or the dayjtime running lights are activated.
Seite 65DrivingControls65
Online Edition for Part no. 0140 2 915 411 - X/16

The radio-ready state remains active if, for inj
stance the ignition is automatically switched
off for the following reasons:'yOpening or closing the driver's door.'yUnfastening of the driver's safety belt.'yWhen automatically switching from low
beams to parking lights.
Switching
off
automatically
The radio-ready state is switched off automatijcally in the following situations:
'yAfter approx. 8 minutes.'yWhen the vehicle is locked using the cenj
tral locking system.'yShortly before the battery is discharged completely, so that the engine can still be
started.
Starting
the
engine
Safety
information DANGER
If the exhaust pipe is blocked or ventilaj
tion is insufficient, harmful exhaust gases can enter into the vehicle. The exhaust gases conjtain carbon monoxide, an odorless and colorjless but highly toxic gas. In enclosed areas, exj
haust gases can also accumulate outside of
the vehicle. There is danger to life. Keep the
exhaust pipe free and ensure sufficient ventilaj tion.'

WARNING
An unsecured vehicle can begin to move
and possibly roll away. There is a risk of an acj
cident. Before exiting, secure the vehicle
against rolling.
In order to ensure that the vehicle is secured against rolling away, observe the following:'ySet the parking brake.'yOn uphill grades or on a downhill slope,
turn the front wheels in the direction of the
curb.'yOn uphill grades or on a downhill slope,
also secure the vehicle, e.g., with a wheel chock.'

'yThe engine is not yet at operating temperjature.'yThe wheels are at a sharp angle or the
steering wheel is being turned.'yAfter driving in reverse.'yFogging of the windows when the autoj matic climate control is switched on.'yVehicle battery is heavily discharged.'yAt higher elevations.'yThe engine compartment lid is unlocked.'yHDC Hill Descent Control is activated.'yThe parking assistant is activated.'yStop-and-go traffic.'ySelector lever in selector lever position N,
M/S or R.'yUse of fuel with high ethanol content.
Starting
the
engine
The engine starts automatically under the foljlowing conditions:
'ySteptronic transmission: by releasing the
brake pedal.
When Automatic Hold is activated: press the accelerator pedal.
After the engine starts, accelerate as usual.
Safety
mode
After the engine switches off automatically, it will not start again automatically if any one of the following conditions are met:
'yThe driver's safety belt is unbuckled and
the driver's door is open.'yThe hood was unlocked.
Some indicator lights light up for a varied length of time.
The engine can only be started via the Start/
Stop button.
Functional
limitations
Even if driving off was not intended, the deactij
vated engine starts up automatically in the folj lowing situations:'yExcessive warming of the vehicle's interior
when the cooling function is switched on.'yThe steering wheel is turned.'ySteptronic transmission: change from sej lector lever position D to R, N or M/S.'ySteptronic transmission: change from sejlector lever position P to N, D, R or M/S.'yFogging of the windows when the autojmatic climate control is switched on.'yVehicle battery is heavily discharged.'yExcessive cooling of the vehicle's interior
when the heating is switched on.
Activating/deactivating
the
system
manually
Using
the
button
Press button.
'yLED comes on: auto Start/Stop function is deactivated.
The engine is started during an automatic engine stop.
The engine can only be stopped or started
via the Start/Stop button.'yLED goes out: auto Start/Stop function is activated.Seite 68ControlsDriving68
Online Edition for Part no. 0140 2 915 411 - X/16

Switching
off
the
vehicle
during
an
automatic
engine
stop
During an automatic engine stop, the vehicle
can be switched off permanently, for instance
when leaving it.
Steptronic transmission:1.Press the Start/Stop button. The ignition is switched off. The Auto Start/Stop functionis deactivated.
Selector lever position P is engaged autoj
matically.2.Set the parking brake.
Engine start as usual via Start/Stop button.
Automatic
deactivation
In certain situations, the Auto Start/Stop funcj
tion is deactivated automatically for safety reaj sons, e.g., if no driver is detected.
Malfunction The Auto Start/Stop function no longer
switches off the engine automatically. A Check Control message is displayed. It is possible to
continue driving. Have the system checked by
a dealerss service center or another qualified
service center or repair shop.
Parking
brake Concept
The parking brake is used to prevent the vehij cle from rolling when it is parked.
Safety
information WARNING
An unsecured vehicle can begin to move
and possibly roll away. There is a risk of an acj
cident. Before exiting, secure the vehicle
against rolling.
In order to ensure that the vehicle is secured against rolling away, observe the following:
'ySet the parking brake.'yOn uphill grades or on a downhill slope,
turn the front wheels in the direction of the
curb.'yOn uphill grades or on a downhill slope,
also secure the vehicle, e.g., with a wheel chock.'

The indicator light lights up red. The
parking brake is set.
While
driving
To use as emergency brake while driving:
Pull the switch and hold it. The vehicle brakes hard while the switch is being pulled.
The indicator light lights up red, a sigj
nal sounds and the brake lights light
up.
A Check Control message is displayed.
If the vehicle is slowed down to a speed of apj prox. 2 mph/3 km/h the parking brake is set.
Releasing
Releasing
manually
With the ignition switched on:
Steptronic transmission: press the
switch while the brake is pressed or sej
lector lever position P is set.
The LED and indicator light go out.
The parking brake is released.
Automatic
release
in
cars
with
Steptronic
transmission
For automatic release, step on the accelerator
pedal.
The LED and indicator lamp go out.
The parking brake is automatically released when you step on the accelerator under the
following conditions:'yEngine on.'yDrive mode engaged.'yDriver buckled in and doors closed.Automatic
Hold
Concept
This system assists the driver by automatically
setting and releasing the brake, such as when
moving in stop-and-go traffic.
The vehicle is automatically held in place when
it is stationary.
On inclines, the system prevents the vehicle
from rolling backward when driving off.
General
information Under the following conditions, Automatic
Hold is automatically deactivated and the parkj
ing brake is set:'yThe engine is switched off.'yA door is opened and driver's safety belt is
unbuckled while the vehicle is stationary.'yThe moving vehicle is brought to a standj
still using the parking brake.
The indicator light switches from green
to red and the letters AUTO H go out.
Safety
information WARNING
An unsecured vehicle can begin to move
and possibly roll away. There is a risk of an acj
cident. Before exiting, secure the vehicle
against rolling.
In order to ensure that the vehicle is secured against rolling away, observe the following:
'ySet the parking brake.'yOn uphill grades or on a downhill slope,
turn the front wheels in the direction of the
curb.'yOn uphill grades or on a downhill slope,
also secure the vehicle, e.g., with a wheel chock.'