dimensions BMW 7 SERIES 2006 E65 Advanced DVD System With Multimedia Changer Retrofit Instalation Instruction Manual
Page 21 of 30
Downloaded from www.Manualslib.com manuals search engine 21 © BMW AG, München 01 29 0 406 372 12.2005 (Z/Z)
8. To install the monitor
Slide the seat backrest cover (1) upwards.
Enlarge the existing holes (2) using a 9.1 mm
twist drill bit.
Insert rivet nuts AG.
Secure spacer bolts X to the seat backrest (1) with
one washer each AN and spacer bolts V to the
seat backrest (1) with
four washers each AN.
Move the seat cover (2) to its initial position.
Cut the seat cover (2) around the spacer bolts
using a knife.
Secure the monitor AA to the seat backrest (1)
using Torx screws Z.
The distance form the top of the monitor support
plate (2) to the headrest (3) must be approx. 10 mm.
The distance can be adjusted by removing
the washers AN or replacing the spacer
bolts V with spacer bolts W. At least one washer
AN must be fitted for each spacer bolt V or W.
Unscrew the monitor AA again
Cars without SA 456 only
Mark the hole at marking (1) on the inside of the
front seat rear panel (2) using the dimensions
shown.
Drill the hole using a 30 mm step drill.
2
1
AGAG
X
VV
1
2
AN
2
1
3AA
Z
Z
13 mm
30 mm2
1
060 0607 Z
Page 22 of 30
Downloaded from www.Manualslib.com manuals search engine 22 © BMW AG, München 01 29 0 406 372 12.2005 (Z/Z)
8. To install the monitor
Cars with SA 456 only
Mark the hole at marking (1) on the inside of the
front seat rear panel (2) using the dimensions
shown.
Drill the hole using a 30 mm step drill.
All cars
Place the rear monitor trim AC on the top edge
(1) of the outside of the front seat rear panel (2).
The hole (3) in the rear of the monitor trim AC
must line up with the hole (4) in the front seat rear
panel.
Mark the holes (5) and drill them using as 15 mm
step drill.
Measure the dimensions of branch F2.
Push fabric hose AF over seat wiring harness F
and secure it with adhesive tape using the
dimensions shown.
Affix the marking (1) with adhesive tape using the
dimensions.
2 mm
30 mm2
1
060 0770 Z
2
55
43
1
AC
1FAFF2