BMW X1 2017 Workshop Manual

WARNING
Unattended children or animals can
cause the vehicle to move and endanger themj selves and traffic, e.g., due to the following acj
tions:'yPressing the Start/Stop button.'yReleasing the parking brake.'yOpening and closing the doors or winj
dows.'yEngaging selector lever position N.'yUsing vehicle equipment.
There is a risk of accidents or injuries. Do not leave children or animals unattended in the vej
hicle. Take the remote control with you when exiting and lock the vehicle.'

Comfort
position
If the glass sunroof is not completely opened
automatically, the comfort position has been
attained. In this position the wind noises in the
interior are the least.
If desired, continue the movement by pressing
the switch.
Jam
protection
system
General
information
If the closing force when closing the glass sunj
roof exceeds a certain value, the closing movej ment is stopped, beginning at approximately
the middle of the opening in the roof, or from
the tilted position during closing. The glass
sunroof opens slightly.
Closing
from
the
open
position
without
jam
protection
If there is an external danger, proceed as folj
lows:1.Push the switch forward past the resistj
ance point and hold.
The glass sunroof closes with limited jam protection . If the closing force exceeds aspecific threshold, closing is interrupted.2.Push the switch forward again past the rej
sistance point and hold until the glass sunj
roof closes without jam protection . Make sure that the closing area is clear.
Closing
from
the
raised
position
without
jam
protection
If there is an external danger,
push the switch forward past the
resistance point and hold it.
The glass sunroof closes without jam protecj
tion .
Initializing
after
a
power
interruption
General
information
After a power failure during the opening or closing process, the glass sunroof can only be
operated to a limited extent.
The system can be initialized under the followj
ing conditions.'yThe vehicle is parked in a horizontal posij
tion.'yThe engine is running.'yThe external temperature is above
41 

SettingsVehicle
features
and
options
This chapter describes all standard, country- specific and optional features offered with theseries. It also describes features that are notnecessarily available in your vehicle, e. g., due
to the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and systems, the applicable laws and regulations
must be observed.
Sitting
safely
An ideal seating position that meets the needs
of the occupants can make a vital contribution to relaxed, fatigue-free driving.
In the event of an accident, the correct seating
position plays an important role. Additionally, observe the following chapters for safe driving:'ySafety belts, refer to page 56.'yHead restraints, refer to page 58.'yAirbags, refer to page 105.
Front
seats
Safety
information WARNING
Seat adjustments while driving can lead
to unexpected movements of the seat. Vehicle
control could be lost. There is a risk of an accij
dent. Only adjust the seat on the driver's side
when the vehicle is stationary.'

Forward/backward
Push switch forward or backward.
Height
Push switch up or down. Seat
tilt
Move switch up or down.
Backrest
tilt
Move switch forward or backward.Thigh
support
Pull the lever at the front of the seat and adjustthe thigh support.
Lumbar
support The curvature of the seat backrest can be adj
justed in a way that it supports the lumbar rej gion of the spine. The lower back and thespine are supported for upright posture.
'yPress the front/rear section
of the switch:
The curvature is increased/
decreased.'yPress the upper/lower secj
tion of the switch:
The curvature is shifted up/ down.
Backrest
width
You can change the width of the backrest usjing the side wings to adjust the lateral support.
Seite 54ControlsSettings54
Online Edition for Part no. 01 40 2 974 556 - X/16

Press button on the correj
sponding side.
Front
seat
heating
Overview
Seat heating
Switching
on Press button once for each temperajture level.
The maximum temperature is reached when three LEDs are lit.
If the trip is continued within approx. 15 mij
nutes after a stop, seat heating is activated auj
tomatically with the temperature selected last.
When ECO PRO is activated, the heater output
is reduced.
Switching
off Press and hold the button, until the
LEDs go out.
Rear
seats
Second
row
of
seats
Safety
information WARNING
There is a risk of jamming when folding
down the center armrest in the rear. There is a
risk of injury. Make sure that the area of movej
ment of the center armrest is clear during foldj
ing down.'

Backrest
tilt
Pull the strap and apply your weight to thebackrest or lift it off, as necessary.
Safety
belts Number
of
safety
belts
The vehicle is fitted with five safety belts to enj
sure occupant safety. However, they can only offer protection when adjusted correctly.
The two outer safety belt buckles of the rear
seat are intended for the persons sitting on the
left and right.
The center safety belt buckles of the rear seat are intended for the persons sitting in the midj
dle.
General
information
Always make sure that safety belts are being
worn by all occupants before driving off. Alj
though airbags enhance safety by providing added protection, they are not a substitute forsafety belts.
Slowly guide the safety belt out of the holder when fastening it.
The upper shoulder strap's anchorage point
will be correct for adult seat occupants of evj ery build if the seat is correctly adjusted.
Safety
information
WARNING
If the safety belt is used to buckle more
than one person, the protective effect of the safety belt can no longer be ensured. There is
a risk of injuries or danger to life. Do not allow more than one person to wear a single safety
belt. Infants and children are not allowed on an occupant's lap, but must be transported andsecured in designated child restraint sysj
tems.'

accident at the dealerss service center or anjother qualified service center or repair shop.'

safety belt reminder is active at speeds above
approx. 6 mph/10 km/h. It can also be activated
if objects are placed on the front passenger
seat.
Front
head
restraints Safety
information WARNING
A missing protective effect due to rej
moved or not correctly adjusted head rej
straints can cause injuries in the head and neck area. There is a risk of injury. Before drivj
ing, install the head restraints on the occupied seats. Ensure that the middle of the head rej
straint supports the back of the head approxij
mately at eye level.'

Rear
head
restraints
Safety
information WARNING
A missing protective effect due to rej
moved or not correctly adjusted head rej
straints can cause injuries in the head and neck area. There is a risk of injury. Before drivj
ing, install the head restraints on the occupied seats. Ensure that the middle of the head rej
straint supports the back of the head approxij
mately at eye level.'

1.Raise the head restraint up against the rej
sistance.2.Press button, arrow 1, and pull the head rej
straint out completely.
Seat
and
mirror
memory
Concept
Two driver's seat and exterior mirror positions
can be stored per driver profile, refer to page 44, and called up. Settings for the backj
rest width and lumbar support are not stored in memory.
Safety
information WARNING
Using the memory function while driving
can lead to unexpected movements of the
seat. Vehicle control could be lost. There is a
risk of an accident. Only retrieve the memory
function when the vehicle is stationary.'