BMW X2 2023 Owners Manual

Safety information
Warning
Operating materials, for instance oils, greases, coolants, fuels, can contain harmful ingredients. There is a risk of injury or dangerto life. Follow the instructions on the contain

Suitable engine oil types
Up to 1 US quart/liter of an engine oil with the following oil specification can be topped up:Gasoline engineBMW Longlife

CoolantVehicle features and options
This chapter describes all standard, country

Adding coolant1.Let the engine cool down.2.Open the hood.3.Turn the lid of the coolant reservoir slightly
counterclockwise to allow any excess pres

MaintenanceVehicle features and options
This chapter describes all standard, country

Diagnostic socket
General information
Devices connected to the diagnostic socket will
trigger the alarm system after locking the vehi

Replacing componentsVehicle features and options
This chapter describes all standard, country

4.Attach a new wiper blade. The wiper blade
must engage audibly.5.Fold in the wiper arm.
Replacing the rear wiper blade
1.Lift the wiper up fully and detach the wiper blade, arrow.2.Position the new wiper blade and press it
on until it you hear it snap into place.3.Fold the wipers in.
Light and bulb replacement
General information
Lights and bulbs
Lights and bulbs make an essential contribu

Headlight glassThe inside of the headlight glass can fog up incool or humid weather. When driving with thelights switched on, the condensation evapo

Remove cover, arrow 2.3.Loosen both nuts, arrow 1, of the outer tail
light. Use the handle of the screwdriver from the onboard vehicle tool kit to loosen.
Carefully pull out the tail light from the body
toward the front, arrow 2. Ensure that the
wiring is not damaged.4.Detach the connector from the light bracket
and detach the tail light wiring.Replacing the bulbs1.Turn the light bracket counterclockwise and remove.2.Press the faulty bulb gently into the socket,turn counterclockwise and remove.3.Proceed in the reverse order to insert thenew bulb and attach the light bracket.
Installing the tail light
1.Connect the plug and hook the wiring onthe tail light, arrow 1.2.Place the tail light with the lugs, arrows 2,on the attachment points of the body and
push onto both of the threaded bolts.3.Press on the tail lights until flush and
tighten both of the nuts.4.Mount the cover. Make sure that the plastic tabs of the cover are correctly seated in the
corresponding recesses of the body.
Lights in the tailgate
General
Follow the safety information, refer to
page 268.
Seite 270MOBILITYReplacing components270
Online Edition for Part no. 01405A540A1