suspension BMW X5 2001 E53 User Guide
Page 43 of 52
43
Special Operation Mode
• Assembly Line Mode (New control module)
The assembly line mode refers to control module manufacturing. New control modules
are stored in a deactivated state. The control programming is not active and must first
be ZCS encoded.
After installing a replacement control module, it must be coded using the DIS or MoDiC.
The instrument cluster fault display will remain illuminated until the control module is
coded.
Control Interrupts
Cornering
To prevent unnecessary suspension adjustments while driving through corners, a “control
interrupt” is built into the system. Above 30MPH the control module monitors the left/right
ride height sensors for a difference of 30mm. Exceeding this difference will put the system
into a control interrupt and no adjustment will take place. The control interrupt last for a
duration of 5 minutes.
Vehicle Lifting
The ride height control is interrupted when the vehicle is raised on a lift or with a jack. The
system monitors the ride height sensor inputs and when the height limit of 90 mm is
exceeded, the control is switched OFF until the vehicle is lowered again.
Page 45 of 52
45
DIS/Modic Service Funnction Program
The Service Functions program of the DIS/MoDiC provides the Transport Mode activa-
tion/deactivation and Ride Height Offset functions (see next page).
Once the transport mode has been released, or if the system requires left to right side
height adjustment, the ride height "OFFSET" must be carried out to ensure that the vehi-
cles suspension has a base ride height level starting point.
The "HEIGHT OFFSET" is adjusted using the DIS or MoDiC. The procedure is as follows:
• Place the vehicle on a level surface unloaded.
• Access the Height Offset program in the service function menu.
• Measure the base ride height from the lower edge of the wheel housing to the center of
the wheel hub.
• Check measured height against the specifications listed
• Use the DIS/MoDiC to correct the ride height if the value differs from the listed specifi-
cation.
Page 48 of 52
48
Wheels and Tires
Light alloy wheels are standard equipment on the X5.
The wheels sizes include:
3 Liter version
• Standard Wheel - 7.5J x17 SEH2
• Standard Tires - 235/65R - 17 H rated all season
Front and Rear
4.4 Liter version standard suspension
• Standard Wheel - 8.5J x 18 EH2
• Standard Tires - 255/55R - 18 H rated all season
Front and Rear
4.4 Liter version sports suspension
• Standard Wheels - 9J x 19 EH2 FRONT
10J x 19 EH2 REAR
• Standard Tires - 255/50R -19 Front/285/45R - 19
Rear V rated
The X5 uses a two piece lug bolt that incorporates a spacer wash-
er and features anti-corrosion coating. The tightening torque on the
lug bolts is 130Nm +/- 10Nm. Advantages of using the spacer
washer include:
• Longer expansion length for the bolt.
• A better fit to the wheel
• The spacer washer is fixed to the wheel when tightening and
the lug bolt turns relative to it.