run flat BUICK ENCLAVE 2009 Owner's Manual

If a tire goes at, avoid further tire
and wheel damage by driving slowly
to a level place and stopping.
1. Turn on the hazard warning
ashers. SeeHazard Warning
Flashers on page 3-5.
2. Park the vehicle. Set the parking
brake rmly and put the shift
lever in P (Park).
3. Turn off the engine.
4. Inspect the at tire.
{CAUTION
Lifting a vehicle and getting under
it to do maintenance or repairs is
dangerous without the appropriate
safety equipment and training. If a
jack is provided with the vehicle, it
is designed only for changing a at
(Continued)
CAUTION (Continued)
tire. If it is used for anything else,
you or others could be badly
injured or killed if the vehicle slips
off the jack. If a jack is provided
with the vehicle, only use it for
changing a at tire.
This vehicle may come with a jack
and spare tire or a tire sealant
and compressor kit. To use the jack
and spare tire, seeChanging a
Flat Tire on page 5-71. To use the
tire sealant and compressor kit,
seeTire Sealant and Compressor
Kit on page 5-57.
Tire Sealant and
Compressor Kit
{CAUTION
Idling a vehicle in an enclosed
area with poor ventilation is
dangerous. Engine exhaust may
enter the vehicle. Engine exhaust
contains Carbon Monoxide (CO)
which cannot be seen or smelled.
It can cause unconsciousness
and even death. Never run the
engine in an enclosed area that
has no fresh air ventilation. For
more information, seeEngine
Exhaust on page 2-30.
Service and Appearance Care 5-57

When using the tire sealant and
compressor kit during cold
temperatures, warm the kit in a
heated environment for 5 minutes.
This will help to inate the tire faster.
Always do a safety check rst.
SeeIf a Tire Goes Flat on
page 5-56. Do not remove any
objects that have penetrated the tire.
1. Remove the tire sealant and
compressor kit from its storage
location. SeeTire Sealant
and Compressor Kit Storage on
page 5-70.
2. Unwrap the sealant/air hose (F)
and the power plug (H).
3. Place the kit on the ground.
Make sure the tire valve
stem is positioned close to the
ground so the hose will reach it.4. Remove the valve stem cap from
the at tire by turning it
counterclockwise.
5. Attach the sealant/air hose (F)
onto the tire valve stem. Turn
it clockwise until it is tight.
6. Plug the power plug (H) into the
accessory power outlet in the
vehicle. Unplug all items
from other accessory power
outlets. SeeAccessory Power
Outlet(s) on page 3-18.
If the vehicle has an accessory
power outlet, do not use the
cigarette lighter.
If the vehicle only has a cigarette
lighter, use the cigarette lighter.
Do not pinch the power plug
cord in the door or window.7. Start the vehicle. The vehicle
must be running while using
the air compressor.
8. Turn the selector switch (A)
counterclockwise to the Sealant +
Air position.
9. Press the on/off (B) button to
turn the tire sealant and
compressor kit on.
The compressor will inject
sealant and air into the tire.
The pressure gage (C) will initially
show a high pressure while the
compressor pushes the sealant
into the tire. Once the sealant is
completely dispersed into the tire,
the pressure will quickly drop and
start to rise again as the tire
inates with air only.
5-64 Service and Appearance Care

Always do a safety check rst. See
If a Tire Goes Flat on page 5-56.
1. Remove the tire sealant and
compressor kit from it’s
storage location. SeeTire
Sealant and Compressor Kit
Storage on page 5-70.
2. Unwrap the air only hose (G)
and the power plug (H).
3. Place the kit on the ground.
Make sure the tire valve
stem is positioned close to the
ground so the hose will reach it.
4. Remove the tire valve stem cap
from the at tire by turning it
counterclockwise.
5. Attach the air only hose (G) onto
the tire valve stem by turning it
clockwise until it is tight.
6. Plug the power plug (H) into the
accessory power outlet in the
vehicle. Unplug all items
from other accessory power
outlets. SeeAccessory Power
Outlet(s) on page 3-18.If the vehicle has an accessory
power outlet, do not use the
cigarette lighter.
If the vehicle only has a cigarette
lighter, use the cigarette lighter.
Do not pinch the power plug
cord in the door or window.
7. Start the vehicle. The vehicle
must be running while using
the air compressor.
8. Turn the selector switch (A)
clockwise to the Air Only position.
9. Press the on/off (B) button to turn
the compressor on.
The compressor will inate the
tire with air only.
10. Inate the tire to the
recommended ination pressure
using the pressure gage (C).
The recommended ination
pressure can be found on the
Tire and Loading Information
label. SeeInflation - Tire
Pressure on page 5-42.The pressure gage (C) may
read higher than the actual tire
pressure while the compressor
is on. Turn the compressor off to
get an accurate reading. The
compressor may be turned on/off
until the correct pressure is
reached.
If you inate the tire higher than
the recommended pressure you
can adjust the excess pressure
by pressing the pressure deation
button (D), if equipped, until
the proper pressure reading is
reached. This option is only
functional when using the air
only hose (G).
11. Press the on/off button (B) to
turn the tire sealant and
compressor kit off.
Be careful while handling the tire
sealant and compressor kit as
it could be warm after usage.
12. Unplug the power plug (H) from
the accessory power outlet in
the vehicle.
Service and Appearance Care 5-69

F
Filter
Engine Air Cleaner............5-14
Finish Damage....................5-90
Flashers, Hazard Warning....... 3-5
Flash-to-Pass........................ 3-7
Flat Tire..............................5-56
Flat Tire, Changing...............5-71
Flat Tire, Storing..................5-80
Floor Mats..........................2-50
Fluid
Automatic Transmission.....5-15
Power Steering.................5-22
Windshield Washer...........5-23
Fog Lamp
Fog ................................3-14
Fog Lamp Light...................3-39
Fuel..................................... 5-5
Additives........................... 5-5
California Fuel................... 5-5
Driving for Better
Economy....................... 4-1
Filling a Portable Fuel
Container....................... 5-8
Filling the Tank.................. 5-7
Fuels in Foreign Countries . . . 5-6Fuel (cont.)
Gage ..............................3-40
Gasoline Octane................ 5-5
Gasoline Specications........ 5-5
Fuses
Fuses and Circuit
Breakers......................5-92
Instrument Panel Fuse
Block...........................5-92
Underhood Fuse Block......5-94
Windshield Wiper..............5-92
G
Gage
Engine Coolant
Temperature.................3-35
Fuel................................3-40
Speedometer...................3-30
Tachometer......................3-30
Voltmeter Gage................3-33
Garage Door Opener............2-44
Gasoline
Octane............................. 5-5
Specications..................... 5-5
Glove Box...........................2-49
GM Mobility Reimbursement
Program............................ 7-5
H
Hazard Warning Flashers........ 3-5
Head Restraints..................... 1-2
Headlamp
Aiming ............................5-33
Headlamps
Adaptive Forward Lighting
System........................3-14
Bulb Replacement.............5-33
Daytime Running Lamps/
Automatic Headlamp
System........................3-13
Delayed..........................3-13
Exterior Lamps.................3-12
Flash-to-Pass..................... 3-7
Halogen Bulbs..................5-34
High Intensity Discharge
(HID) Lighting...............5-33
High/Low Beam Changer..... 3-7
Heated Seats........................ 1-4
Heater
Engine Coolant.................2-23
Heater................................3-20
High Voltage Devices and
Wiring.............................5-91
Highbeam On Light..............3-40
Highway Hypnosis................4-12
Hill and Mountain Roads.......4-13
INDEX i-5

Remote Vehicle Start............. 2-5
Removing the Flat Tire and
Installing the Spare Tire.....5-74
Removing the Spare Tire and
Tools..............................5-72
Replacement Bulbs..............5-35
Replacement Parts,
Maintenance....................6-14
Replacement, Windshield......5-35
Reporting Safety Defects
Canadian Government.......7-13
General Motors................7-13
United States
Government..................7-12
Restraint System Check
Checking the Restraint
Systems.......................1-58
Replacing Restraint System
Parts After a Crash........1-59
Retained Accessory Power....2-22
Roadside
Assistance Program............ 7-6
Rocking Your Vehicle to Get
it Out ..............................4-16
Routing, Engine Drive Belt....6-15
Running the Vehicle While
Parked............................2-31S
Safety Belt Reminders..........3-30
Safety Belts
Care of ...........................5-86
How to Wear Safety Belts
Properly.......................1-16
Lap-Shoulder Belt.............1-20
Safety Belt Extender.........1-25
Safety Belt Use During
Pregnancy....................1-25
Safety Belts Are for
Everyone.....................1-12
Safety Warnings and Symbols.... iii
Scheduled Maintenance.......... 6-3
Seats
Heated and Cooled Seats.... 1-4
Heated Seats..................... 1-4
Manual Lumbar.................. 1-3
Memory, Mirrors................. 1-5
Power Lumbar ................... 1-4
Power Seats...................... 1-3
Rear Seat Operation........... 1-8
Reclining Seatbacks............ 1-6
Third Row Seat................1-10
Second Row Center
Console..........................2-50Secondary Latch System.......5-78
Securing a Child Restraint
Rear Seat Position............1-40
Right Front Seat
Position.......................1-42
Security Light......................3-39
Service................................ 5-3
Accessories and
Modications.................. 5-3
Adding Equipment to the
Outside of the Vehicle..... 5-4
California Perchlorate
Materials Requirements.... 5-4
California Proposition 65
Warning......................... 5-3
Doing Your Own Work........ 5-4
Engine Soon Lamp...........3-36
Publications Ordering
Information...................7-13
Service, Scheduling
Appointments..................... 7-8
Servicing Your
Airbag-Equipped Vehicle....1-56
Setting the Clock.................3-65
Sheet Metal Damage............5-89
Shifting Into Park
.................2-28
Shifting Out of Park..............2-29
INDEX i-9

Tires (cont.)
Pressure Monitor
Operation.....................5-45
Pressure Monitor System . . . 5-44
Removing the Flat Tire......5-74
Removing the Spare Tire
and Tools.....................5-72
Secondary Latch System . . . 5-78
Storing a Flat or Spare Tire
and Tools.....................5-80
Tire Sealant and
Compressor Kit.............5-57
Tire Sidewall Labeling.......5-37
Tire Terminology and
Denitions....................5-40
Uniform Tire Quality
Grading.......................5-52
Wheel Alignment and Tire
Balance.......................5-54
Wheel Replacement..........5-55
When It Is Time for New
Tires............................5-50
Tow/Haul Mode ....................2-26
Tow/Haul Mode Light............3-40Towing
Recreational Vehicle..........4-21
Towing a Trailer................4-24
Your Vehicle.....................4-21
Traction
Stabilitrak
®System............. 4-5
Transmission
Fluid, Automatic................5-15
Transmission Operation,
Automatic........................2-24
Turn and Lane-Change
Signals............................. 3-7
Turn Signal/Multifunction
Lever................................ 3-6
U
Ultrasonic Rear Parking
Assist (URPA)..................2-34
Uniform Tire Quality
Grading...........................5-52
Universal Home Remote
System...........................2-44
Operation........................2-45
V
Vehicle
Control............................. 4-3
Loading...........................4-16
Running While Parked.......2-31
Symbols.............................. iii
Vehicle Customization, DIC....3-57
Vehicle Data Recording and
Privacy............................7-14
Vehicle Identication
Number (VIN)...................5-90
Service Parts Identication
Label...........................5-91
Vehicle, Remote Start............. 2-5
Ventilation Adjustment...........3-25
Visors.................................2-16
Voltage Devices, High and
Wiring.............................5-91
Voltmeter Gage....................3-33
INDEX i-11