lights BUICK LACROSSE 2007 Get To Know Guide

3
See Section 3 of your Owner Manual.
B
D
F
G
H
I
K
L
M
X
W
E
ON
Q
Z
P
A
R
S
U
V
Y
T
J
Instrument Panel Cluster
Your vehicle’s instrument
panel is equipped with thiscluster or one very similar to it. The instrument panel
cluster includes these keygauges and lights/lamps.
A.Trunk Ajar
B.Door Ajar
C.Tire Pressure Monitor
D.Antilock Brake System
(ABS)
E.Cruise Engaged
F.TachometerG.Security
H.Seat Belt – Driver
I.Driver Air Bag
J.Service Vehicle Soon
K.Speedometer
L.Headlamp Suggested
M.Fuel Gauge
N.Washer Fluid Level
O.Battery
P.Temperature Gauge
Q.KilometersperHour
(km/h)R.Miles per Hour (mph)
S.High Beam
T.Reduced Engine Power
U.Service Traction Control
V.Check Gas Cap
W.Oil Level/ChangeOil
Soon
X.Service Engine Soon
Y.Oil Pressure
Z.Brake
Note:
The instrument panel
cluster is designed to letyou know about manyimportant aspects of yourvehicle’s operation. It is
important to read yourOwner Manual and becomefamiliar with the informationbeing relayed to you by thelights, gauges, DIC mes
sages and indicators,aswell as what action can
be taken to ensure safetyand to prevent damage.
C
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 3

5
E/M (English/Metric):On the base DIC,
press to choose English or Metric units.
On uplevel DICs, press the (Option)button until UNITS appears. Press the
(Set/Reset) button to choose English
or Metric units.
(Set/Reset)(if equipped): Press to
set/reset certain functions and to turn
off/acknowledge DIC messages.
(Gauges)(if equipped): Press to dis
play battery and oil life. To reset the OilLife System after an oil change, press
and hold the button while OIL LIFE
is displayed until it shows 100%.
(Fuel)(if equipped): Press to display
fuel range and average economy.
(Option) (if equipped): Press to dis
play English/Metric units, language,
personalization, compass zone andcompass calibration.
(Traction Control)(if equipped):
Press to turn traction control on or off.
(Hazard):Press to turn the hazard
warning flashers on or off.
Personalizing the DIC (if equipped)
Uplevel DICs can memorize selected
personalized settings for up to two drivers. (Some features are limited to asingle setting.)
1. Place the vehicle in Park (P) and turn
on the ignition.
2. Press the (Option) button until
PERSONALPROGRAM is
displayed.
3. Press the (Set/Reset) button
to display instructions.
4.Press the button to display
programmable features.
5. Press the button to change the
setting of each feature.
Your ignition key identifies you to the
vehicle.Two keys can be programmed
for certain features that correspond to
each driver. To personalize a key:
1. From the Personal Program menu,
press the (Option) button until
PERSONALIZE KEY is displayed.
2. Press the (Set/Reset) button until
YES is displayed.
3. Press the button.Personalization Features include:
Delayed Locking— Delays locking
of the vehicle doors for up to five
seconds after the last door is closed.
Two chimes will sound when the powerdoor lock switch or the Lock button onthe Remote Keyless Entry transmitter
is pressed when a door is open. Toprogram:
1. From the Personal Program menu,
press the (Option) button untilDELAYED LOCKING is displayed.
2. Press the (Set/Reset) button until
ON or OFF appears.
3.Press the button to select it.
The ignition key must be removed for
the feature to work after programming.
Key Fob Feedback— Choose from Off
(no feedback), Lights (exterior lightsflash) or Lights and Horn when you
press the Remote Keyless Entry transmitter (key fob) Lock button. To program:
1. From the Personal Program menu,
press the (Option) button until FOB LOCK FEEDBACK is displayed.
2. Press the (Set/Reset) button until
the desired setting is displayed.
3.Press the button to save the
setting.
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 5

Getting to Know YourLaCrosse6
Unlocking the Doors with the Key
Your vehicle’s passenger doors can be
unlocked using the driver’s door key.
With the key in the lock cylinder:
• Turn the key toward the front of the
vehicle to unlock the driver’s door.
• Turn and hold the key toward the
front of the vehicle for two seconds
to unlock all doors.
•Turn and hold the key toward the rear
of the vehicle to lock all doors.
See Section 2 of your Owner Manual.
SAFETY & SECURITY
Automatic Door Locks
Auto Door Lock
The automatic door locks will lock the
vehicle’s doors when all doors areclosed and the vehicle is shifted intoDrive.
Auto Door Unlock
Automatic door unlocking options
include off, unlocking the driver’s door
or unlocking all doors. Press the button on the DIC until Auto Door
Unlock is displayed; and then press
the button to scroll through Off,
Driver and All. If Driver or All is selected,two additional choices — KeyOut andPark — will be displayed. Select one ofthese choices to determine when the
vehicle’s door(s) will automaticallyunlock.
See Section 3 of your Owner Manual.
Exterior Light Delay— Sets the time
for exterior lights to remain on after thekey is removed from the ignition or thevehicle is unlocked with the Remote
Keyless Entry transmitter. To program:
1. From the Personal Program menu,
press the (Option) button until
EXTLIGHT DELAY is displayed.
2. Press the (Set/Reset) button to
scroll through OFF or 15/30/60/90second delays.
3. Press the button to store a setting.
You can also use the (Option) and
(Set/Reset) buttons to personalize
each of the following:
• Return settings to factory default/
reset all keys
• Interior lights on when key is
removed from the ignition
• Content theftdeterrent system on/off
Exiting Programming Mode:The DIC
exits programming mode when:
• The vehicle is shifted out of Park.
• The vehicle is no longer in Run.
See Section 3 of your Owner Manual.
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 6

Getting to Know YourLaCrosse12
CONVENIENCE
Remote Vehicle Start
(if equipped)
Use the Remote Keyless Entry transmit
ter (key fob) to start the engine fromoutside the vehicle. (See the Driver
Information Center personalization menu
section to enable.) Automatic Climate
Control system vehicles will regulate the
inside temperature.
To remote start the vehicle:
1. Press and release the key fob Lock
button.
2. Press and hold the (Remote Start)
button until the turn signal lights flash.If the lights are not visible, hold theRemote Start button for four secondsand release.
The engine runs for 10 minutes. Extend
run time for 10 minutes from present bypressing the Lock and Remote Start but
tons again. Pressing only the Remote
Start button again will turn off the ignition. Maximum run time is 20 minutes.
After two remote starts have been pro
vided, the Remote Vehicle Start featurewill not operate.
See Section 2 of your Owner Manual.
Finding a Category Station
(if equipped)
Category (CAT) stations are available on
XM1 or XM2 bands only. To find a CATstation:
1. Press the CAT button to activate
Program Type (PTY) Select mode.
2. A category is displayed.
3. Rotate the Tune knob. When the
preferred category appears, press theSeek button to go to the first categorystation (pressing Seek for more thantwo seconds will activate CategoryScan).
4. To go to another station, press the
CAT button. The previously storedcategory will be displayed.
5. Press the up or down Seek button.
6. Press the CAT button to exit Program
Type Select mode.
Audio Steering Wheel Controls
(if equipped)
See Audio Systems for full details about
the functions of the following buttons:
•
(Seek)
•BAND
•1–6 (Preset Stations)
•(OnStar®/Mute):Press to silence
audio, and again to play. In OnStar
equipped vehicles, press to interactwith the OnStar system.
•
(VOLUME):Press up/down
arrow to increase/decrease volume.
See Section 3 of your Owner Manual.
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 12

13
Headlamp Controls and
Automatic Headlamp System
You will find the exterior lamps knob on
the left side of the instrument panel.
(On/Off): To turn the headlamps off
when the lights are on, turn the control
to the position. The momentary
switch design springs back to AUTOwhen released.
AUTO:Activates the automatic head
lamp system, illuminating all exterior
lamps and the instrument panel/radiolights when needed.
(Parking Lamps):The parking lamp
position illuminates tail/side marker/license plate lamps and instrumentpanel/radio lights.
(Headlamps):The headlamps posi
tion manually activates the headlamps,
exterior tail/marker lamps and instrument panel/radio lights.
(Fog Lamps):To activate the fog
lamps, press the center of the rotarycontrol marked .
To switch headlamps from low to high
beam, push the multifunction lever awayfrom you. Pull it back and release forlowbeam operation.
See Section 3 of your Owner Manual.
Daytime Running Lamps (DRL)
DRL illuminates the lowbeam head
lamps at a lower intensity in daylight to make the front of the vehicle more
visible to others. The DRL illuminatesonly the lowbeam headlamps, not the taillamps or side marker lamps.
See Section 3 of your Owner Manual.
Interior Lamps
The interiorlamps control is located next to
the exterior lamps control on the left side
of the instrument panel. It can be set to:
(Off):This position disables the inte
rior lamps entirely, whether or not a dooris open.
(Door):This position turns on the
interior lamps when a door is openedand when the ignition key is removed.
(On):This position turns on the
interior lamps continuously.
Instrument Panel Brightness:When
you push the center of the interior lampsknob, a springloaded stem will pop out.
Turn it right or left to adjust intensity.
Reading Lamps:Press the reading light
lens to turn on/off.
See Section 3 of your Owner Manual.
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 13

Getting to Know YourLaCrosse18
Ultrasonic Rear Parking Assist
(if equipped)
Ultrasonic Rear Parking Assist (URPA)
detects objects up to 5 feet (1.5 m)behind the vehicle when the shift lever is in the Reverse position and vehiclespeed is less than 3 mph (5 km/h).Three colorcoded lights inside the
vehicle, above the rear window, providedistance and system information to thedriver.
See Section 3 of your Owner Manual.
Antilock Brake System
The Antilock Brake System (ABS) helps
prevent a braking skid. The ABS warning light illuminates briefly when theengine is started. Momentary motor orclicking noises and slight brake pedalmovement are normal as the systemchecks itself when reaching speeds ofapproximately 3 to 5 mph.
See Section 4 of your Owner Manual.
Traction Control System (TCS)
The Traction Control System (TCS)
limits wheelspin. TCS activates when it
senses one or both front wheels spin
ning or losing traction. Then the systemreduces engine power and may upshiftthe transaxle to limit wheelspin. It is nor
mal to hear or feel the system working.
TCS is always enabled unless you disable it manually to rock the vehicle free
from sand, mud or snow.
To disable TCS, press the TCS button
on the instrument panel. The TCS warning light will come on. Press the button
again to turn TCS on.
See Section 4 of your Owner Manual.
StabiliTrak® – Stability Control
System (if equipped)
StabiliTrak is a computercontrolled sys
tem that detects and corrects differencesbetween the path you have chosen and
the vehicle’s actual direction by applyingbrake pressure individually at the appro
priate wheel. When the system acti
vates, STABILITY CONTROL ACTIVEdisplays on the DIC.
See Section 4 of your Owner Manual.
LaCrosse 2007 A.qxd 4/25/06 11:14 AM Page 18