headlamp BUICK LESABRE 2005 Get To Know Guide

Instrument Panel . . . . . . . . . . . . . . . . . . . . . . . . . .2
Instrument Panel Cluster . . . . . . . . . . . . . . . . . . .3
Audio Systems . . . . . . . . . . . . . . . . . . . . . . . . . . .4Climate Controls . . . . . . . . . . . . . . . . . . . . . . . . . .6
Power Seat Controls . . . . . . . . . . . . . . . . . . . . . . .7
Heated Seats . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7Door Locks and Child Security . . . . . . . . . . . . . .8
Mirrors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Window Controls . . . . . . . . . . . . . . . . . . . . . . . . . .9Sunroof . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Lamp Controls . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Turn Signal/Multifunction Lever . . . . . . . . . . . .10Cruise Control . . . . . . . . . . . . . . . . . . . . . . . . . . .11Headlamps — High Beam . . . . . . . . . . . . . . . . . .11
Trunk Release . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Valet Key . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Convenience Features . . . . . . . . . . . . . . . . . . . .13OnStar
® . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14
HeadUp Display (HUD) . . . . . . . . . . . . . . . . . . . .14
Universal Transmitter . . . . . . . . . . . . . . . . . . . . .15
Driver Memory Seat and Mirrors . . . . . . . . . . . .16
Driver Information Center (DIC) . . . . . . . . . . . . .16
DIC Programming . . . . . . . . . . . . . . . . . . . . . . . .17
Roadside Assistance . . . . . . . . . . . . . . . . . . . . .20
My GMLink . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20
Congratulations on your purchase of a Buick LeSabre. Please read this information and your Owner Manual
to ensure an outstanding ownership experience. Note that your vehicle may not include all the featuresdescribed in this booklet. Place this booklet in your Owner Manual portfolio for easy reference.

Turn Signal/Multifunction Lever
Windshield Wiper Controls
MIST
Turn the WIPER band toward you and
release it for a single wipe cycle. Formore cycles, hold the band on MIST
longer.
WASH
Push the washer PUSH tab to spray
washer solvent on the windshield. The headlamps, parking and backup
lamps will illuminate when you press theunlock symbol ( ) on the keyfob
transmitter.
See Section 3 of your Owner Manual.
Getting to Know YourLeSabre10
Lamp Controls
Interior Lamps
See Section 3 of your Owner Manual for
interior lamp operating instructions.
Daytime Running Lamps
The Daytime Running Lamps will come
on when the ignition is on, the headlamp
switch is OFF, and the transaxle is not inPark (P).
Twilight Sentinel
This feature automatically switches the
headlamps on and off by sensing how
dark it is outside. You should not have to
manually turn the headlamps on or off.
The Twilight Sentinel control lever is
located to the left of the steering
column. To operate it, slide the leverfrom OFF to MAX to adjust the headlamps ON time from a few secondsto three minutes, after the ignition has
been turned OFF.
Perimeter Lighting
Notice:
Driver #1 and Driver #2 key
fob settings are unique. Refer to DICProgramming.

11
Rainsense™ Wipers (if equipped)
The Rainsense system monitors the
amount of moisture on the windshieldand automatically operates the wipers
as needed, depending on driving condi
tions and the sensitivity setting. The
moisture sensor is mounted on the interior side of the windshield behind the
rearview mirror.
The Rainsense wipers operate in a
delay mode as well as a continuous lowor high speed as needed. If the system
is left on for long periods of time, occasional wipes may occur without anymoisture on the windshield to indicatethe system is active.
To activate the Rainsense wipers:
Turn the wiper band to one of the five
sensitivity levels within the delay area.
The position closest to OFF is the low
est sensitivity level. Each higher sensitivity level increases the frequency of
wipes. The system can be overridden atany time by manually turning the wiperband to LO or HI speed.
See Section 3 of your Owner Manual.
Cruise Control
Set Cruise Control
The Cruise Control buttons are located
on the steering wheel. Press theON/OFF button to turn Cruise Control
on. Accelerate to the speed you want to set.
Press the SET/COAST button. The
Cruise Control light on the instrumentcluster will illuminate. Remove your footfrom the accelerator pedal.
Resume Set Speed
Applying the brakes will turn the Cruise
Control off.
Press the RESUME/ACCELbutton.
The vehicle’s preset speed will resume.
OFF
Press ON/OFF or step on the brake
pedal.
See Section 3 of your Owner Manual.
Notice:Turn the Rainsense
wipers off to avoid wiper damagewhen going through an automaticcar wash.
Headlamps — High Beam
High/Low Beam Changer
Pull the turn signal lever toward you until
it clicks to change from low beam tohigh beam.
FlashToPass
Pull and hold the turn signal lever toward
you briefly to flash the headlamps.
See Section 3 of your Owner Manual.

19
Perimeter Lighting
To turn the headlamps, parking lamps
and backup lamps on when you press
on the key fob/transmitter:
1.
PERIMETER LIGHTS (OFF/ON)Press ENG/MET to select OFF or
ON.
If you select OFF for PERIMETER
LIGHTS, there will be no perimeterlighting.
If you select ON for PERIMETER
LIGHTS, the lights will illuminate.
Press RESET to record your choice.
Memory Seats Recall
To recall the position of your seat and
mirrors when you press unlock on thekey fob/transmitter:
1.
SEAT RECALL(OFF/ON)Press
ENG/METto select OFF or ON.
If you select OFF for SEAT RECALL,
there will be no seat recall feature.
If you select ON for SEAT RECALL,
the seat and mirrors will move to theirpreset memory positions when thevehicle is unlocked using the key
fob/transmitter.
Press RESET to record your choice.
2.
RECALL POSITION MEMORY(EXIT)Press ENG/MET to select
MEMORYor EXIT.
If you select MEMORY for RECALL
POSITION, the seat and mirrors willmove to their preset memory positions.
Note:If you desire perimeter lighting,
you must select LIGHTS for UNLOCKFEEDBACK.
If you select EXIT for RECALL POSI
TION, the seat and mirrors will moveto their preset exit positions.
Press RESET to record your choice.
Window Lockout
To select the number of passenger win
dows you want to prevent from beingopened:
1.
WINDOW LOCK (R+ PASS/REAR)Press ENG/MET to select R+ PASS
or REAR.
If you select R+ PASS for WINDOW
LOCK, all three passenger windowswill lock out.
If you select REAR, the two rear win
dows will lock out.
Press RESET to record your choice.
See Section 3 of your Owner Manual.
Note:This feature is activated by press
ing the WINDOW LOCK switch on the
driver’s door.