length BUICK RAINIER 2005 Get To Know Guide

Page 4 of 20

Getting to Know YourRainier4
Trip Information Button:Press
to access each of the odometer,
TRIP A, TRIP B and TIMER functions.To reset either trip odometer to zero,
access it on the DIC and press the
Select button ( ) for one second, orpress and hold the reset stem on the
instrument cluster.
Use the TIMER function to time the
length of your trip, pressing to startor stop the timer when the function is
displayed on the DIC. To reset it to zero,press and hold when the function isdisplayed on the DIC.
Fuel Information Button:Press
to access the range, average fuel
economy, fuel used and the GM Oil LifeSystem
TMstatus.
RANGE estimates the remaining dis
tance you can drive without refueling. It is based on recent fuel economy andremaining fuel.
AVG ECON calculates how many miles
per gallon you are getting based on current and past driving conditions. Press
and hold the reset stem while it is displayed and the DIC will begin calculatingaverage fuel economy from that point intime.
Driver Information Center (DIC)
The Driver Information Center (DIC) fea
tures a message center that can display
trip information, fuel economy information, personalization features and othermessages or warnings.The DIC displayis located above the steering wheel on
the instrument cluster, and can be pro
grammed in three languages. To accessthe various DIC modes, press one ofthe four DIC buttons located on the
steering wheel: Trip Information, FuelInformation, Personalization or Select.
Malfunction Indicator Lamp(Service Engine Soon Lamp)
Located on the instrument panel, this
lamp illuminates under a variety of conditions when the OnBoard DiagnosticsII (OBD II) system detects a malfunction
in the vehicle’s emission controls. If it is
lit steadily, check the gas cap to ensurethat it is attached and securely fastened.
Turn it clockwise until a “ratcheting”sound is heard, signaling that it is
secure. If this is the cause of the condi
tion, and the cap is installed properly,
this should turn the light off.
See Section 3 of your Owner Manual.

Page 15 of 20

15
For garage door openers with a “rolling
code,” continue with the following steps:
• Firmly press the training button (usu
ally marked “LEARN” or “SMART”) onthe garage door opener motor headunit near the antenna.
• Within 30 seconds, press and hold
the HomeLink
®transmitter button pro
grammed in the previous steps fortwo seconds.
• Press and release this button twice
more for two seconds each time.
See Section 2 of your Owner Manual.
Remote Keyless Entry System
The RKE system locks and unlocks the
doors and lift glass from a range of 3 to
30 feet (1–9 m). At times the range maybe shorter than usual, which is normal. If the transmitter doesn’t seem to beworking properly:
• Ensure that you are within transmitter
range of the vehicle. Rainy and
snowy weather can reduce transmitter range.
Note:To ensure successful HomeLink®
Transmitter programming, it’s important
that your garage door opener battery bewell charged.
Content TheftDeterrent System
The Content TheftDeterrent System has
a red indicator lamp on the instrumentpanel that is labeled
SECURITY. The
system can be activated in two ways:
• Press the
LOCKbutton on the
Remote Keyless Entry key fob afterclosing all doors.
• Press the power door
LOCKswitch
with the door open.
The alarm is not armed until the
SECURITYlight turns off (after a delay
of approximately 30 seconds).
If the alarm is tripped, the horn sounds
for 30 seconds, and the headlamps andparking lamps also flash for two minutes
to get visual attention. The alarm soundswhenever a locked door is opened with
out the key or Remote Keyless Entry
System transmitter.
See Section 2 of your Owner Manual.
• Check to see if other vehicles or
obstacles are blocking the transmittersignal by stepping a few feet to theleft or right, and hold the transmitterhigher when pressing the button(s).
• Consider the length of time that
the transmitter battery has been inservice and replace it if necessary
(the DIC will display “RFA # BATLOW” if the battery needs replacing).Use CR 2032 battery or equivalent.
See Section 2 of your Owner Manual.