seat memory BUICK RANDEZVOUS 2005 Owner's Manual

Front Armrest Storage Area...........................2-40
Rear Storage Area........................................2-40
Roof Rack System........................................2-40
Convenience Net..........................................2-43
Cargo Cover................................................2-43
Rear Convenience Center..............................2-44Sunroof.........................................................2-47
Vehicle Personalization...................................2-47
Memory Seat...............................................2-47
Section 2 Features and Controls
2-2

Sunroof
If the vehicle has a
sunroof, the switch to
operate it is located on the
headliner, between the
sun visors.
The sunroof switch will only work when the ignition is
ON or when the ignition is OFF and retained accessory
power (RAP) is active. SeeRetained Accessory
Power (RAP) on page 2-21.
Notice:Opening the sunroof when the luggage
rack crossrails are not in the full-rear position could
cause damage to the sunroof or luggage rack.
Verify the luggage rack crossrails are in the full-rear
position before opening the sunroof.
Press the rear of the switch to open the sunroof to the
vent position. The sunshade must be opened by hand.Press and release the rear of the switch a second time to
express-open the sunroof. The sunshade will open with
the sunroof. Press the switch in either direction to stop it
from moving. If the rear of the switch is pressed and held,
the express-open operation will be overridden.
To close the sunroof, press and hold the front of the
switch.
Vehicle Personalization
Memory Seat
If your vehicle has this
feature, the controls are
located on the driver’s door
panel and are used to
store and recall the driver’s
seat position and the
outside rearview mirror
position.
The settings for these features can be personalized for
both driver 1 and driver 2. Driver 1 and driver 2
correspond to the memory buttons labeled 1 and 2 on
the driver’s door.
2-47

To store the memory settings, do the following:
1. Adjust the driver’s seat and the outside rearview
mirrors to the position you would like for driving.
2. Press and hold memory button 1 for more than
three seconds.
A double beep will sound when the memory seat and
mirror position have been stored.
To store the seat and outside rearview mirror positions
for a second driver, follow the previous steps, but
press button 2 instead.
To recall your stored positions, your vehicle must be in
PARK (P). Press and release the memory button (1 or 2)
corresponding to the desired driving position. The
seat and the outside rearview mirrors will move to the
position previously stored for the identied driver.
You will hear one beep.To store an exit position for each driver, do the following:
1. Move the seat to the desired exit position.
2. Hold the button with the exit symbol, located below
the memory buttons, for more than three seconds.
The exit position stored will be for the most recently
selected driving position (1 or 2). A double beep
will sound when the exit position is stored.
To use the exit feature, your vehicle must be in PARK (P).
Press and release the button with the exit symbol and the
seat will move to the exit position stored for the most
recently selected driver. You will hear one beep.
To stop recall movement of the seat at any time, press
one of the three memory buttons or one of the power seat
controls located on the outboard side of the driver’s seat.
If your vehicle is equipped with a Driver Information
Center (DIC), you can use it to program certain functions
of the memory seats. SeeDIC Vehicle Personalization
on page 3-66.
2-48

Lock Feedback
The lock feedback feature can be programmed to one
of the following modes:
OFF:When LOCK is pressed on the remote keyless
entry transmitter, the headlamps and parking lamps will
not ash and the horn will not sound.
LIGHTS:When LOCK is pressed on the remote
keyless entry transmitter, the headlamps and parking
lamps will ash briey.
LIGHTS and HORN:When LOCK is pressed a second
time on the remote keyless entry transmitter within
ve seconds, the headlamps and parking lamps
will ash briey and the horn will sound.
Your vehicle was originally programmed to LIGHTS and
HORN. The mode may have been changed since
then. To determine the current mode, or to change the
mode, do the following:
1. Follow the instructions for “Entering Programming
Mode” listed previously.
2. Press the MODE button until LOCK FEEDBACK
appears on the DIC.
3. Press the SET button until the arrow is before OFF,
LIGHTS or LIGHTS and HORN.The mode you selected is now set. You can either exit
programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
Seat Recall
The seat recall feature can be programmed to one of
the following modes:
ON:The previously programmed memory seat position
will be recalled when the UNLOCK button is pressed
on the remote keyless entry transmitter.
OFF:No memory seat position will be recalled when
you press the UNLOCK button on the remote keyless
entry transmitter.
To determine the mode to which your vehicle is
programmed or to program your vehicle to a different
mode, do the following:
1. Follow the instructions for “Entering Programming
Mode” listed previously.
2. Press the MODE button until SEAT RECALL
appears on the DIC.
3. Press the SET button until the arrow is before ON
or OFF.
3-73

If the seat recall feature has been programmed to ON,
the seat recall feature can also be programmed to
one of the following modes:
MEMORY:The position recalled will be the memory
driving position.
EXIT:The position recalled will be the previously
programmed exit position.
To determine the mode to which your vehicle is
programmed or to program your vehicle to a different
mode, do the following:
1. Follow the instructions for “Entering Programming
Mode” listed previously.
2. Follow the instructions for programming SEAT
RECALL to ON listed previously.
3. Press the MODE button until RECALL POSITION
appears on the DIC.
4. Press the SET button until the arrow is before
MEMORY or EXIT.
The mode you selected is now set. You can either exit
programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.Tilt Mirror
The tilt mirror feature can be programmed to one of the
following modes:
ON:The passengers side outside rearview mirror will
tilt down towards the curb when the vehicle is shifted to
REVERSE (R) and returns to its previous position
when the vehicle is shifted out of REVERSE (R).
OFF:The mirror will not tilt.
To determine the mode to which your vehicle is
programmed or to program your vehicle to a different
mode, do the following:
1. Follow the instructions for “Entering Programming
Mode” listed previously.
2. Press the MODE button until TILT MIRROR
appears on the DIC.
3. Press the SET button until the arrow is before ON
or OFF.
The mode you selected is now set. You can exit
programming mode by following the instructions next in
this section.
3-74

Lockout Protection..........................................2-11
Locks
Delayed Locking........................................... 2-9
Door........................................................... 2-8
Lockout Protection.......................................2-11
Power Door.................................................. 2-9
Programmable Automatic Door Locks.............2-10
Rear Door Security Locks.............................2-10
Loss of Control...............................................4-15
Low Brake Fluid Warning Message....................3-59
Low Engine Oil Level Message.........................3-55
Low Fuel Warning Message.............................3-58
Low Oil Pressure Message...............................3-54
Low Tire Message..........................................3-56
Low Washer Fluid Warning Message.................3-58
Lumbar
Manual Controls............................................ 1-5
M
Maintenance Schedule
Additional Required Services........................... 6-6
At Each Fuel Fill........................................... 6-8
At Least Once a Month.................................. 6-9
At Least Once a Year.................................... 6-9Maintenance Schedule (cont.)
Introduction.................................................. 6-2
Maintenance Footnotes.................................. 6-7
Maintenance Record....................................6-14
Maintenance Requirements............................. 6-2
Normal Maintenance Replacement Parts.........6-13
Owner Checks and Services........................... 6-8
Recommended Fluids and Lubricants.............6-12
Scheduled Maintenance................................. 6-4
Using Your................................................... 6-2
Your Vehicle and the Environment................... 6-2
Malfunction Indicator Light................................3-46
Manual Lumbar Controls.................................... 1-5
Manual Passenger Seat.................................... 1-3
Memory Seat.................................................2-47
Message
All-Wheel Drive Disable Warning....................3-57
Center.......................................................3-51
Change Engine Oil......................................3-55
Charging System Indicator............................3-53
Door Ajar Warning.......................................3-56
Engine Coolant Temperature Warning.............3-52
Highbeam Out Warning................................3-61
Low Brake Fluid Warning..............................3-59
Low Engine Oil Level...................................3-55
Low Fuel Warning.......................................3-58
9

Safety Belts (cont.)
Rear Safety Belt Comfort Guides for Children
and Small Adults......................................1-40
Rear Seat Passengers.................................1-34
Right Front Passenger Position......................1-34
Safety Belt Extender....................................1-42
Safety Belt Use During Pregnancy.................1-34
Safety Belts Are for Everyone.......................1-20
Shoulder Belt Height Adjuster........................1-33
Safety Warnings and Symbols.............................. iii
Scheduled Maintenance..................................... 6-4
Seats
Captain Chairs............................................1-13
Four-Way Manual Driver Seat......................... 1-3
Head Restraints............................................ 1-7
Heated Seats............................................... 1-5
Manual Lumbar............................................. 1-5
Manual Passenger......................................... 1-3
Memory.....................................................2-47
Rear Seat Operation...................................... 1-8
Reclining Seatbacks...................................... 1-6
Six-Way Power Seats.................................... 1-4
Split Bench Seats......................................... 1-8
Stowable Seat............................................1-17
Secondary Latch System.................................5-84Securing a Child Restraint
Center Rear Seat Position............................1-62
Designed for the LATCH System...................1-60
Rear Outside Seat Position...........................1-60
Right Front Seat Position..............................1-64
Security Message, PASS-Key
®III ......................3-57
Service........................................................... 5-3
Adding Equipment to the Outside of Your
Vehicle..................................................... 5-5
Doing Your Own Work................................... 5-4
Engine Soon Light.......................................3-46
Publications Ordering Information...................7-12
Traction System Warning Message.................3-51
Vehicle Soon Message.................................3-59
Servicing Your Airbag-Equipped Vehicle..............1-82
Setting the Time.............................................3-76
Sheet Metal Damage.....................................5-101
Shifting Into Park (P).......................................2-27
Shifting Out of Park (P)...................................2-28
Shoulder Belt Height Adjuster...........................1-33
Signals, Turn and Lane-Change.......................... 3-7
Spare Tire
Installing....................................................5-80
Removing...................................................5-74
Storing.......................................................5-88
13

Vehicle Personalization
DIC ...........................................................3-66
Memory Seat..............................................2-47
Ventilation Adjustment......................................3-36
Visors...........................................................2-15
W
Warning Lights, Gages and Indicators................3-37
Warnings
Hazard Warning Flashers............................... 3-6
Other Warning Devices.................................. 3-6
Safety and Symbols......................................... iii
Vehicle Damage.............................................. iv
Washer Fluid Low Warning Message.................3-58
Wheels
Alignment and Tire Balance..........................5-68
Replacement...............................................5-68
Where to Put the Restraint...............................1-52
Windows.......................................................2-13Windows (cont.)
Power........................................................2-14
Windshield
Backglass, and Wiper Blades, Cleaning..........5-99
Windshield Washer........................................... 3-9
Fluid..........................................................5-37
Windshield Wiper
Blade Replacement......................................5-53
Fuses......................................................5-104
Windshield Wipers......................................... 3-9
Winter Driving................................................4-26
X
XM™ Satellite Radio Antenna System..............3-135
Y
Your Driving, the Road, and Your Vehicle............. 4-2
Your Vehicle and the Environment....................... 6-2
16