BUICK REGAL 1994 Repair Manual
Page 61 of 308
2.
3.
4.
Put the restraint on the seat. Follow the instructions
for the child restraint.
Secure the child
in the child restraint as the
instructions say.
Run the vehicle’s safety belt through or around the
restraint. The child restraint instructions
will show
you how.
5. Buckle the belt. Make sure the release button is
positioned so you would be able to unbuckle the
safety belt quickly
if you ever had to.
6. To tighten the belt, pull its free end while you push
down
on the child restraint.
7. Push and pull the child restraint in different
directions
to be sure it is secure. If the child restraint
isn’t secure, turn the latch plate over and buckle
it
again. Then see if it is secure. If it isn’t, secure the
restraint
in a different place in the vehicle and
contact the child restraint maker for their advice
about how to attach
the child restraint properly.
To remove the child restraint, just unbuckle the vehicle’s
safety belt. It will be ready to work for an adult or larger
child passenger.
59
ProCarManuals.com
Page 62 of 308
Securing a Child Restraint in the Right
Front
Seat
To use a child restraint here, you will need a special
infant/child seat attaching belt and the hardware that
goes with
it. See the earlier section about the top strap if
the child restraint has one.
Your dealer can get these and install the hardware
for
you. It’s free. The special belt is GM Part Number
12340286. Your dealer can find the correct hardware in
the accessory section of the
GM Parts Catalog.
Once the special hardware is installed, please follow the
instructions
with it and these steps:
60
ProCarManuals.com
Page 63 of 308
1. Unbuckle the automatic lap-shoulder belt by pushing
the button on the buckle. 2. Snap one hook of the infant/child seat attaching belt
near the floor at the door side
of the seat.
It will stay on the door, ready
to be rebuckled for use
by adults
or older children.
ProCarManuals.com
Page 64 of 308
3. Put the belt's special latch plate into the vehicle's
safety belt buckle.
I
4. You can make the belt longer by tilting the buckle
and pulling
it along the belt.
.:
5. Put the restraint on the seat. Follow the instructions
for the child restraint.
6. Secure the child in the child restraint as the
instructions say.
62
ProCarManuals.com
Page 65 of 308
7. Run the belt through or around the child restraint.
The child restraint instructions will show
you how.
8. Put the hook on the free end through the slot in the
latch plate.
x
9. To make it tight, pull the belt while you push down
on the child restraint. If the belt won't stay tight,
switch
it end for end.
10. Push and pull the child restraint in different
directions to be sure
it is secure.
63
ProCarManuals.com
Page 66 of 308
To remove the infantlchild seat restraint:
1. Push the button on the safety belt buckle and remove
the special latch plate. Leave the latch plate on the
special belt.
A
4. Remember to reattach the automatic belt again, once
the child restraint is removed. Be sure it isn’t twisted.
Larger Children
2. Push the spring on the hook near the door and
remove
the special belt.
3. Put the belt away in a safe place in your vehicle, so it
won’t fly around in a crash and injure someone.
A
Children who have outgrown child restraints should
wear the vehicle’s safety belts.
If you have
the choice, a child should sit next to a
window
so the child can wear a lap-shoulder belt and
get the additional restraint a shoulder belt can provide.
64
ProCarManuals.com
Page 67 of 308
Accident statistics show that children are safer if they
are restrained
in the rear seat. But they need to use the
safety belts properly.
Children who aren’t buckled up can be thrown out in
a crash.
Children who aren’t buckled up can strike other
people who are.
I &!, CAUTION:
Never do this.
Here
two children are wearing the same belt. The
belt can’t properly spread the impact forces.
In a
CAUTlON: (Continued)
65
ProCarManuals.com
Page 68 of 308
What if a child is wearing a lap-shoulder belt,
but fhe child is so small that the shoulder belt is
’very close to the child’s face or neck?
A: Move the child toward the center of the vehicle, but be
sure that the shoulder belt still is on the child’s shoulder,
so that in a crash the child’s upper body would have the
restraint that
belts provide. If the child is so small that
the shoulder belt
is still very close to the child’s face or
neck, you might want to place
the child in the center seat
position, the one that has only a lap belt.
See “Rear
Safety Cornfort Guides” in the Index.
ProCarManuals.com
Page 69 of 308
Wherever the child sits, the lap portion of the belt
should be worn low and snug on
the hips, just touching
the child’s thighs. This applies belt force to the child’s
pelvic bones
in a crash.
Safety Belt Extender
If the vehicle’s safety belt will fasten around you, you
should use it. The automatic lap-shoulder belt has plenty
of extra length built
in, so it will fasten around almost
all people.
But
if a safety belt isn’t long enough to fasten, your
dealer will order you an extender. It’s free. When you go
in to order it, take the heaviest coat you will wear, so the
extender will
be long enough for you. The extender will
be just for you, and just for the seat
in your vehicle that
you choose. Don’t let someone else use it, and use
it
only for the seat it is made to fit. To wear it, just attach it
to the regular safety belt.
Checking Your Restraint Systems
Now and then, make sure all your belts, buckles, latch
plates, retractors, anchorages and reminder systems are
working properly.
Look for any loose parts or damage.
If you see anything that might keep a restraint system
from doing its job, have
it repaired.
67
ProCarManuals.com
Page 70 of 308
Replacing Safety Belts After a Crash
If you’ve had a crash, do you need new belts?
After a very minor collision, nothing may be necessary.
But if the belts were stretched, as they would be
if worn
during a more severe crash, then you need new belts.
If belts are cut or damaged, replace them. Collision
damage also may mean you will need
to have safety belt
or seat parts repaired or replaced. New parts and repairs
may be necessary even if
the belt wasn’t being used at
the time
of the collision.
@’ What’s wrong with this?
A: The belt is torn.
Torn
or frayed belts may not protect you in a crash.
They can rip apart under impact forces.
If a belt is torn
or frayed, get a new one right away.
68
ProCarManuals.com