CHEVROLET ASTRO 1997 2.G User Guide

Downloaded from www.Manualslib.com manuals search engine Manual Lumbar Support (If Equipped) Power Seats (If Equipped)
If you have this feature, there will be a control pad on the
inboard side
of the driver and passenger bucket seats.
If you have this feature, there will be a
knob on the
inboard side
of the driver and passenger bucket seats.
Turn the knob toward the front
of the vehicle to increase
lumbar support. Turn the knob toward the rear
of the
vehicle to decrease lumbar support. The
front control makes the front
of the seat go up
and down.
The rear control makes
the rear of the seat go up
and down.
The center control makes the whole seat
go forward,
rearward, up or down.
1-3

Downloaded from www.Manualslib.com manuals search engine Reclining Seatbacks
There is a lever on the inside of the seat to adjust the seatback.
You can adjust the seatback
by lifting the lever. Release
the lever
to lock the seatback
where you want
it. Pull up
on the lever and the seat will
go to an upright position.
But don’t have
a seatback reclined if your vehicle is moving.
~
Sitting in a reclined position when your vehicle is
in motion can be dangerous. Even if you buckle
CAUTION: (Continued)
1-4

Downloaded from www.Manualslib.com manuals search engine I-
up, your safety belts can’t do their job when
you’re reclined like this. The shoulder belt can’t do its job because it
won’t be against your body. Instead, it
will be in
front of you. In a crash you could
go into it,
receiving neck or other injuries.
The lap belt can’t
do its job either. In a crash the
belt could
go up over your abdomen. The belt
forces would be there, not at your pelvic bones.
This could cause serious internal injuries.
For proper protection when the vehicle is in
motion, have the seatback upright. Then sit well
back in the seat and wear your safety belt properly.
Head Restraints
Head restraints are fixed on some models and adjustable
on others. Slide an adjustable head restraint up or down
so that the top of the restraint is closest to the top of
your ears. This position reduces the chance of a neck
injury
in a crash.
Seatback Latches (Non-Touring
Bench Seats)
The seatback lever is on the right rear of your seat.
To fold your non-touring
seatback forward, pull
up on
the latch release lever while
pulling the seatback toward
the rear of
the vehicle.

Downloaded from www.Manualslib.com manuals search engine After the latch has been released, push the seatback
toward the front
of the vehicle until it locks in place. To
raise the seatback, unlock the seatback latch by pushing
up on the lever while pushing down on the upper edge
of the seatback. Move the seatback into the upright
position. Make sure
the seatback is locked when it is
bacl 1 th lpright position.
A CAUTION:
If the seatback isn’t locked, it could move
forward in
a sudden stop or crash. That could
cause injury to the person sitting there. Always
press rearward
on the seatback to be sure it
is locked.
Rear Seats
A CAUTION:
A seat that isn’t locked into place properly can
move around
in a collision or sudden stop. People
in the vehicle could be injured. Be sure to lock
the seat into place properly when installing it.
A CAUTION:
- I
A safety belt that is twisted or not properly
attached won’t provide the protection needed in
a
crash. The person wearing the belt could be
seriously injured. After installing the seat, always
check to be sure that the safety belts are not
twisted and are properly attached.
1-6

Downloaded from www.Manualslib.com manuals search engine Bucket Seats
If you have rear bucket seats in your vehicle, they will
recline and adjust the same way as the front manual
bucket seats. See “Reclining Seatbacks” earlier
in this
section or
in the Index.
Bench Seats
If you have bench seats in your vehicle, each seat can
carry up to three passengers. They can also be removed
to increase storage space.
The center bench (if not equipped with
a built-in child
restraint) and rear bench seats can be adjusted forward
or rearward by
the lever at the front of the seat. Move
the seat adjustment
lever at the front of the seat
toward the passenger’s side
to unlock it. Slide the seat to
where
you want it. Then
release the lever and try to
move the seat with your
body,
to make sure the seat
is locked into place.
The non-touring center bench seat has
a pivoting
right armrest. The left armrest can also be used as
a
storage compartment.
The optional touring bench seats come with moveable
armrests, individual reclining seatbacks, adjustable
headrests
and a fold-down center console.
1-7

Downloaded from www.Manualslib.com manuals search engine i
To raise or lower the center
console, press the button
between the beverage
holders. Only sit in the
center seating position
when the console is in an
upright position.
For details about headrests, see “Head Restraints”
in
this section.
To adjust your seatback, pull up on the lever on the
lower outside of the seat.
The center bench seatbacks will recline further back
than the rear bench seatbacks.
1-8

Downloaded from www.Manualslib.com manuals search engine Removing the Rear Seats
To remove the rear seats, do the following:
c I TO DETACH
‘1 BELT FOR
SEAT REMOVAL
-9.- I
INSERT KEY , 1
INTO HOLE
AND PUSH I
I I
1 I
1. If you are removing the
center seat, remove the
right lap-shoulder belt.
To do this, press the tip
of a key into the release
hole of the safety belt
attachment while pulling
up on the safety belt.
2. If you have a safety belt
guide on
your seat, pull
the
safety belt all the way
I, out through the guide.
3. Pull up on the seatback latch on the right rear of the
front seat. Push the seatback
down until it locks in
place (non-touring bench seats only).
1-9

Downloaded from www.Manualslib.com manuals search engine 4. Lift up on the left seat release lever, then the right.
The latches
are near the floor on the rear legs of
the seat.
5. Lift up on the rear of the seat to remove the seat
assembly from the rear latch pins. Then, pull back
and lift the seat out of the vehicle.
Your seat release latch lever
is sprung with a
two-stage mechanism.
To fully release the latch, two
levels of lift effort will be required. First, a low effort
to overcome the first stage and then a moderate
effort to fully release the latch.
1-10

Downloaded from www.Manualslib.com manuals search engine Replacing the Rear Seats
To replace the rear seats, do the following:
1. Lower the seat into position. Make sure the front
retainers are hooked onto the anchor pins.
2. Pull the seat down to latch the rear retainers. Make
sure the seat
is locked in by pulling up and down on
the seat.
3. Raise the seatback by pushing forward on the latch at
the right rear of the seat, while pushing down on the
upper edge of the seatback. Pull up on the seatback
until
it is locked securely in the up position.
1-11

Downloaded from www.Manualslib.com manuals search engine 4. If you are replacing the center seat, connect the right
lap-shoulder belt to
the attachment on the seat
cushion. If
you have a safety belt guide on your seat,
pull the belt through
the guide before reattaching the
lap-shoulder belt to the side
of the seat. The release
hole should be facing outward.
If you installed the safety belt with the release hole
facing inward (toward the seat), slide the plastic
cover up
so you can see the buckle. Disconnect the
seat belt. Slide the cover back down and reinstall the
belt correctly.
NOTICE:
Be sure to put the correct seats back in the proper
positions
so the safety belts will work properly.
Safety Belts: They’re for Everyone
This part of the manual tells you how to use safety belts
properly. It also tells
you some things you should not do
with safety belts.
And it explains the Supplemental Inflatable Restraint
(SIR), or air bag system.
Don’t let anyone ride whel he or she can’t wear
a safety belt properly. If you are in a crash and
you’re not wearing
a safety belt, your injuries
can be much worse.
You can hit things inside the
vehicle or be ejected from it.
You can be seriously
injured or killed. In the same crash, you might
not be if you are buckled up. Always fasten your
safety belt, and check that your passengers’ belts
are fastened properly too.
1-12