turn signal CHEVROLET COBALT 2007 1.G Owners Manual

Remote Keyless Entry (RKE)
System Operation
The vehicle’s doors may be locked and
unlocked, and the trunk can be opened from
about 3 feet (1 m) up to 197 feet (60 m) away with
the remote keyless entry transmitter. If your vehicle
has the remote vehicle start feature, you can also
start the vehicle’s engine with the Remote Keyless
Entry (RKE) transmitter.The following functions may be available if your
vehicle has the RKE system./(Remote Vehicle Start):If your vehicle has
this feature, the engine may be started from
outside the vehicle using the RKE transmitter.
See “Remote Vehicle Start” later in this section
for more detailed information.
Q(Lock):Press the lock button to lock all the
doors. The interior lamps will turn off after all of the
doors are closed. If enabled through the Driver
Information Center (DIC), the remote lock feedback
can be programmed to have the horn chirp
and/or the turn signals ash when the RKE
transmitter is used to lock the vehicle’s doors.
See “LOCK HORN” and “LIGHT FLASH” under
DIC Vehicle Personalization on page 186for more
information.
Pressing the lock button may also arm the
content theft-deterrent system. SeeContent
Theft-Deterrent on page 107.
Remote Keyless Entry
with Remote StartRemote Keyless Entry
without Remote Start
92

K(Unlock):Press the unlock button to unlock
the driver’s door. If the button is pressed again
within ve seconds, all remaining doors will unlock.
The interior lamps will turn on and stay on for
20 seconds or until the ignition is turned on. If
enabled through the DIC, the remote unlock
feedback can be programmed to have the horn
chirp and/or the turn signals ash when the RKE
transmitter is used to unlock the vehicle’s doors.
See “UNLOCK HORN” and “LIGHT FLASH” under
DIC Vehicle Personalization on page 186for more
information.
If enabled through the DIC, and it is dark enough
outside, the vehicle’s high-beam headlamps,
parking lamps, and back-up lamps will turn on
each time the unlock button on the transmitter is
pressed. These exterior lamps will stay on for
20 seconds, or until a door is opened. See “EXT
(Exterior) LIGHTS” underDIC Vehicle
Personalization on page 186for additional
information.
Pressing the unlock button on the RKE transmitter
will disarm the content theft-deterrent system. See
Content Theft-Deterrent on page 107.V(Remote Trunk Release):The trunk will
open when this button on the transmitter is pressed
and held for about one second. You can open the
trunk with the transmitter when the vehicle speed is
less than 2 mph (3 km/h), when the ignition is off, or
when the vehicle shift lever is in PARK (P), if your
vehicle has an automatic transaxle.
L(Vehicle Locator/Panic Alarm):This button
may be used to locate your vehicle. Press and
release this button to initiate vehicle locate. The
horn will sound three times and the headlamps
and turn signals will ash three times. Press and
hold the button for about three seconds to initiate
the panic alarm. The horn will sound and the
headlamps and turn signals will ash for
30 seconds. Press the button again to cancel
the panic alarm.
93

To start the vehicle using the remote start feature,
do the following:
1. Aim the transmitter at the vehicle.
2. Press and release the transmitter’s lock
button, then immediately press and hold
the transmitter’s remote start button until the
vehicle’s turn signal lamps ash.
When the vehicle starts, the parking lamps will
turn on and remain on while the engine is
running.
3. If it is the rst remote start since the vehicle
has been driven, repeat these steps, while
the engine is running, to extend the time by
10 minutes for the engine to continue to run.
After entering the vehicle after a remote start,
insert and turn the key to RUN to drive the vehicle.
The engine will shut off automatically after
10 minutes, unless a time extension has been
done or the vehicle’s key is inserted into the
ignition switch and turned to RUN.To manually shut off a remote start, do any of the
following. The parking lamps will turn off to
indicate the engine is off.
Aim the RKE transmitter at the vehicle and
press and release the remote start button.
Turn on the hazard warning ashers.
Turn the ignition switch to RUN and
then LOCK.
Your vehicle’s engine can be started two times,
per ignition cycle, using the transmitter’s remote
start feature.
If the remote start procedure is used again before
the rst 10 minute time frame has ended, the
rst 10 minutes will immediately expire and
the second 10 minute time frame will start.
96

Power Door Locks
Your vehicle may have
power door locks.
The locks are located
on the driver’s and
front passenger’s
door armrest.
Press the side of the switch with the lock symbol
to lock the doors. This is the right side for the
driver’s switch and the left side for the front
passenger’s switch.
Press the side of the switch with the unlock
symbol to unlock the doors. This is the left side
for the driver’s switch and the right side for
the front passenger’s switch.
Delayed Locking
If your vehicle has power locks, it will have the
delayed locking feature.
This feature will delay the actual locking of the
doors for up to ve seconds when the power door
lock switch or remote keyless entry transmitter
is used to lock the vehicle.
If any door is open when locking the vehicle,
three chimes will sound signaling that the delayed
locking feature is active. Five seconds after the
last door is closed, all of the doors will lock and the
turn signal lamps will ash. To cancel the delay
and lock the doors immediately, press the
lock button a second time.
This feature will not lock the doors if the key is in
the ignition.
You can disable this function through the Driver
Information Center (DIC). SeeDIC Vehicle
Personalization on page 186.
Driver’s Switch shown,
Front Passenger’s
Switch similar
99

Instrument Panel Overview........................ 142
Hazard Warning Flashers.......................... 144
Other Warning Devices............................. 144
Horn.......................................................... 144
Tilt Wheel.................................................. 145
Turn Signal/Multifunction Lever.................. 145
Turn and Lane-Change Signals................. 146
Headlamp High/Low-Beam Changer.......... 146
Flash-to-Pass............................................ 146
Windshield Wipers..................................... 147
Windshield Washer.................................... 148
Cruise Control........................................... 149
Headlamps................................................ 152
Wiper Activated Headlamps....................... 153
Headlamps on Reminder........................... 153
Daytime Running Lamps (DRL)................. 153
Fog Lamps................................................ 154
Instrument Panel Brightness...................... 154
Dome Lamp.............................................. 155
Entry/Exit Lighting...................................... 155
Mirror Reading Lamps............................... 155
Electric Power Management...................... 155
Battery Run-Down Protection..................... 156
Accessory Power Outlet(s)........................ 156
Ashtray(s) and Cigarette Lighter................ 157Climate Controls......................................... 158
Climate Control System............................. 158
Outlet Adjustment...................................... 161
Passenger Compartment Air Filter............. 162
Warning Lights, Gages, and Indicators..... 164
Instrument Panel Cluster........................... 165
Speedometer and Odometer...................... 166
Tachometer............................................... 166
Safety Belt Reminder Light........................ 166
Passenger Safety Belt Reminder Light....... 167
Airbag Readiness Light............................. 167
Passenger Airbag Status Indicator............. 168
Charging System Light.............................. 170
Up-Shift Light............................................ 171
Brake System Warning Light..................... 171
Anti-Lock Brake System Warning Light...... 172
Enhanced Traction System
Warning Light......................................... 173
Engine Coolant Temperature
Warning Light........................................ 174
Malfunction Indicator Lamp........................ 174
Oil Pressure Light..................................... 178
Security Light............................................ 179
Fog Lamp Light......................................... 179
Section 3 Instrument Panel
139

The main components of your instrument panel are the following:
A. Side Window Outlets. SeeClimate Control
System on page 158.
B. Air Outlets. SeeOutlet Adjustment on
page 161.
C. Turn Signal/Multifunction Lever. SeeTurn
Signal/Multifunction Lever on page 145.
D. Cruise Control Buttons (If Equipped) and
Driver Information Control Buttons. SeeCruise
Control on page 149andDriver Information
Center (DIC) on page 181.
E. Instrument Panel Cluster. SeeInstrument
Panel Cluster on page 165
F. Audio Steering Wheel Controls (If Equipped).
SeeAudio Steering Wheel Controls on
page 222.
G. Hazard Warning Flashers Button. SeeHazard
Warning Flashers on page 144.
H. Windshield Wiper/Washer Controls. See
Windshield Wipers on page 147andWindshield
Washer on page 148.
I. Audio System. SeeAudio System(s) on
page 192.J. Fog Lamp Button (If Equipped). SeeFog
Lamps on page 154.
K. Trunk Release. SeeTrunk on page 102.
L. Instrument Panel Brightness Control. See
Instrument Panel Brightness on page 154.
M. Horn. SeeHorn on page 144.
N. Cigarette Lighter (If Equipped). SeeAshtray(s)
and Cigarette Lighter on page 157.
O. Shift Lever (Manual Shown). SeeManual
Transaxle Operation on page 121and
Automatic Transaxle Operation on page 118.
P. Climate Controls. SeeClimate Control System
on page 158.
Q. Passenger Air Bag Status Indicator and Heated
Seats Button (If Equipped). SeePassenger
Airbag Status Indicator on page 168and
Heated Seats on page 11.
R. Glove Box. SeeGlove Box on page 136.
143

Hazard Warning Flashers
The hazard warning ashers let you warn the
police and others that you have a problem.
The front and rear turn signal lamps will ash
on and off.
The hazard warning
asher button is located
in the center of the
instrument panel.
Press the button to make the front and rear turn
signal lamps ash on and off. Press the button
again to turn the ashers off.While the hazard warning ashers are on, the turn
signals do not work.
The hazard warning ashers work no matter what
position the key is in, and even if the key is not
in the ignition switch.
Other Warning Devices
If you carry reective triangles, you can set them
up at the side of the road about 300 feet (100 m)
behind your vehicle.
Horn
To sound the horn, press the center pad on the
steering wheel.
144

Tilt Wheel
A tilt wheel allows you to adjust the steering wheel
before you drive. You can raise the steering wheel
to the highest level to give your legs more room
when you enter and exit the vehicle.
The lever that allows you to tilt the steering wheel
is located on the left side of the steering column.
To tilt the wheel, pull down the lever. Then move
the wheel to a comfortable position, pull up
the lever to lock the wheel in place.
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
GTurn and Lane-Change Signals. See
Turn and Lane-Change Signals on page 146.
53Headlamp High/Low-Beam Changer.
SeeHeadlamp High/Low-Beam Changer on
page 146.
Flash-to-Pass. SeeFlash-to-Pass on page 146.
OExterior Lamp Control. SeeHeadlamps on
page 152.
145

Turn and Lane-Change Signals
The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up
or down. When the turn is nished, the lever will
return automatically.
An arrow on the
instrument panel
cluster will ash in the
direction of the turn
or lane change.
To signal a lane change, raise or lower the lever
until the arrow starts to ash. Hold it there until you
complete your lane change. The lever will return
by itself when you release it.
As you signal a turn or a lane change, if the arrows
ash rapidly, a signal bulb may be burned out and
other drivers will not see your turn signal. If a bulb is
burned out, replace it to help avoid an accident.If the arrows do not go on at all when you signal a
turn, check the fuse. SeeFuses and Circuit
Breakers on page 384.
Headlamp High/Low-Beam Changer
To change the headlamps from low beam to high
beam, push the turn signal lever away from you.
When the high beams
are on, this light on
the instrument panel
cluster will also be on.
To change the headlamps from high beam to low
beam, pull the turn signal lever toward you.
Flash-to-Pass
This feature lets you use your high-beam
headlamps to signal a driver in front of you
that you want to pass.
To use it, pull the turn signal/multifunction lever
toward you until the high-beam headlamps
come on, then release the lever to turn them off.
146

UNLOCK HORN
If your vehicle has Remote Keyless Entry (RKE),
this feature, which allows the vehicle’s horn to
chirp on the rst press of the unlock button on
the RKE transmitter, can be enabled or disabled.
When UNLOCK HORN appears on the display,
press and hold the reset button for at least
one second to scroll through the available settings:
OFF (default):The horn will not chirp when the
unlock button on the RKE transmitter is pressed.
ON:The horn will chirp on the rst press of
the unlock button on the RKE transmitter.
SeeRemote Keyless Entry (RKE) System
Operation on page 92for more information.
Choose one of the available settings and press
the information button to select it and move on to
the next feature.
LIGHT FLASH
If your vehicle has Remote Keyless Entry (RKE),
this feature, which allows the vehicle’s exterior
hazard/turn signal lighting to ash every time
the lock, unlock, or trunk release buttons on the
RKE transmitter are pressed, can be enabled
or disabled. When LIGHT FLASH appears on the
display, press and hold the reset button for at
least one second to scroll through the available
settings:
OFF:The exterior hazard/turn signal lighting will
not ash when the lock, unlock, or trunk release
buttons on the RKE transmitter are pressed.
ON (default):The exterior hazard/turn signal
lighting will ash when the lock, unlock, or trunk
release buttons on the RKE transmitter are
pressed.
SeeRemote Keyless Entry (RKE) System
Operation on page 92for more information.
Choose one of the available settings and press
the information button to select it and move on to
the next feature.
189