door lock CHEVROLET CORVETTE 1993 4.G Owners Manual
Page 12 of 370
Downloaded from www.Manualslib.com manuals search engine These are some of the symbols you will
find on your vehicle. For example, these
symboJs are used on an original battery:
Caution Possible injury
Protect Eyes by Shielding
Caustic Battery Acid
Could Cause Burns
Avoid Sparks or Flames Spark or Flame Could Explode Battery
These symbols are important for you These symbols have to do with yow
and your passengers whenever your lights:
vehicle is driven:
Fasten Safety Belts
Door LocklUnlock 1 Master Lighting Switch
Turn
.--a Signal Direction
Hazard Warning flashers
Headlight High
Beam
Parking Lights
Fog Lamps
Page 24 of 370
Downloaded from www.Manualslib.com manuals search engine T
T
Driver Position
This section describes the driver's
restraint
system.
LapShoufrter Belt
The driver has alap-shoulder bdt.
Here's
how to wear' it properly.
1. Close and lock the door.
2. Adjust the seat (to see h-ow, see the
Index urider Seat C~ntrols) so you
can sit up straight.
3. Pick up the latch plate and pull the
al belt across you. Don't let it get
twisted.
until it clicks.
4. Push the latch plate into the buckle
If the belt isn't long enough, see the
Index under Safety Belt Extender.
Make sure the release button on the
budkle faces ypward or outward so YOU
would be able to unbudlde. it -quickly if
you ever had to.
Page 43 of 370
Downloaded from www.Manualslib.com manuals search engine Features & Controls
Keys The ignition keys are for the ignition
Ody.
The door keys are for the doors anddl
other locks, except the. engine power
switch (if you have a ZR-1) which uses
a third key.
When a new Corvette'is delivered, the.
dealer removes the plugs
from the keys,
and gives them to the-first owner.
However, the ignition key may not have
a plug.
Each
plug has a code on it that tells
your dealer or a qualified locksmith
how to make extra keys. Keep the plugs
' in a safe piace. If you lose your-.keys,
you'll be able to have new ones made
easily using these.plugs. If your ignition
keys dodt have plugs, go to your
Chevrolet dealer for the correct key
code if you need a new.ignition key.
I NOTICE
P
c
Page 44 of 370
Downloaded from www.Manualslib.com manuals search engine ,F
i
l Door Locks b
1"
I
rhere are several ways to locls: and
unlock your vehicle.
From the Outside:
Use your door key or the Passive
Keyless
Entry transmitter.
If your theft deterrent system is armed,
unlock the doors only with the key or
Passive Keyless Entry system. This wizl
avoid setting off the alarm.
To lock the doors with the Passive
Keyless Entry system, take the
transmitter .out of range-after five
seconds, the doors will lock and the
horn will sound once. To unlock the
doors, move the transmitter back into
vehicle range. See the Index under
Passive Keyless Entry System.
I
. . ._ -. -
From the Inside:
Tollock the door, slide the lock control
on the door rearward.
To unlock the door, slide the lock
control on the door forward.
Page 45 of 370
Downloaded from www.Manualslib.com manuals search engine Features & Controls
4
Power Door Locks
With power door locks, ,you can lock or
unlock both doors-.of your vehicle from
the driver or-passenger door lock switch.
Slide the power door
lock switch
reaward to lock the doors. Slide the
switch €ornard to unlock the doors.
Leaving Your Vehicle
If you are leaving,the vehicle, open your
door and set the lucks from inside. Then
get out and close the door.
Your vehicle has a thee detefrent
system. See- the
index uader Unzversal
Theft Deterrent.
I4
Passive KeyEess Entry System
Your Passive Keyless Entry system
operates on a radio frequency subject to
Federal Communications Commission (FCC)
Rules.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This
device may not cause- harmful
interfejrence,
and (2) This device must
accept any interference received,
including interference that
may cause
undesired operation. Should interference
to
this system
occur, try
this:
Check to:see if the passive feature is
enabled.
Check the distance. You may be too
far lrom your vehicle. This product
has a maximum range.
Check the location. Other vehicles or
objects-may be blocking the signal.
Check to determine if battery
replacement is. necessary.
See the
instructioas .on battery replacement
later in this section.
See your Chevrolet dealer 6r.a
qualified technician
for service.
Changes or modifications td this system
by other than an authorized service
facility could void authorization to use
this .equipment.
Page 46 of 370
Downloaded from www.Manualslib.com manuals search engine .F
i
i+ i,
.e
i 1
r I .,
Passive Keyless .Entry Description
The Passive Keyless-Entry system, or
PKE, on your Corvette is a new
approach2o remote keyless entry.
Unlike other systems, PKE requires no
specific .action from the operator ,to
unlock
or lock the dams. When the
passive kature
is er;abled, simply
approach the vehide with
the .PKE
trinsmitter-the system automatically
disarms
your vehicle's theft deterrent
system and unlocks either the driver's
door or both doors (depending on
which unlock mode it is in). Move back
aut
-of range, and P-KE locks all the
doas and arms the theft deterrent
system. The Passive Keyless
Entry system also
has other useful features. The passenger
- door can be unlocked by pressing. the
DOOR button
on the transmitter. On
the. coupe, the hatch can be openqd ley
pressing the HATCH button on the
transmitter.
In addition to these
features, there
is a special function that
prevents
thekeys from being locked in
the vehicle while they are in the
ignition.
Your Corvette comes equipped from the
facbry with one transmitter. Additional
transmitters,
if desired, .may be
purchased though your dealer. Each
transmitter is co-ded for. secu-rity, and
must be ,programmed to yow vehicle
before
it is used. See Programming
Transmitters laterin this section,
Page 48 of 370
Downloaded from www.Manualslib.com manuals search engine i"" V'
r"
Transmitter Range Suggestions:
The range of the Passive Keyless
EMry system is very dependent on
bow
the transmitter is held. For
opthum range hd performance,
hold the transmitter
vertically when
approaching the vehicle.
If the range gradually decreases over
time even though the transiitter is
held
vertically, change the battery in
the transmitter.
The range will decrease if mure than
one3ransmitter is in range at the same
time.
Avoid taking more than one-
transmitter into vehicle range at the
same time.
Do not put the transmitter into a
metal container, which
will prevent
the
.signal from getting- to the vehicle.
hen you move the transmitter into
vehicle range, the
theft deterrent system
automatically disengages and the
driver's door automatically unlocks.
When you move the transmitter out of
vehide range with the' do.ors closed and
the
key out af the ignition, the system
will automatically:
Lock both .dooxs after -a five-second
Immediately arm the theft deterrent
Sound the horn once to signal that
Turn-off the interior lights.
delay.
system.
the doors are locked.
The theft deterrent system will still
operate using the .pma d0.w lock. See
the Index under .Universal The#?
DeZerrenzt.
You mEQT also Llnbclr the passenger
door by pressing the-DOOR-buttoil Qn
the transmitter, and the hatch by
pressing the HATCH button, but only
when the ignition is off.
Page 49 of 370
Downloaded from www.Manualslib.com manuals search engine Features & Controls
Passive Keyless Entry Settings
With Passive Keyless Entry, you am use-
the
system to operate both doors, or'
only the driver's door. You can also
choose to disable the system, ifthere are
times when. you would prefer .not to use
Passive Keyless Entry.
To Sdtch Dbor Settings:
To switch the: setting, from automatically
locking
.and unlocking the .driver's door
to autom,atically iocling: and unlocking
both doors:
1. Insert the ignition key, but leave the
ipition
off.
2. With the transmitter in range, hold.
the. DOOR, button for more than two
seconds. The system.wil1 then cycle
the doox. locks.
3. To switch back, repeat steps I; and 2.
Turning the Passive Keyless Entry
System Off
1, Take the keys out of the-ignition.
2. Hold the DOOR button on the
tramrnitter for longer than two
seconds.
3: The: system will sfgnal the shut-off by
cycling the locks from lock to unlock.
T.0 make sure the PKE system is off,
turn the ignition on and look for the
PASSIVE KEYLESS ENTRY hght
on the Driver Information Center. If
the PKE system Is on, the light will
come on for-two seconds. If the
systemis off, the light will not come
on. When
the system is off or me
transmitter is left
at home, none of the
Passive
Keyless. Entry features work.
But you will still be able to work the
manual
and power locks, and arm the
theft deterrent system. See the Index
'under Door Lacks, .Power Door Locks
and Univerml Theft Deterrent.
.. . -
-
Page 50 of 370
Downloaded from www.Manualslib.com manuals search engine Iy
If you are working around your Corvette
and are- keeping your keys with you,
you rnight want to turn the Passive
Keyless Entry system off to prevent the
transmitter
from activating the locks.
You also might want to turn the system
off if you have a passenger remaining in
the vehicle. If the passenger leaves the
vehicle with the dm arme.d, he or she
might
set it off.
Enabling the Passive Keyless Entry
System:
To turn .the Passive Keyless Entry
system: on again, simply follow steps 1
through 3'under Turning the- Passive:
Keyless Entry System Off.
There-are two ways to make sure that
the passive feature is on. Either turn- the
ignition on and check to see' that the
PASSTvlE KE%LESS ENTRY light on
the Driver Infomation Center comes
on-for two seconds, or shut the doors.
and walk away from the vehicle with
the keys and transmitter. If the PKE
system is on,.the doors.will lock.
Passive Keyless Entry Safety
Features
This system makes it d.Scult for you to
lock-your keys in the vehicle. If the keys
are left In the ignition and you lock-the
doors, the system dl1 automatically
unlock the doors as
soon as they close.
Also, this system will not lock the doot
&er the transmitter has moved out of
range until the key is removed from the
ignition and the.-driver's
door has been
opened. When using this system, you.
should become aware of the:ham ale-rt
once the doors
lock automatically. If
you have left your keys. in the ignition,
the horn will .not souhd. Be sure to, lock
the doors ,once- you have removed the
key
from the ignition.
Page 51 of 370
Downloaded from www.Manualslib.com manuals search engine Features & Controls
Passive Keyless Enfry Safety
Features (CONT.)
If you have your keys and the h.om does
not sound, check to see’if the passive.
feature is.enabled.
If the system is
enabled and the horn still won’t sound,
see your dealer for -assistance.
The transmitter
shuts down after 21
seconds without movement to
maximize battery life. If. you’ve lpclted
your keys in the vehicle, but didn’t leave
them
in the ignition, wait 25 seconds,
then rock the vehicle.
A motion
detector inside the. transmitter
will send
a si-gnal to “wake up’’ the vehicle, which
will then unlock the doors.
It is still possible to lock your lreys in
the vehicle if the transmitter’s battery is
low, or if it is in a location where a
signal
can’t be received, .For your
convenience, a€ways take your keys
with.you.
io
-Matching Transmitter(§) to Your
Vehicle
Your Corvette comes equipped from the
-factory with one Passive
Keyless Entry
system transmitter. Additional
transmitters
may be purchased through
your- dealer. Each Bey chain transmitter
is coded to prevent
another transmitter
from unlocking
your vehicle. If a
transmitter is lost or stolen, a
replacement
can be purchasdthrough
your dealer. Remember to bring the-
remaining. transmitter
(s) with you when
you
go to your dealer. When the dealer
matches the replacement transmitter
to
your vehicle, the remaining
transmitter(s)
must aIso be matched.
‘Once the new transmitter
is coded, the
lost transmitter will not unlock your
vehicle.
Programming Transmiff ers
The Passive Keyless Entry system
allows up to thee transmitters
to be
matched to
your Corvette. Each
transmitter has its
own code. To
operate with your~particular vehicle, the
code needs
to be programmed into the
system.
To Engage the Pmgramming Mode:
1 I Move all transmitters out of range.
2. Turn.the ignition key on.
3. Push the TRIP ODO button on the
Driver Information Center twice.
4. Within five seconds, press and hold
the FUEL INFO button on the
Driver Inforfiation Center until the
PASSIVE KEYLESS ENTRY light
comes on and stays on. --
5. Turn the ignition key to the Off
position, but leave the key in the
ignitiofi..