heater CHRYSLER PACIFICA 2005 1.G Owners Manual
Page 202 of 376
key is turned “ON”. The frequent use of outside air will
help keep odors from building up within the air
conditioner-heater housing. It is recommended that the
recirculation mode be used as little as possible, especially
in humid climates.
For hot and dry climates, or people who are allergic to
pollen and find frequent use of the recirculation mode
necessary, the recirculation mode can be programmed to
not automatically reset to the outside mode by using the
following procedures:
•Turn the ignition switch to the OFF position.
•Press and hold the recirculation button.
•While holding the recirculation button, turn the igni-
tion switch to the “RUN” position.
•Continue holding the recirculation button for 4 sec-
onds, then release.The recirculation control is now programmed so that the
recirculation mode willnotreset to the outside air mode
when the engine is restarted. The recirculation program-
ming can be changed back by repeating this procedure.
Rear Fan Operation
To operate the rear fan, press theREARbutton. The first
time this button is pressed theREAR AUTOdisplay
will illuminate indicating that the rear fan speed is
automatically controlled. To manually control the rear
fan speed, press theREARbutton again and only
REARwill illuminate in the display. This allows the rear
seat occupants to control the rear fan speed using the
switch located in the center console between the second
row seats. By pressing theREARbutton a third time,
the rear fan will shut off.
202 UNDERSTANDING YOUR INSTRUMENT PANEL
Page 203 of 376
When the ATC display readsREAR AUTOor when the
rear fan is off, the switch located in the center console
between the second row seats is not functional. When the
ATC display readsREAR, only the rear seat occupants
can control the rear fan speed from the rear switch. When
in the “REAR” mode, the rear occupants can set the rear
switch to any fan speed includingOFF,orAUTO.
While in theAUTOposition, the rear fan speed will be
automatically controlled.
Summer Operation
The engine cooling system in air conditioned vehicles
must be protected with a high-quality antifreeze coolant
to provide proper corrosion protection and to protect
against engine overheating. A 50% solution of ethylene
glycol antifreeze coolant in water is recommended. Refer
to section 7, Maintenance Procedures, of this manual for
proper coolant selection.
Winter Operation
To insure the best possible heater and defroster perfor-
mance, make sure the engine cooling system is function-
ing properly and the proper amount, type, and concen-
tration of coolant is used. Refer to section 7, Maintenance
Procedures, of this manual for proper coolant selection.
Use of the air Recirculation mode during winter months
is not recommended because it may cause window
fogging.
Vacation Storage
Anytime you store your vehicle, or keep it out of service
(i.e. vacation) for two weeks or more, run the air condi-
tioning system at idle for about five minutes in the fresh
air and high blower setting. This will insure adequate
system lubrication to minimize the possibility of com-
pressor damage when the system is started again.
UNDERSTANDING YOUR INSTRUMENT PANEL 203
4
Page 207 of 376
STARTING AND OPERATING
CONTENTS
Starting Procedures.....................210
▫Normal Starting......................210
Engine Block Heater — If Equipped.........212
Automatic Transmission..................213
▫Brake/Transmission Interlock System.......213
▫Automatic Transmission Ignition Interlock
System.............................214
▫Four Speed Automatic Transmission........214
AutoStick............................216▫AutoStick Operation...................216
▫AutoStick General Information............216
All Wheel Drive — If Equipped............217
Parking Brake.........................218
Brake System..........................219
▫Anti-Lock Brake System................220
Power Steering........................222
Traction Control — If Equipped............223
Tire Safety Information...................224
5
Page 210 of 376
STARTING PROCEDURES
CAUTION!
Long periods of engine idling, especially at high
engine speeds, can cause excessive exhaust tempera-
tures which can damage your vehicle. Do not leave
your vehicle unattended with the engine running.
WARNING!
Do not leave animals or children inside parked
vehicles in hot weather; interior heat build up may
cause serious injury or death.
The gear selector must be in the NEUTRAL or PARK
position before you can start the engine. Apply the brakes
before shifting into any driving gear.
Normal Starting
Normal Startingof either a cold or a warm engine is
obtained without pumping or depressing the accelerator
pedal. Turn the key to the “START” position and release
when the engine starts. If the engine has not started
within 3 seconds, slightly depress the accelerator pedal
while continuing to crank. If the engine fails to start
within 15 seconds, turn the key to the “OFF” position,
wait 10 to 15 seconds, then repeat the normal starting
procedure.
Extremely Cold Weather(below29°C or20°F) To
insure reliable starting at these temperatures, use of an
externally powered electric engine block heater (available
from your dealer) is recommended.
210 STARTING AND OPERATING
Page 212 of 376
If the engine shows no sign of starting after two 15
second periods of cranking with the accelerator pedal
held to the floor, the “NORMAL STARTING” procedure
should be repeated.
After Starting
The idle speed will automatically decrease as the engine
warms up.
ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms engine coolant and
permits quicker starts in cold weather. Connect the cord
to a standard 110-115 volt AC electrical outlet with a
grounded, three-wire extension cord.The engine block heater cord is routed under the hood on
the driver side of the vehicle. It has a removable cap that
is located on the driver side of the Integrated Power
Module.
WARNING!
Remember to disconnect the cord before driving.
Damage to the 110-115 volt electrical cord could
cause electrocution.
212 STARTING AND OPERATING
Page 263 of 376
IF YOUR ENGINE OVERHEATS
In any of the following situations, you can reduce the
potential for overheating by taking the appropriate ac-
tion.
•On the highways — Slow down.
•In city traffic — While stopped, put transmission in
neutral, but do not increase engine idle speed.
NOTE:There are steps that you can take to slow down
an impending overheat condition. If your air conditioner
is on, turn it off. The air conditioning system adds heat to
the engine cooling system and turning off the A/C
removes this heat. You can also turn the Temperature
control to maximum heat, the Mode control to floor, and
the fan control to High. This allows the heater core to act
as a supplement to the radiator and aids in removing heat
from the engine cooling system.
CAUTION!
Driving with a hot cooling system could damage
your vehicle. If temperature gauge reads “H”, pull
over and stop the vehicle. Idle the vehicle with the
air conditioner turned off until the pointer drops
back into the normal range. If the pointer remains on
the “H”, turn the engine off immediately, and call for
service.
WHAT TO DO IN EMERGENCIES 263
6
Page 271 of 376
WARNING!
•Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic trans-
mission cannot be started this way. Unburned fuel
could enter the catalytic converter and once the
engine has started, ignite and damage the converter
and vehicle. If the vehicle has a discharged battery,
booster cables may be used to obtain a start from
another vehicle. This type of start can be dangerous
if done improperly, so follow this procedure care-
fully.
•Battery fluid is a corrosive acid solution; do not
allow battery fluid to contact eyes, skin or clothing.
Don’t lean over battery when attaching clamps or
allow the clamps to touch each other. If acid splashes
in eyes or on skin, flush contaminated area immedi-
ately with large quantities of water.
•A battery generates hydrogen gas which is flam-
mable and explosive. Keep flame or spark away from
the vent holes. Do not use a booster battery or any
other booster source with an output that exceeds 12
volts.
1. Wear eye protection and remove any metal jewelry
such as watch bands or bracelets that might make an
inadvertent electrical contact.
2. When boost is provided by a battery in another
vehicle, park that vehicle within booster cable reach and
without letting the vehicles touch. Set the parking brake,
place the automatic transmission in PARK and turn the
ignition switch to the OFF position for both vehicles.
3. Turn off the heater, radio and all unnecessary electrical
loads.
4. Connect one end of a jumper cable to the positive
terminal of the discharged battery. Connect the other end
of the same cable to the positive terminal of the booster
battery.
WHAT TO DO IN EMERGENCIES 271
6
Page 325 of 376
FLUIDS AND CAPACITIES
U.S. Metric
Fuel (approximate) 89
Octane23 gallons 87 liters
Engine Oil-With Filter
3.5 Liter Engines (SAE 10W-30, API Certified) 5.5 qts 5.2 liters
Cooling System *
3.5 Liter Engines (MoparAntifreeze/Coolant 5 Year/100,000
Mile Formula)10.5 qts 9.9 liters
* Includes heater and coolant recovery bottle filled to MAX level.
MAINTAINING YOUR VEHICLE 325
7
Page 364 of 376
Block Heater......................... 212
Break-In Recommendations................ 59
Checking Oil Level..................... 284
Compartment......................... 280
Coolant............................. 326
Cooling............................. 298
Exhaust Gas Caution..................29,251
Fails to Start.......................... 211
Fuel Requirements..................248,325
Oil ...........................284,325,326
Oil Change Interval.................... 286
Oil Selection.......................286,325
Oil Synthetic......................... 288
Overheating.......................... 263
Temperature Gauge..................... 144
Engine Oil Viscosity Chart................. 287
Exhaust Gas Caution..............29,60,251,298
Exhaust System......................... 297
Extender, Seat Belt........................ 41Exterior Folding Mirrors................... 68
Filters
Air Cleaner.......................... 289
Air Conditioning....................204,294
Automatic Transaxle.................... 309
Engine Fuel.......................... 289
Engine Oil........................288,326
Engine Oil Disposal.................... 288
Flashers
Hazard Warning....................... 262
Turn Signal.....................145,322,324
Floor Console.......................... 133
Fluid Capacities......................... 325
Fluid Leaks............................. 62
Fluid Level Checks
Automatic Transaxle.................... 308
Brake............................... 327
Power Steering.....................294,327
364 INDEX
Page 366 of 376
Head Phones........................... 183
Head Restraints.......................... 94
Headlights............................ 322
Bulb Replacement...................... 321
High Beam........................... 113
High Beam/Low Beam Select Switch........ 113
Passing............................. 113
Replacing............................ 321
Switch.............................. 110
Time Delay........................... 111
Heated Seats............................ 94
Heater, Engine Block..................... 212
Holder, Cup........................... 133
Homelink Transmitter.................... 123
Hood Release.......................... 107
Hoses.............................303,306
Ignition
Key ................................. 11Illuminated Entry........................ 15
Immobilizer............................ 12
Indicator, Traction Control................. 147
Infant Restraint.......................... 55
Information Center, Vehicle................. 151
Instrument Cluster....................143,144
Instrument Panel and Controls.............. 142
Instrument Panel Lens Cleaning............. 315
Integrated Power Module.................. 316
Interior Appearance Care.................. 314
Interior Fuses.......................... 316
Interior Lights.......................109,110
Intermittent Wipers...................... 114
Introduction............................. 4
Jack Location........................... 265
Jack Operation.......................264,267
Jacking Instructions...................... 267
Jump Starting.......................... 270
366 INDEX