CHRYSLER PT CRUISER 2007 1.G Owners Manual

Driver’s Seat Back Tilt—If Equipped
How to operate the driver’s seat:
1. Push the lever down until seat back releases.
2. Push the seat back forward.
3. To return seat to a sitting position, push seat back
rearward.
NOTE:The driver’s front seat has a full recliner
memory, which will allow the seat back to return to its
original position.
Passenger Seat Back Tilt (Easy Entry System)
(Convertible)
How to operate the passenger front seat:
1. Push the lever down until seat back releases.
Driver’s Seat Back Tilt Lever
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 161
3

2. Push seat back forward until it slides toward the
dashboard.
3. To return seat to a sitting position, rotate seat back
upright until it locks.4. Push seat rearward until the track locks.
NOTE:The passenger front seat has a full recliner
memory, which will allow the seat back to returned to its
original position.
NOTE:The passenger front seat has a track memory,
which returns the seat to just past the half way point of
the track regardless of original position.
Adjustable Head Restraints
Head restraints can reduce the risk of whiplash injury in
the event of impact from the rear. Pull up or push down
on the head restraints so that the upper edge is as high as
practical. To raise the head restraint, pull up on the head
restraint. To lower the head restraint, depress the button
and push down on the head restraint.
Passenger Seat Back Tilt Lever
162 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Heated Seats — If Equipped
WARNING!
Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabetes,
spinal cord injury, medication, alcohol use, exhaus-
tion or other physical condition must exercise care
when using the seat heater. It may cause burns even
at low temperatures, especially if used for long
periods of time. Do not place anything on the seat
that insulates against heat, such as a blanket or
cushion. This may cause the seat heater to overheat.
Adjustable Head Restraints
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 163
3

This feature heats the front driver’s and passenger’s
seats. The control for the heater is located on the instru-
ment panel, below the radio. After turning on the igni-
tion, you may choose OFF, HIGH, or LOW heat settings.
An indicator on the switch shows which setting has been
chosen.
Pressing the switch once will select high-level
heating. Pressing the switch a second time will
select low-level heating. Pressing the switch a
third time will shut the heating elements off.When high-temperature heating is selected, the heaters
provide a boosted heat level during the first four minutes
of operation after heating is activated. The heat output
then drops to the normal high-temperature level. If
high-level heating is selected, the system will automati-
cally switch to the low level after about 30 minutes of
continuous operation. At that time, the number of illu-
minated LEDs changes from two to one, indicating the
change. Operation on the low setting also turns off
automatically after about 30 minutes of continuous op-
eration.
NOTE:Once a heat setting is selected, heat will be felt
within 2 to 3 minutes.
Heated Seat Switches
164 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Folding Rear Seat (Sedan)
To provide additional storage area, each rear seatback can
be folded forward. Push and hold the buttons shown in
the picture to fold down either or both seatbacks.WARNING!
•It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision,
people riding in these areas are more likely to be
seriously injured or killed.
•Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat
belts
•Be sure that everyone in your vehicle is in a seat
and using a seat belt properly.
NOTE:
•If the rear center lap/shoulder belt appears to be
locked into place, check to verify that the seatback is
fully latched.
Folding Rear Seat Button
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 165
3

•If the seatback is properly latched and the rear center
lap/shoulder belt still does not operate properly check
and see if the Automatic Locking retractor (ALR)
system is activated.
WARNING!
The rear center lap/shoulder belt is equipped with a
lock-out feature to ensure that the seatback is in the
fully upright and locked position when occupied. If
the rear seatback is not fully upright and locked and
the rear center lap/shoulder belt can be pulled out of
the retractor, the vehicle should immediately be
taken to your dealer for service. Failure to follow this
warning could result in serious or fatal injury.
Folding Rear Seat (Convertible)
To provide additional storage area, each rear seatback can
be folded forward. The seat back release knobs are
located in the trunk area. Pull the left side seatback
release knob to fold down the left side seatback. Pull the
right side seatback release knob to fold down the right
side seatback.
166 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!
•It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision,
people riding in these areas are more likely to be
seriously injured or killed.
•Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat
belts.
•Be sure that everyone in your vehicle is in a seat
and using a seat belt properly.
NOTE:Prior to lifting either seatback to the upright
position, be sure that the seat belt is brought forward to
avoid trapping it behind the seatback.Folding Rear Seat Release Knobs
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 167
3

Tumbling Rear Seat (Sedan)
To provide additional storage in the cargo area, each rear
seat can be tumbled forward.
CAUTION!
It is important that the front seats be pulled forward
to the midpoint of the seat track to avoid contact
between the rear seat and the front seatback. If the
front seat is not pulled forward the two seats will
make contact during the tumbling motion and cause
damage to the rear seat material. After the rear seat is
tumbled forward and secured the front seat can then
be repositioned to the preferred position.
•Push and hold the button on the seatback and fold
down the rear seatback.
Folding Rear Seat Button
168 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

•Pull the release handle located on the outboard side of
the seat. Lift up the seat and tumble the seat forward.
•Attach the elastic strap, located at the base of the seat
cushion, onto the hook bar on the center trim panel to
hold the seat in place.To return the rear seat to it’s upright latched position,
rotate the seat cushion rearward to latch the seat. Then
lift the seatback to its upright latched position.
NOTE:The elastic strap should be reinstalled in the clip
on the base of the seat cushion before returning the seat
to its normal position.
Tumbling Seat Release Strap
Tumbling Seat Strap
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 169
3

Tumbling Rear Seat (Convertible)
To provide additional storage area, each rear seat can be
tumbled forward.
CAUTION!
It is important that the front seats be pulled forward
to the midpoint of the seat track to avoid contact
between the rear seat and the front seatback. If the
front seat is not pulled forward the two seats will
make contact during the tumbling motion and cause
damage to the rear seat material. After the rear seat is
tumbled forward and secured the front seat can then
be repositioned to the preferred position.
To tumble the seat forward use the following procedure:
1. The seat back release knobs are located in the trunk
area. Pull the left side seatback release knob to fold down
the left side seatback. Pull the right side seatback release
knob to fold down the right side seatback.
Folding Rear Seat Release Knobs
170 UNDERSTANDING THE FEATURES OF YOUR VEHICLE