display CHRYSLER SEBRING CONVERTIBLE 2008 3.G Owners Manual

NOTE:The following conditions must be met in order
for this switch to operate:
²The gear selector lever must be in PARK.
²The convertible top must be either closed and latched
or open and latched.To unlatch the trunk lid from outside the vehicle, press
and release the TRUNK button on the Remote Keyless
Entry (RKE) transmitter two times.
With the ignition ON, the word ªdeckº will display in the
odometer indicating the trunk is open. The odometer
display will reappear once the trunk is closed or if the
trip button is pressed.
With the key in the lock position or with the key out, the
word ªdeckº will display until the trunk is closed.
On vehicles equipped with the Electronic Vehicle Infor-
mation Center (EVIC), the words ªTrunk Ajarº will
display.
Trunk Release Button
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 37
2

Cargo Protector
The cargo protector is located in the trunk. Before low-
ering the convertible top, you must unfold the cargo
protector and seat the tabs at each end of the cargo
protector in the V slots in the trunk liner. Doing so closes
a switch that allows top operation. If the switch is not
closed, a warning message displays in the instrument
cluster to notify the driver.
Positioning the Cargo Protector for Top Operation
Pull the cargo protector toward you to begin unfolding
the panels. Grasp the handle in the center of the outer-
most (top) panel and raise the cargo protector. Then,
align and seat the tabs at each end of the cargo protector
in the V slots in the trunk liner as shown in the illustra-
tion.
Cargo Protector
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 85
3

EVIC
MessageLEVIC
Message
Display
TimeLOdometer
Message
(< 5 mph
[8 km/h])LLOdometer
Message
Display
TimeLLOdometer
Message
(> 5 mph
[8 km/h])LLOdometer
Message
Display
TimeLLChime ConditionOperator
Action
Required
CONVERT-
IBLE TOP IN
OPERATIONUntil Op-
eration is
CompleteTOP Until Opera-
tion is Com-
pleteÐ Ð Ð The System is
Lowering or
Raising the TopÐ
CONVERT-
IBLE TOP
COMPLETE9 Seconds TOP DONE Display Scrolls
for 6 SecondsÐ Ð Single
ChimeThe System
Completes Op-
eration of Low-
ering or Raising
the TopÐ
SECURE
CARGO
SHIELD9 Seconds SET CARGO
SHIELDDisplay Scrolls
for 9 SecondsÐ Ð Single
ChimeThe Top Fails to
Move When Op-
erating the
Power Top Con-
trolPosition the
Cargo Protec-
tor in the
Trunk to Allow
Top Operation
CONVERT-
IBLE TOP IN
OPERATIONUntil Op-
eration is
CompleteTOP Until Opera-
tion is Com-
pleteTOP Until Op-
eration is
CompleteSingle
ChimeThe System Fails
to Complete Op-
eration of Low-
ering or Raising
the TopCycle Power
Top Control
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 93
3

EVIC
MessageLEVIC
Message
Display
TimeLOdometer
Message
(< 5 mph
[8 km/h])LLOdometer
Message
Display
TimeLLOdometer
Message
(> 5 mph
[8 km/h])LLOdometer
Message
Display
TimeLLChime ConditionOperator
Action
Required
SPEED TOO
HIGH9 Seconds SPEED TOO
HIGHDisplay Scrolls
for 9 SecondsTOP 6 Seconds Single
ChimeYou Are Operat-
ing the Power
Top at a Vehicle
Speed Greater
Than 0 mph (0
km/h)The Top Will
Not Operate
Unless the Ve-
hicle is Station-
ary.
TRUNK
AJARContinu-
ousDECK Continuous DECK Continuous Single
ChimeThe Trunk Lid is
Unlatched or
OpenThe Top Will
Not Operate
Unless the
Trunk Lid is
Closed
CONVERT-
IBLE TOP
MALFUNC-
TION6 Seconds TOP FAIL Display Scrolls
for 6 SecondsTOP 6 Seconds Single
ChimeThe PTCM Acti-
vated the System
LOCKOUT Fea-
tureRefer to Foot
NoteLLL
CONVERT-
IBLE TOP
MALFUNC-
TIONUntil Fault
is No
Longer De-
tected or
RepairedTOP FAIL Display Scrolls
until Fault is
No Longer De-
tected or Re-
pairedTOP Display
Flashes un-
til Fault is
No Longer
Detected or
RepairedSingle
ChimeThe PTCM Acti-
vated the System
LOCKOUT Fea-
tureSee your au-
thorized dealer
for service
94 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

The UConnecttsystem is fully integrated with the vehi-
cle's audio system. The volume of the UConnecttsystem
can be adjusted either from the radio volume control
knob or from the steering wheel radio control (right
switch), if so equipped.
The radio display will be used for visual prompts from
the UConnecttsystem such as9CELL9or caller ID on
certain radios.
Operation
Voice commands can be used to operate the UConnectt
system and to navigate through the UConnecttmenu
structure. Voice commands are required after most
UConnecttsystem prompts. You will be prompted for a
specific command and then guided through the available
options.
²Prior to giving a voice command, one must wait for
the beep, which follows the9Ready9prompt or another
prompt.
²For certain operations, compound commands can be
used. For example, instead of saying9Setup9and then
9Phone Pairing,9the following compound command
can be said:9Setup Phone Pairing.9
²For each feature explanation in this section, only the
combined form of the voice command is given. You
can also break the commands into parts and say each
part of the command when you are asked for it. For
example, you can use the combined form voice com-
mand9Phonebook New Entry,9or you can break the
combined form command into two voice commands:
9Phonebook9and9New Entry.9Please remember, the
UConnecttsystem works best when you talk in a
normal conversational tone, as if speaking to someone
sitting a few feet/meters away from you.
Voice Command Tree
Refer to ªVoice Treeº at the end of this section.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 101
3

²For identification purposes, you will be prompted to
give the UConnecttsystem a name for your cellular
phone. Each cellular phone that is paired should be
given a unique phone name.
²You will then be asked to give your cellular phone a
priority level between 1 and 7, with 1 being the highest
priority. You can pair up to seven cellular phones to
your UConnecttsystem. However, at any given time,
only one cellular phone can be in use, connected to
your UConnecttsystem. The priority allows the
UConnecttsystem to know which cellular phone to
use if multiple cellular phones are in the vehicle at the
same time. For example, if priority 3 and priority 5
phones are present in the vehicle, the UConnectt
system will use the priority 3 cellular phone when you
make a call. You can select to use a lower priority
cellular phone at any time (refer to9Advanced Phone
Connectivity9).
Dial by Saying a Number
²
Press the PHONE button to begin.
²After the9Ready9prompt and the following beep, say
9Dial.9
²The system will prompt you to say the number you
want to call.
²For example, you can say9234-567-8901.9The phone
number that you enter must be of valid length and
combination. Based on the country in which the ve-
hicle was purchased, the UConnecttsystem limits the
user from dialing an invalid combinations of numbers.
For example, in the U.S.A., 234-567-890 is nine digits
long, which is not a valid U.S.A. phone number - the
closest valid phone number has 10 digits.
²The UConnecttsystem will confirm the phone num-
ber and then dial. The number will appear in the
display of certain radios.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 103
3

Call by Saying a Name
²
Press the PHONE button to begin.
²After the9Ready9prompt and the following beep, say
ªCall9.
²The system will prompt you to say the name of the
person you want to call.
²After the9Ready9prompt and the following beep, say
the name of the person you want to call. For example,
you can say9John Doe,9where John Doe is a previ-
ously stored name entry in the UConnecttphonebook.
Refer to9Add Names to Your UConnecttPhonebook,9
to learn how to store a name in the phonebook.
²The UConnecttsystem will confirm the name and
then dial the corresponding phone number, which
may appear in the display of certain radios.
Add Names to Your UConnecttPhonebook
NOTE:Adding names to the phonebook is recom-
mended when the vehicle is not in motion.
²Press the PHONE button to begin.
²After the9Ready9prompt and the following beep, say
9Phonebook New Entry.9
²When prompted, say the name of the new entry. Use of
long names helps the voice recognition and it is
recommended. For example, say9Robert Smith9or
9Robert9instead of9Bob.9
²When prompted, enter the number designation (e.g.,
9Home,99Work,99Mobile,9or9Pager9). This will allow
you to store multiple numbers for each phonebook
entry, if desired.
²When prompted, recite the phone number for the
phonebook entry that you are adding.
104 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

After you are finished adding an entry into the phone-
book, you will be given the opportunity to add more
phone numbers to the current entry or to return to the
main menu.
The UConnecttsystem will allow you to enter up to 32
names in the phonebook with each name having up to
four associated phone numbers and designations. Each
language has a separate 32-name phonebook accessible
only in that language.
Phonebook Download
UConnecttallows the user to download entries from
their phone via Bluetootht. To use this feature, press the
PHONE button and say ªPhonebook Download.º The
system prompts, ªReady to accept vcard entry via
Bluetooth¼º The system is now ready to accept phone-
book entries from your phone using the Bluetootht
Object Exchange Profile (OBEX). Please see your phone
owners' manual for specific instructions on how to send
these entries from your phone.NOTE:
²Phone handset must support BluetoothtOBEX trans-
fers of phonebook entries to use this feature.
²Some phones cannot send phonebook entries if they
are already connected to any system via Bluetootht,
and you may see a message on the phone display that
the Bluetoothtlink is busy. In this case, the user must
first disconnect or drop the Bluetoothtconnection to
the UConnecttsystem, and then send the address
book entry via Bluetootht. Please see your phone
Owner 's Manual for specific instructions on how to
drop the Bluetoothtconnection.
²If the phonebook entry is longer than 24 characters, it
will only use the first 24 characters.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 105
3

Turning Confirmation Prompts On/Off
Turning confirmation prompts off will stop the system
from confirming your choices (e.g., the UConnecttsys-
tem will not repeat a phone number before you dial it).
²Press the PHONE button to begin.
²After the9Ready9prompt and the following beep, say
9Setup Confirmations.9The UConnecttsystem will
play the current confirmation prompt status and you
will be given the choice to change it.
Phone and Network Status Indicators
If available on the radio and/or on a premium display
such as the instrument panel cluster, and supported by
your cell phone, the UConnecttsystem will provide
notification to inform you of your phone and network
status when you are attempting to make a phone call
using UConnectt. The status is given for roaming, net-
work signal strength, phone battery strength, etc.
Dialing Using the Cellular Phone Keypad
You can dial a phone number with your cellular phone
keypad and still use the UConnecttsystem (while dial-
ing via the cell phone keypad, the user must exercise
caution and take precautionary safety measures). By
dialing a number with your paired Bluetoothtcellular
phone, the audio will be played through your vehicle's
audio system. The UConnecttsystem will work the same
as if you dial the number using voice recognition.
NOTE:Certain brands of mobile phones do not send the
dial ring to the UConnecttsystem to play it on the
vehicle audio system, so you will not hear it. Under this
situation, after successfully dialing a number the user
may feel that the call did not go through even though the
call is in progress. Once your call is answered, you will
hear the audio.
114 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Instrument Panel Dimming
With the parking lights or headlights on, rotate the
Dimmer Control upward or downward to change the
brightness of the instrument panel lights.
Parade Mode (Daytime Brightness Feature)
Rotate the Dimmer Control to the first detent to brighten
the odometer and radio display when the parking lights
or headlights are on during daylight conditions.
Interior Light ON
Rotate the Dimmer Control completely upward to the
second detent to turn on the interior lights. The interior
lights will remain on when the dimmer control is in this
position.
Interior Light Defeat OFF
Rotate the Dimmer Control completely downward to the
(O) OFF position. The interior lights will remain off when
the doors are open.
Dimmer Control
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 145
3