fuse CHRYSLER SEBRING CONVERTIBLE 2009 3.G User Guide

CAUTION! (Continued)
•When replacing a blown fuse, it is important to
use only a fuse having the correct amperage rating.
The use of a fuse with a rating other than indicated
may result in a dangerous electrical system over-
load. If a properly rated fuse continues to blow, it
indicates a problem in the circuit that must be
corrected.
VEHICLE STORAGE
If you will not be using your vehicle for more than
21 days, you may want to take steps to preserve your
battery.
•Disengage the mini-fuse in the Power Distribution
Center labeled IOD (Ignition Off-Draw).
•Disconnect the negative cable from the battery.
REPLACEMENT BULBS
All the inside bulbs are brass or glass wedge base.
Aluminum base bulbs are not approved and should not
be used for replacement.
LIGHT BULBS — Interior Bulb Number
Front Courtesy/Reading
Lights..................... LED(Dealer Service)
Center Console Courtesy Light...........578/W5W
Glove Box Light......................... 194
Rear Compartment (Trunk) Light............. 579
NOTE:For lighted switches, see your dealer for replace-
ment instructions.
MAINTAINING YOUR VEHICLE 411
7

Fuses................................ 405
Garage Door Opener (HomeLink) ........... 158
Gas Cap (Fuel Filler Cap)............334,336,373
Gasoline, Clean Air...................... 327
Gasoline (Fuel)......................... 325
Gasoline, Reformulated................... 327
Gauges
Coolant Temperature.................... 181
Fuel................................ 181
Odometer........................... 184
Tachometer.......................... 183
Gear Ranges........................... 274
Gearshift.............................. 274
General Information............18,27,130,278,325
General Maintenance..................... 376
Glass Cleaning.......................... 402
Gross Axle Weight Rating...............337,340
Gross Vehicle Weight Rating.............337,339GVWR............................... 337
Hands-Free Phone (UConnect) .............. 102
Hazard
Driving Through Flowing, Rising, or Shallow
Standing Water........................ 280
Hazard Warning Flasher................... 352
Head Restraints......................... 141
Headlights.......................143,144,412
Automatic........................... 144
Bulb Replacement...................... 412
Cleaning............................ 400
Delay.............................. 145
High Beam........................... 192
High Beam/Low Beam Select Switch........ 148
Lights On Reminder.................... 146
On With Wipers....................144,153
Passing............................. 148
Replacing............................ 412
INDEX 459
10

Switch...........................143,144
Time Delay.......................... 145
Heated Mirrors......................... 101
Heated Seats........................... 136
Heater............................... 250
Heater, Beverage Holder (Cupholder)......... 168
Heater, Engine Block..................... 270
High Beam/Low Beam Select (Dimmer) Switch . . 148
Hitches
Trailer Towing........................ 341
Holder, Cup........................... 167
Holder Heated/Cooled (Cupholder).......... 168
HomeLink(Garage Door Opener) Transmitter . . . 158
Hood Prop............................ 143
Hood Release.......................... 142
Ignition............................... 13
Key ...............................12,13
Lock................................ 13Ignition Key Removal..................... 13
Illuminated Entry........................ 20
Immobilizer (Sentry Key)................... 15
Infant Restraint........................62,63
Information Center, Vehicle................. 193
Instrument Cluster.................179,180,181
Instrument Panel and Controls.............. 178
Instrument Panel Cover................... 400
Instrument Panel Lens Cleaning............. 402
Integrated Power Module (Fuses)............ 405
Interior Appearance Care.................. 400
Interior Lighting......................143,148
Interior Lights.......................... 150
Intermittent Wipers (Delay Wipers)........... 152
Introduction............................. 4
Jack Location........................... 355
Jack Operation.......................354,356
Jacking Instructions...................... 356
460 INDEX

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped. The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.