cruise control Citroen BERLINGO MULTISPACE RHD 2014.5 2.G User Guide

 59
Berlingo_2_VP_en_Chap04_Ergonomie_ed02-2014
changing the
programmed
speed Switching the function off
Operating fault
The programmed
 speed  is  cleared  then  replaced
  by   three   dashes.   Contact  
a

  CITROËN   dealer   or   a   qualified  
workshop

  to   have   the   system   checked.
cancelling the programmed
reference speed
When the vehicle becomes stationary, after switching of f the ignition, the
system
  no   longer   memorises   a   speed.
There
 
are
 
two
 
methods
 
of
 
memorising
 
a

 
speed
 
higher
 
than
 
the
 
previous
 
one:
Without
 
using
 
the
 
accelerator:
-
press the
SE
t
+
 
button.a brief press increases the speed by

1
 
mph
 
(km/h).
A
 

maintained
 
press
 
increases
 
the
 
speed

 
in
 
steps
 
of
 
5
 
mph
 
(km/h).
Using
 
the
 
accelerator:
-
 
exceed

 
the
 
memorised
 
speed
 
until
 
the

 
speed
 
required
 
is
 
reached,
-

press the

SE
t
+ or SE
t
-
 
button.
To
 
memorise
 
a
 
speed
 
lower
 
than
 
the
 
previous

 
one:
-

press the

SE
t
-
 
button.
a brief press decreases the speed by


1
 
mph
 
(km/h).
A
 

maintained
 
press
 
decreases
 
the
 
speed

 
in
 
steps
 
of
 
5
 
mph
 
(km/h). -

Place the dial in position
0 or
switch off the ignition to switch
everything off.
Good practice
When changing the programmed reference   speed   by   means   of   a  
maintained

  press,   pay   attention   as  
the speed can increase or decrease
rapidly

.
d

o not use the cruise control on
slippery
  roads   or   in   heavy   traffic.
In the event of a steep slope, the cruise
control
  cannot   prevent   the   vehicle   from  
exceeding

  the   programmed   speed.
In any event, the cruise control cannot
replace the need to observe the speed
limits
  and   the   need   for   vigilance   on   the  
part

  of   the   driver.
It is advisable to leave your feet near
the
  pedals.
To
  avoid   any   jamming   under   the  
pedals:
-

 
ensure
  that   the   mat   and   its   fixings  
on

  the   floor   are   positioned   correctly,
-
 
never
  place   one   mat   on   top   of  
another

.
Steering mounted controls
EASE OF uSE and cOMFOrt
4