battery Citroen BERLINGO MULTISPACE RHD 2017 2.G Owner's Guide

171
Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016
ECONOMY MODE
After the engine has stopped, with
the
  key   in   the   ignition   position,   certain  
functions (windscreen wiper

, electric
windows, courtesy lamps, audio
equipment,
  etc.)   can   only   be   used   for   a  
cumulative duration of thirty minutes, to
prevent

  discharging   of   the   battery.
Once the thirty minutes have elapsed,
the active functions are put on standby
and
  the   battery   warning   lamp   flashes  
accompanied by a message in the
screen.
T

o resume the use of these functions
immediately, start the engine and let it
run
  for   a   few   minutes.
The time available will then be double
the time for which the engine was left
running.
  However,   this   time   will   always  
be

  between   five   and   thirty   minutes.
A
 

flat   battery   will   prevent   the  
engine

  from   starting.
Battery
QUICK HELP
8

182
Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016
2. Sidelamps
Type A, W5W - 5W
-
Remove the cover by pullin
g the
flexible
  rubber   tab.
-
 
Remove
  the   bulb   holder   fitted   by  
pressure

  by   pulling   the   connector.
-
 
Change
  the   bulb.
-
 
Ensure
  that   the   cover   is   refitted  
correctly all round to assure correct
sealing.
Front lamps
1. Dipped / Main beam headlamps
T ype C, H4 - 55W
-

Remove the centre cover by pullin
g
the
  flexible   rubber   tab.
-
 
Disconnect
  the   electrical   connector.
-
 
Release
  the   retaining   tab.
-
 
Change
  the   bulb   taking   care  
to align the metal part with the
grooves

  on   the   lamp.
-
 
Reposition
  the   retaining   tab.
-
 
Ensure
  that   the   cover   is   refitted  
correctly all round to assure correct
sealing.
High pressure washing Open

 
the
 
bonnet.
 
T

o
 
access
 
the
 
bulbs,
 
reach

 
behind
 
the
 
headlamp
 
unit.
Carry out the operations in reverse
order
 
to
 
refit
 
each
 
bulb
 
and
 
check
 
that
 
the

 
bonnet
 
is
 
closed
 
securely.
Halogen bulbs must be changed
with
 
the
 
headlamp
 
off.
 
Wait
 
a
 
few
 
minutes

 
(risk
 
of
 
serious
 
burns).
 
Do not touch the bulb directly with your
fingers,

 
use
 
lint-free
 
cloths.
It is normal for condensation to form
inside
 
the
 
headlamps.
 
Regular
 
use
 
of
 the
 
vehicle
 
eliminates
 
this
 
misting.
The bulbs must be changed with
the ignition off or with the battery
disconnected.
 
Wait
 
approximately
 
3


minutes after changing the bulb
before
 
reconnecting
 
the
 
battery.
Check
 
that
 
the
 
lamps
 
operate
 
correctly
 
after

 
each
 
operation.
When using this type of washing
on stubborn dirt, do not persist on
the headlamps, the lamps and their
edges to avoid damaging their coating
and
 
seals.
Changing a bulb

187
Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016
CHANGING A FUSE
The fuseboxes are located:
-
in the lower dashboard on the left-
hand side (behind the cover),
-

 
under
  the   bonnet   (near   the   battery).
The information given concerns only
those fuses which can be changed by
the user using the tweezer, located
behind the dashboard storage
compartment
  on   the   right-hand   side.  
For

  any   other   work,   visit   a   CITROËN  
dealer

  or   a   qualified   workshop.
Removing and fitting a fuse
Always replace a failed fuse with a
fuse of the same rating.
Motor
 
trade
 
technicians:
 
for
 
complete information on the fuses
and relays, refer to the "Repair
Manual" diagrams via the dealer
network.
CITROËN will not accept responsibility
for the cost incurred in repairing
your vehicle or for rectifying the
malfunctions resulting from the
installation of accessories not
supplied and not recommended by the
CITROËN

 
network
 
and
 
not
 
installed
 
in accordance with its instructions,
in particular when the combined
consumption of all of the additional
equipment connected exceeds
10 millia

mperes. Before replacing a fuse, the cause of
the
  incident   must   be   identified   and  
rectified.
●

 
Use
  the   tweezer.
QUICK HELP
8
Changing a fuse

261
Berlingo2VP_en_Chap10a_SMEGplus_ed02-2016
QUESTIONANSWER SOLUTION
There is a difference in
sound quality between the
different
  audio   sources. For
  optimum   sound   quality,   the   audio   settings   for   Volume:,   Bass:,  
T

reble:,   Ambience   and   Loudness   can   be   adapted   to   the   different  
s

ound sources, which may result in audible differences when
changing
 s

ource. Check
  that   the   audio   settings   for   (Volume:,   Bass:,  
T

reble:,   Ambience,   Loudness)   are   adapted   to   the  
s

ources   listened   to.   It   is   advisable   to   set   the   audio  
f

unctions   (Bass:,   Treble:,   Balance)   to   the   middle  
p

osition, select the "None" musical ambience
and set the loudness correction to the "Inactive"
position
  in   radio   mode.
With the engine off, the
system switches off after a
few
 
minutes   of   use. When the engine is switched off, the system's operating time
depends
  on   the   state   of   charge   of   the   battery.
The
  switch-off   is   normal:   the   system   switches   to   economy   mode   and  
s

witches   off   to   prevent   discharging   of   the   vehicle's   battery.Start the vehicle's engine to increase the battery
charge.
Audio and Telematics
TECHNOLOGY on BOARD
10

265
Berlingo2VP_en_Chap10b_RD45_ed02-2016
Audio system
Audio system / Bluetooth®
Contents
First steps
2 66
Steering
 
mounted
 
controls
 
2
67
Menus
268
Radio
268
Media
 2

70
Telephone
 2

74
Screen
 
menu
 
map(s)
 
2
76
Frequently
 
asked
 
questions
 
2
80
Your Audio system is coded in such a way that it will only operate
in
 
your
 
vehicle. As a safety measure, the driver must only carry out operations
which
 
require
 
prolonged
 
attention
 
while
 
the
 
vehicle
 
is
 
stationary.
When the engine is switched off and to prevent discharging of the
battery,
 
the
 
audio
 
equipment
 
may
 
switch
 
off
 
after
 
a
 
few
 
minutes.
Audio and Telematics
TECHNOLOGY on BOARD
10

280
Berlingo2VP_en_Chap10b_RD45_ed02-2016
The table below gives answers to the most frequently asked questions on your audio system.
Q UESTION ANSWER SOLUTION
With the engine off, the
audio system switches off
after
  a   few   minutes   of   use.When the engine is switched off, the audio system operating time
depends
  on   the   state   of   charge   of   the   battery.
The
  switch-off   is   normal:   the   audio   equipment   switches   to   economy  
m

ode and switches off to prevent discharging of the vehicle's
battery. Start the vehicle's engine to increase the battery
charge.
The message "the audio
system is overheated"
appears
  on   the   display.In order to protect the installation if the surrounding temperature
is too high, the audio system switches to an automatic thermal
protection mode leading to a reduction in volume or CD play
stopping. Switch the audio system off for a few minutes to
allow
  the   system   to   cool.
Frequently asked questions
QUESTIONANSWER SOLUTION
There is a difference in
sound quality between the
different audio sources
(radio,
 C

D...). For optimum sound quality, the audio settings (Volume, Bass,
Treble, Ambience, Loudness) can be adapted to the different sound
sources, which may result in audible differences when changing
source
  (radio,   CD...). Check
  that   the   audio   settings   (Volume,   Bass,  
T

reble, Ambience, Loudness) are adapted to
the
  sources   listened   to.   It   is   advisable   to   set  
t

he audio functions (Bass, Treble, Front-Rear
Balance, Left-Right Balance) to the middle
position, select the musical ambience "None"
and set the loudness correction to the "Active"
position in CD mode or to the "Inactive" position
in
  radio   mode.
Radio
Audio and Telematics

282
Berlingo2VP_en_Chap10b_RD45_ed02-2016
Media
QUESTIONANSWER SOLUTION
The message "USB
peripheral error" is
displayed
  on   the   screen.
The Bluetooth
® connection
is
 
cut. The
  battery   of   the   peripheral   may   not   be   sufficiently   charged. Recharge   the   battery   of   the   peripheral   device.
The   USB   memory   stick   is   not   recognised.
The   USB   memory   stick   may   be   corrupt.Reformat
  the   USB   memory   stick.
The
 
CD
 
is
 
ejected  
a

utomatically or is not
played
 
by
 
the
 
player. The CD is inserted upside down, is unplayable, does not contain
any audio data or contains an audio format which the player cannot
p l ay.
The CD is protected by an anti-pirating protection system which is
not
  recognised   by   the   audio   equipment.-
 
C
heck   that   the   CD   is   inserted   in   the   player  
t

he   right   way   up.
-
 
C
heck   the   condition   of   the   CD:   the   CD  
c

annot   be   played   if   it   is   too   damaged.
-
 
C
heck   the   content   in   the   case   of   a   recorded  
C

D:   consult   the   advice   in   the   "Audio"   section.
-

T
he audio equipment's CD player does not
play
  DVDs.
-

D
ue to their quality level, certain writeable
CDs
  will   not   be   played   by   the   audio   system.
The CD player sound is
p o o r. The
  CD   used   is   scratched   or   of   poor   quality.Insert good quality CDs and store them in
suitable
 c

onditions.
The audio equipment settings (bass, treble, ambiences) are
unsuitable. Set the treble or bass level to 0, without selecting
an
 am

bience.
QUESTION ANSWER SOLUTION
I am unable to access my
voicemail. Few
  telephones   or   service   providers   allow   the   use   of   this   function.
Telephone
Audio and Telematics

284
Berlingo2VP_en_Chap10c_BTA-3R_ed02-2016
Localised Assistance Call
Operation of the systemIf you purchased your vehicle outside
the  Brand's   dealer   network,   we  
i

nvite   you   to   have   a   dealer   check   the  
c

onfiguration of these services and, if
desired,
  modified   to   suit   your   wishes.   In  
a m

ulti-lingual country, configuration is
possible in the official national language
of
  your   choice.
For technical reasons and in particular
to improve the quality of "Telematic
services" services to customers, the
manufacturer reserves the right to carry
out updates to the vehicle's on-board
telematic
  system.
When the ignition is switched
on, the green LED comes on for
3 seconds indicating that the
system
 
is
 
operating
 
correctly.
The red indicator lamp is on
continuously:
 
there
 
is
 
a
 
system
 
f

ault.
A fault with the system does not prevent
the
 
vehicle
 
being
 
driven. Press this button for more than
2

seconds to request assistance if
the
 
vehicle
 
breaks
 
down.
**

D

epending on the geographical cover of
"Localised Emergency Call", "Localised
Assistance Call" and the official national
language selected by the owner of the
vehicle.
T

he list of countries covered and Telematic
services is available from dealers or on the
website
  for   your   country.
Pressing this button again immediately cancels
the
 
request.
The cancellation is confirmed by a voice
message.
Geo-location
You can deactivate geo-location by
simultaneously pressing the "Localised
Emergency Call" and "Localised Assistance
Call" buttons, followed by a press on "Localised
Assistance
  Call"   to   confirm.
To reactivate geo-location, simultaneously
press the "Localised Emergency Call" and
"Localised Assistance Call" buttons again,
followed by a press on "Localised Assistance
CallLocalisé"
  to   confirm.
The
 
red
 
indicator
 
lamp
 
flashes:
 
replace
 
the
 
b

ack-up
 
battery. A voice message confirms that the call has
been  made**.
In either case, the emergency and assistance
calls
 
may
 
not
 
function.
Contact a qualified repairer as soon as
possible. For Russia, Belarus and Kazakhstan.
Audio and Telematics