fuel filter Citroen BERLINGO MULTISPACE RHD 2017 2.G Owner's Manual

Page 14 of 292

12
Berlingo2VP_en_Chap01_vue-ensemble_ed02-2016
TECHNICAL DATA - M AINTENANCE
Identification markings, 
serial number ,
paint code, tyres

201
Windscreen wash, level


158
Changing bulbs,


lighting
181-186 Checks
 
159-160
-


battery
,
-
 
brake
  pads,
-
 
brake
  drums,   discs.
-
 
parking
  brake,
-

carbon/passenger compartment filter,- oil  filter,
-  particle   filter,
-

gearbox,
Emissions control


41
Engine

  fuses  
187,
  190
Opening the bonnet, stay

154 Levels

 
157-158
-
 
engine
  oil   dipstick,
-  
brake
  fluid,
-  
coolant.
-
 
power
  steering   fluid,
-
Diesel additive,
Bleeding
  water,   Diesel   filter  
160
W

arning lamps

32-39
Under the bonnet-


Diesel

156
-


petrol

155
Fuel cut-of

f, Diesel
priming
163
AdBlue
® 164-169
Dimensions

193-196
Petrol
 
engines
 
/
 

weights
 
197-198
Diesel

 
engines
 
/
 

weights
 
197,

 
199-200
Location

Page 19 of 292

17
Berlingo2VP_en_Chap02_eco-conduite_ed02-2016
Limit the causes of excess
consumption
Spread loads throughout the vehicle;
place the heaviest items in the bottom
of the boot, as close as possible to
the  rear   seats.
Limit the loads carried in the
vehicle and reduce wind resistance
(roof
  bars,   roof   rack,   bicycle  
carrier

,   trailer...).   Use   a   roof   box   in  
preference.
Remove

  roof   bars   and   roof   racks  
after

  use.
At the end of winter, remove snow
tyres
  and   refit   your   summer   tyres.
Observe the recommendations
on maintenance
Check the tyre pressures regularly, when cold, referring to the label in the
door  aperture,   driver's   side.
Carry
  out   this   check   in   particular:
-
 
before
  a   long   journey,
-

at each change of season,
-

 
after
  a   long   period   out   of   use.
Don't forget the spare wheel and the
tyres
  on   any   trailer   or   caravan.
Have your vehicle serviced regularly
(engine
  oil,   oil   filter,   air   filter,   passenger  
compartment

  filter...)   and   observe   the  
schedule of operations recommended
in

  the   manufacturer's   service   schedule.
With a BlueHDi Diesel engine, if the
SCR system is faulty your vehicle
becomes polluting; go to a CITROËN
dealer
  or   a   qualified   workshop   without  
delay to have the emissions of nitrogen
oxides

  brought   back   to   the   legal   level.When refuelling, do not continue after
the third cut-off of the nozzle to avoid
any
  overflow.
At the wheel of your new vehicle,
it
  is   only   after   the   first   1   800   miles  
(3 000

  kilometres)   that   you   will   see  
the fuel consumption settle down to a
consistent

  average.
2
ECO-DRIVING
Motoring & the Environment

Page 37 of 292

+
ABS
35
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Warning lamp isindicatesSolution - action
Power
steering on. a fault with the
system.
The vehicle
 retains  conventional  steering  without  assistance. Have
  it   checked   by   a   CITROËN   dealer   or   a   qualified workshop.
Door open
detectionon and accompanied
by a message in the
screen. that a door is not
closed
  correctly.Check
  that   all   of   the   doors   are   closed.
ABS remaining
  on.a fault with the anti-
lock
  braking   system.The
  vehicle   retains   conventional   braking.
Have
  it   checked   by   a   CITROËN   dealer   or   a  
qualified

  workshop.
ESC flashing.
triggering of the ASR
or
  DSC   regulation.The system optimises traction and improves the
directional
  stability   of   the   vehicle.
Chapter
  5,   "Driving   safety"   section.
remaining
  on.a fault with the
system.
E.g.:
  under-inflation  
of

  the   tyres.E.g.:
  check   the   pressure   of   the   tyres.
Have
  it   checked   by   a   CITROËN   dealer   or   a  
qualified

  workshop.   (Wheel   speed   sensor,  
hydraulic

  valve   block,   ...).
Under-
inflation on.
the tyre pressure is
too low in or more
wheels.Check
  the   tyre   pressure   as   soon   as   possible.
This
  check   must   be   done   with   the   tyres   cold.
flashing
  then
 remaining on,


accompanied by the
Service warning
lamp, and depending
on equipment, the
display
  of   a   message.the tyre pressure
monitoring system
has a fault or one of
the wheels does not
have
  a   sensor.Detection
  of   under-inflation   is   no   longer   assured.
Have
  it   checked   by   a   CITROËN   dealer   or   a  
qualified

  workshop.
Particle filter on. a problem with the
particle
  filter   (fuel  
additive

  level,   risk   of  
blockage, ...).Have

  the   filter   checked   by   a   CITROËN   dealer   or  
a

  qualified   workshop.
Chapter
  7,   "Levels"   section.
READY TO GO
3

Page 39 of 292

37
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Warning lamp
in the screenis
indicates Solution - action
Cruise
control on.
cruise
  control   selected.Manual
  selection.
Chapter
  4,   "Steering   mounted   controls"   section.
Speed limiter on.speed
  limiter   selected.Manual
  selection.
Chapter
  4,   "Steering   mounted   controls"   section.
Gear shift
indicator on.a recommendation
independent of the type and
density
  of   traffic.To reduce fuel consumption, change to an
appropriate
  gear   with   a   manual   gearbox.
The driver retains responsibility to follow this
indication
  or   not.
Diesel
pre-heating on.climatic conditions requiring
pre-heating. Wait until the warning lamp goes off before
operating
  the   starter.
Presence of
water in the
Diesel filter
on and
accompanied by
a message in
the
  screen.
water in the Diesel filter. Have   the   filter   bled   by   a   CITROËN   dealer   or   a  qualified
  workshop   without   delay.
Chapter   7,   "Checks"   section.
According
  to   country.
Service
spanner on.that a service will be due
shortly. Refer
  to   the   list   of   checks   in   the   maintenance   and  
warranty

  guide.
Have the service carried out by a CITROËN
dealer
  or   a   qualified   workshop.
Time flashing. adjustment
  of   the   time.Use
  the   left-hand   button   on   the   instrument   panel.
Chapter
  3,   "Instruments   and   controls"   section.
READY TO GO
3