warning Citroen C ZERO 2010.5 1.G User Guide

Page 26 of 164

Monitoring
24
Warning/indicator lampStateCauseAction/Observations
Electronic stabilityprogrammeand anti-slipregulation(ESP/ASR)
Flashing. Activation of the ESP/ASR systems. The systems optimise traction and improve the
directional stability of the vehicle.
Adapt your driving and moderate your speed.
On fixed. Fault in the ESP/ASR systems. Have it checked by a CITROËN dealer or a qualified
workshop.
+



Door(s) openOn fixed, accompanied by anaudible signal. A door or the boot is still open.
Close the door or boot.



Ancillariesbattery chargeOn fixed. The ancillaries battery chargingcircuit has a fault (dirty or loose
terminals, slack, transformer fault, ...).The warning lamp should go o
ff when the motor isstarted.
If it does not go off, contact a CITROËN dealer or
qualified workshop.
Electric power steeringOn fixed. The electric power steering has afault. Drive carefully at reduced speed.
Have it checked by a CITROËN dealer or a qualified
workshop.

Page 27 of 164

1
Monitoring
25
Warning/indicator lampStateCauseAction/Observations


Airbags

On temporarily. When you switch on the ignition, this
warning lamp comes on for a few seconds, then goes off. If it does not
go off, contact a CITROËN dealer or
a qualified workshop.

On fixed. Fault with one of the airbag or seat
belt pretensioner systems. Have it checked by a CITROËN dealer or a qualified
workshop.
Protection system for themain battery
On fixed. The state of charge of the main battery is too low or the temperature
of the main battery is too low... The power
from the motor is limited.
Charge the main battery as soon as possible.
If the warning lamp does not go off, contact aCITROËN dealer or qualified workshop.
Self-diagnosis system of the main electricalcircuit
On fixed. Fault in the main electrical circuit. You must stop as soon as it is safe to do so.
Have it checked by a CITROËN dealer or a qualified
workshop.
Front seat beltnot fastened/unfastened
On fixed, then
flashing, accompanied
by an audible signal.The driver and/or the front passen
ger has not fastened or has unfastenedtheir seat belt. Pull the strap, then inser t the ton
gue in the buckle.
Right hand rear seatbelt unfastened
On fixed. The right hand rear passenger hasunfastened their seat belt.
Pull the strap then inser t the ton
gue in the buckle.Left hand rear seat beltunfastened
On fixed. The left hand rear passenger hasunfastened their seat belt.

Page 28 of 164

Monitoring
26
Main battery state of charge indicator
Display

Four successive aler ts indicate that the energyavailable in the main battery is dropping to alow level:


- 2 bars of the state of charge gauge in the
instrument panel, on and flashing: star tingto use the reserve.

- The last bar in the state of charge gauge flashing.

- The last bar disappears: display of the
range disappears; the heating and air conditioning are switched off.

Low energy alerts
- Display of this warning lamp in
the instrument panel: progressive reduction in the power availablefrom the motor.
The state of char
ge of the main battery is displayed continuously in the instrument panel.

Page 37 of 164

2
!
Access
35





Doors


From outside
)After unlocking the vehicle using theremote control or the key, pull the door handle.
From inside
)
Pull the front or rear door control to open
the door.
If the doors are locked, opening the driver's door does not unlock the other doors.
- opening the driver's door unlocks the other doors,
- the front passenger or rear doors must
then be unlocked manually using the frontlocking control before they can be opened.
I
f a door or the boot is not closedcorrectly, this warning lamp comes
on in the instrument panel until the
door in question or the boot is closed.

Opening
Closin
g
Locking/unlocking from the
inside
) Press the button on the driver's door
towards the front to lock and towards
the rear to unlock the vehicle completely.
The buttons on the front and rear passenger doors only lock/unlockthe door in question.

Page 41 of 164

3
!
Comfort
39






Head restraint height adjustment
)To raise it, pull upwards. )To lower it, push it downwards, pressing
the height adjustment button at the same
time.)To remove it, raise it to the high position,
then remove it pressing the height
adjustment button at the same time.)To refit it, engage the rods of the head restraint in the apertures, pressing the height adjustment button at the same time.
Never drive with the removed headrestraints in the vehicle as they couldbe thrown around the vehicle on sharp braking. They must always be in placeand adjusted correctly.
After installing the head restraint, checkthat the height adjustment button has engaged correctly. The adjustment is correct when the top of the head restraint is aligned with thetop of the head of the seated person.
Press the control switch, located on
the dashboard, to switch on the driver's seat
heatin
g.
The warning lamp in the switch comes on.
The temperature is controlled automatically.
Pressing a second time stops operation.


Heated seat control

Page 55 of 164

4
!
Driving
53





Manual parking brake


Applying
)Pull the parking brake lever fully up to
immobilise your vehicle.
When parking on a slope, direct your wheels against the kerb, apply the parking brake, place the drive selector in position P and switch off the ignition.

Releasing
)
Pull the parking brake lever up gently,
press the release button then lower
the lever full
y.
When the vehicle is being driven, i
f
the parking brake is still on or hasnot been fully released, this warning
lamp comes on.

Page 71 of 164

7
i
Safety
69











Direction indicators

Selection of the left or right direction indicators
to signal a change of direction of the vehicle. )Left: lower the lighting stalk beyond
the point of resistance. )Right: raise the lighting stalk beyond
the point of resistance.









Hazard warning lamps

A visual warning by means of the directionindicators to alert other road users to a vehiclebreakdown, towing or accident.)
Press this button, the direction indicators flash.
They can operate with the ignition off.





Horn
Audible warning system to aler t other road
users to an imminent danger. ) Press the central part of the steering wheel.

Use the horn moderately and only in the following circumstances:


- immediate danger,

- approaching a location lackingvisibility.

Page 73 of 164

7
i
!
Safety
71

Operating fault

When the vehicle is stationar
y

The warning lamp comes on for a few seconds when the ignition is switchedon (ON position). If it does not go off or does not come on, contact a CITROËNdealer or a qualified workshop. I
f this warning lamp comes oncontinuously it indicates a malfunction of the wheel anti-lock braking system
which could result in a loss of controlof the vehicle on braking.
You must stop as soon as it is safe to do so.Contact a CITROËN dealer or a qualifiedworkshop.
When the vehicle is moving
Illumination of these twowarning lamps indicates a
malfunction of the electronic brake force distributionwhich could result in a loss of control of
the vehicle on braking.
You must stop as soon as it is safe to do so.Contact a CITROËN dealer or a qualifiedworkshop.
When replacing wheels (tyres and rims),
ensure that they conform to the manufacturer's recommendations.
The illumination o
f this warning lampit indicates a malfunction of the wheelanti-lock braking system, which could result in a loss of control of thevehicle when braking.
Contact a CITROËN dealer or a qualified
workshop.
Emergency braking assistance
System which, in an emergency, enables you
to obtain the optimum braking pressure more quickly, thus reducing the stopping distance.
Activation
It is triggered by the speed at which the brake pedal is pressed.
The effect of this is a reduction in theresistance of the pedal and an increase in
braking efficiency.
When braking in an emergency, press firmly without releasing the pressure.

Page 74 of 164

!
Safety
72
Anti-slip regulation (ASR)
and electronic stability
programme (ESP)














Trajectory control systems



Deactivation

In exceptional conditions (starting a vehicle
which is bogged down, stuck in snow, on soft ground, ...), it may be advisable to deactivate
the ASR and ESP systems, so that the wheels can move freely and regain grip. ) Press this button button, located on the
dashboard to the right of the steeringwheel, until the corresponding symbol
appears in the instrument panel screen.
Activation
These systems are activated automatically each time the vehicle is started.
They come into operation in the event of a grip
or trajectory problem.
The displa
y of this symbol indicates
that the ASR and ESP systems are deactivated.

Reactivation

These systems are not reactivated automatically.
)Press this button again to reactivate themmanually.
The symbol going off in the instrument panel indicates
the reactivation of the ASR and ESP systems. The anti-slip regulation (also known as Traction Control) optimises traction to prevent skidding
of the wheels, by acting on the brakes of the
driving wheels and on the engine.
The electronic stability programme acts on the
brake of one or more wheels and on the engine
to keep the vehicle on the trajectory requiredby the driver, within the limits of the laws of physics.
This is indicated b
y flashing of this
warning lamp in the instrument panel.


The ASR/ESP systems offer exceptional safety in normal driving, butthis should not encourage the driver to take extra risks or drive at high speed.
The correct functioning of these systems depends on obser vation of the manufacturer’s recommendationsregarding the wheels (tyres and rims),the braking components, the electronic components and the assembly and repair procedures used by theCITROËN dealer network.
After an impact, have these systems checked by a CITROËN dealer or a qualified workshop.



Operating fault
The display of this message in the instrument panel indicates a malfunction of
these systems.
Contact a CITROËN dealer or a
qualified workshop
to have the ASR /ESP systems checked.

Page 75 of 164

7
Safety
73
Seat belts


Front seat belts
Fastening
)
Pull the strap, then inser t the tongue inthe buckle A.)
Check that the seat belt is fastened correctly by pulling the strap.



Front seat belt not fastened/
unfastened warning lamp

If the driver does not fasten their seat
belt within one minute after switching on
the ignition, the warning lamp flashes
accompanied by an intermittent audible signal.
After about 90 seconds, the warning lamp, the
audible signal and the display stop, and then
return until the driver fastens their seat belt.
If the seat belt is unfastened while the vehicle is moving
, you are warned by the same alerts.

Th
e front seat belts are fitted with a
pretensioning and force limiting system.
This system improves safety in the frontseats in the event of a front or side impact.
Depending on the severity of the impact,
the pretensioning system instantly tightens
the seat belts against the body of the
occupants.

The pretensioning seat belts are active when
the ignition is on.
The force limiter reduces the pressure of
the seat belt on the chest of the occupant,so improving their protection.

Unfastening
)
Press the red button on the buckle A
.

When the ignition is switched on, this
warning lamp comes on accompanied
by an audible signal for a few secondsif the driver and/or passenger has notfastened their seat belt.

Page:   < prev 1-10 11-20 21-30 31-40 next >