ESP Citroen C1 2008 1.G User Guide

6
56
SAFETY When this warning light
comes on, it indicates that
there is a malfunction of the
ABS, which can cause a
loss of control of the vehicle
when braking.
Consult a CITROËN dealer.
When these warn-
ing lights come on
s i m u l t a n e o u s l y,
it indicates that
there is a malfunc-
tion of the braking system or that the
handbrake has not been released
fully, which can cause a loss of con-
trol of the vehicle when braking.

Stop immediately.
Consult a CITROËN dealer.
Normal operation of the ABS
may make itself felt by slight
vibrations of the brake pedal.

In emergency braking,
press very fi rmly without
releasing the pressure. TRACTION CONTROL (ASR)
AND DYNAMIC STABILITY
CONTROL (ESP)
These systems are linked and sup-
plement the ABS.
The ASR system optimises drive to
prevent the wheels skidding, by act-
ing on the brakes of the driving wheels
and on the engine. It also allows the
directional stability of the vehicle to
be improved on acceleration.
If there is a variation between the tra-
jectory followed by the vehicle and
that required by the driver, the ESP
system automatically acts on the
brake of one or more wheels and on
the engine to put the vehicle back on
course, within the limits of the laws
of physics.
Operating check
Operation of the ASR and ESP
systems When one of these two
systems is operating, this
warning light comes on. When a malfunction of the
systems occurs, this warning
light comes on.
The ASR/ESP systems offer
exceptional safety during nor-
mal driving, but this should not
encourage the driver to take
extra risks or drive at high speed.
Correct operation of these systems
depends on observation of the man-
ufacturer’s recommendations re-
garding the wheels (tyres and rims),
the braking components and the
electronic components as well as the
CITROËN assembly and operation
procedures.
After an impact, have these systems
checked by a CITROËN dealer.
Activation of the ESP system is also
accompanied by an audible signal. Contact a CITROËN dealer to have
the systems checked.

7
62
DRIVING Driver information
The symbol which corresponds to the
selection, R , N , E or M and the number
of the gear engaged 1 to 5 , are displayed
on the instrument panel screen.
SENSODRIVE GEARBOX
The fi ve-speed "SensoDrive" gearbox
offers a choice between the comfort of

automatic operation or the pleasure of

manual gear changing .
Driving mode
Select the driving mode by moving
the gear lever.

R everse "R". This gear will be en-
gaged when stationary or at a speed
below approximately 4 mph (6 km/h).
The switch to reverse gear is accom-
panied by an audible signal.

N eutral "N".
Position the lever to the right in position

N , to start the engine .

E asy "E": automatic gear changing.

M anual ( +/- ) "M": manual gear changing.
Starting the vehicle
With the handbrake applied, press
the brake pedal then select position

N to start the engine.
With your foot on the brake, select
position R , E or M .
Release the handbrake, take your
foot off the brake pedal, then accel-
erate.

Notes: with the engine running,
in these three positions, an au-
dible signal is heard when the
driver’s door is opened.
You can change from position E to
position M and vice versa at any
time.

8
68
CHECKS
CHECKS Oil filter
Change the fi lter regularly, in accor-
dance with the servicing schedule. Only use products recom-
mended by CITROËN or
products of equivalent quality
and characteristics.
In order to optimise the op-
eration of units as important as the
braking circuit, CITROËN selects
and offers specifi c products.
In order to avoid damaging the elec-
trical units, high pressure washing
to clean the engine compartment is
strictly prohibited.
To check the main levels and certain
components, in accordance with the
manufacturer’s servicing schedule,
refer to the pages of the servicing
booklet which correspond to your
vehicle’s engine.
Battery
At the start of winter, have your battery
checked by a CITROËN dealer.
Air filter and passenger
compartment filter
Have the fi lter elements replaced regu-
larly.
If you drive in dusty conditions,
change them twice as often.
Brake pads
Brake pad wear depends on the style
of driving, in particular for vehicles
which are used in town, over short
distances.
Disc and drum wear status
For any information relating to disc
and drum surface wear, contact a
CITROËN dealer. Manual gearbox
Have the level checked in accordance
with the manufacturer’s servicing
schedule.
RUNNING OUT OF FUEL (DIESEL)
It may be necessary to check
the thickness of the pads,
even between services.
If the engine stops, it is pos-
sible to restart it to drive a
short distance by operating
the pump at least 10 times.
If you run out of fuel, the circuit must be
reprimed:
- fi ll the fuel tank with at least fi ve litres of diesel,
- squeeze and release the manual repriming pump at least 10 times.
This is located under the protective
cover which must fi rst be unclipped
and then removed,
- operate the starter until the engine starts.

Notes: if the engine does
not start after approximately
15 seconds of attempts, op-
erate the repriming pump
again approximately fi fteen times be-
fore trying again.
If the emission control warning light has
come on, it will only switch off after your
vehicle has been used several times.
Handbrake
Where the handbrake travel is too
great or there is a reduction in the
performance of the system, the
handbrake should be adjusted, even
between services.
Have the system checked by a CITROËN
dealer.

9
78
PRACTICAL INFORMATION

Fuse N° Rating
Functions

1 50 A "SensoDrive" gearbox - Fan assembly (diesel)

2
10 A Headlamps

20 A Headlamps with daytime lights

3 30 A ABS/ESP control unit

4 30 A Ignition switch supply

5 10 A Hazard warning lights - Instrument panel warning lights - Direction indicators

6 10 A Headlamps

7 15 A Courtesy light - Speedometer - Audio equipment - Instrument p anel - Rev counter

8 15 A/25 A Petrol/diesel engine control unit

9 10 A Horn

10 30 A Fan assembly (petrol)

11 50 A ABS/ESP

12 50 A Power steering