tow Citroen C1 DAG 2010.5 1.G User Guide

Page 75 of 97

8
71
CHECKS
Oil filter
Change the fi lter regularly, in accor-
dance with the servicing schedule. Only use products recom-
mended by CITROËN or
products of equivalent qual-
ity and specifi cation.
In order to optimise the operation
of units as important as the braking
system, CITROËN selects and offers
specifi c products.
In order to avoid damaging the elec-
trical units, high pressure washing
to clean the engine compartment is
strictly prohibited.
To check the main levels and certain
components, in accordance with the
manufacturer's servicing schedule,
refer to the pages of the servicing
booklet which correspond to your
vehicle's engine.
Battery
At the start of winter, have your bat-
tery checked by a CITROËN dealer
or a qualifi ed workshop.
Air filter and passenger
compartment filter
Have the fi lter elements replaced regu-
larly.
If you drive in dusty conditions,
change them twice as often.
Brake pads
Brake pad wear depends on the style
of driving, in particular for vehicles
which are used in town, over short
distances. Disc and drum wear
For information on disc and drum
surface wear, contact a CITROËN
dealer or a qualifi ed workshop.
Manual gearbox
Have the level checked in accord-
ance with the manufacturer's servicing
schedule.
It may be necessary to check
the thickness of the pads,
even between services. Parking brake
Where the parking brake travel is too
great or there is a reduction in the
performance of the system, the park-
ing brake should be adjusted, even
between services.
Have the system checked by a
CITROËN dealer or a qualifi ed work-
shop.

Page 76 of 97

9
72
PRACTICAL INFORMATION
Parking the vehicle

 As far as possible, immobilise the
vehicle on level, stable, non-slip-
pery ground.

 Apply the parking brake, switch
off the ignition and engage fi rst
gear or reverse for the manu-
al gearbox, position N for the
"SensoDrive" gearbox. Tools
The following tools are installed in a
carrier, located in the centre of the
spare wheel:

1. Wheelbrace

2. Jack with handle

3. Removable towing eye
Access to the spare wheel and
the jack in the boot

 Remove the carpet then the plas-
tic cover using the handle. Tyre pressures
These are indicated on the label po-
sitioned on the inner pillar of the left
door, see "Identifi cation".
CHANGING A WHEEL

 If necessary, chock the wheel di-
agonally opposite the wheel to be
changed.

 It is imperative that you ensure
that the occupants get out of the
vehicle and wait in a safe loca-
tion.

Page 81 of 97

9
77
PRACTICAL INFORMATION
DIRECTION INDICATOR SIDE REPEATERS (WY 5 W AMBER)

 Push the repeater forwards or
rearwards and detach it by pull-
ing towards you.

 Disconnect the bulb holder and
change it.
CHANGING A FUSE
The fuseboxes are located under the
instrument panel trim and next to the
battery in the engine compartment.

Good
Removing and fitting a fuse
Before changing a fuse, the cause of
the incident must be found and recti-
fi ed.

 Use the tweezer A located in the
fusebox under the bonnet.

Failed

Tweezer A Instrument panel fuseboxes
These are located on each side of
the instrument panel under the trim.

 Turn the steering wheel to the
left, remove bolt B .

 Turn the steering wheel to the
right (do not forget to release the
steering wheel using the key), re-
move bolt C .
Always replace a faulty fuse
with a fuse of the same rating
(same colour).

Page 84 of 97

9
77
PRACTICAL INFORMATION
DIRECTION INDICATOR SIDE REPEATERS (WY 5 W AMBER)

 Push the repeater forwards or
rearwards and detach it by pull-
ing towards you.

 Disconnect the bulb holder and
change it.
CHANGING A FUSE
The fuseboxes are located under the
instrument panel trim and next to the
battery in the engine compartment.

Good
Removing and fitting a fuse
Before changing a fuse, the cause of
the incident must be found and recti-
fi ed.

 Use the tweezer A located in the
fusebox under the bonnet.

Failed

Tweezer A Instrument panel fuseboxes
These are located on each side of
the instrument panel under the trim.

 Turn the steering wheel to the
left, remove bolt B .

 Turn the steering wheel to the
right (do not forget to release the
steering wheel using the key), re-
move bolt C .
Always replace a faulty fuse
with a fuse of the same rating
(same colour).

Page 85 of 97

9
77
PRACTICAL INFORMATION
DIRECTION INDICATOR SIDE REPEATERS (WY 5 W AMBER)

 Push the repeater forwards or
rearwards and detach it by pull-
ing towards you.

 Disconnect the bulb holder and
change it.
CHANGING A FUSE
The fuseboxes are located under the
instrument panel trim and next to the
battery in the engine compartment.

Good
Removing and fitting a fuse
Before changing a fuse, the cause of
the incident must be found and recti-
fi ed.

 Use the tweezer A located in the
fusebox under the bonnet.

Failed

Tweezer A Instrument panel fuseboxes
These are located on each side of
the instrument panel under the trim.

 Turn the steering wheel to the
left, remove bolt B .

 Turn the steering wheel to the
right (do not forget to release the
steering wheel using the key), re-
move bolt C .
Always replace a faulty fuse
with a fuse of the same rating
(same colour).

Page 92 of 97

9
84
PRACTICAL INFORMATION
TOWING THE VEHICLE

Your vehicle can only be towed at
the front.
Lifting (2 wheels only
on the road)

Never use the radiator crossmember.
Towing with fours wheels on the road
must be carried out at very low speed
over a very short distance (in accor-
dance with the legislation in force).
In all other cases, your vehicle must
be transported on a trailer.
Without lifting
(4 wheels on the road)
The removable towing eye is stored
in the spare wheel, under the boot
carpet.

 Unclip the bottom of the cover,


Screw in the towing eye until it locks.
Place the gear lever in posi-
tion N for the "SensoDrive"
gearbox.
FITTING ROOF BARS
Please refer to national legis-
lation in order to comply with
the regulations concerning the
transportation of objects which
are longer than the vehicle.
Vehicles fitted with a manual
gearbox
In the case of vehicles fi tted with a
manual gearbox, the gear lever must
be in the neutral position.
Failure to observe this special con-
dition may result in damage to cer-
tain braking components and the
absence of braking assistance the
next time the engine is started.
When fi tting transverse roof bars,
use the accessories recommended
by CITROËN and follow the manu-
facturer's fi tting instructions.
For more information, contact a
CITROËN dealer or a qualifi ed work-
shop.

Maximum weight authorised on
the bars, for a loading height not
exceeding 40 cm (except bicycle
carrier): 50 kg.

If the height exceeds 40 cm, adapt
the speed of the vehicle to the pro-
fi le of the road to avoid damaging
the roof bars.
General
recommendations
Observe the legislation in
force in your country.
Ensure that the weight of the tow-
ing vehicle is higher than that of the
towed vehicle.
The driver must stay at the wheel of
the towed vehicle.
Driving on motorways and fast roads
is prohibited when towing.
When towing a vehicle with all four
wheels on the ground, always use an
approved towing bar; rope and straps
are prohibited.
When towing a vehicle with the en-
gine off, there is no longer any power
assistance for braking or steering.
In the following cases, you must al-
ways call on a professional recovery
service:
- vehicle broken down on a motor- way or fast road,
- when it is not possible to put the gearbox into neutral, unlock the
steering, or release the parking
brake,
- towing with only two wheels on the ground,
- where there is no approved towing bar available...

Page:   < prev 1-10 11-20