steering CITROEN C3 2009 User Guide

Page 129 of 209

11
PRACTICAL INFORMATION
This repair kit is available from
CITROËN dealers.
It is designed to repair holes of a
maximum diameter of 6 mm, only
where the puncture is located on
the tyre tread or shoulder. Avoid
removing any foreign bodies
which have penetrated the tyre.
TEMPORARY PUNCTURE
REPAIR KIT
Complete system consisting of a compres-
sor and an incorporated sealant cartridge
which permits temporary repair of the
tyre so that you can drive to the nearest
garage.
The kit is mounted in the boot under the
fl oor. Using the kit
This procedure, comprising several
steps, must be carried out in full.

 Switch off the ignition.


Turn the selector A to the "SEALANT"
position.

 Check that the switch B is in posi-
tion "0" .

 Connect the white pipe C to the
valve of the tyre to be repaired.

 Connect the compressor's electric
plug to the vehicle's 12 V socket.

 Affi x the speed limitation sticker to
the vehicle's steering wheel to re-
mind you that a wheel is in temporary
use.

 Start the vehicle and leave the engine
running.
Access to the kit

Page 144 of 209

11
PRACTICAL INFORMATION

Fuse N° Rating Functions

F8 20 A Multifunction screen, audio system, navigation
radio, instrument panel with clock, alarm control
unit, alarm siren.

F9 30 A Audio system (after-market), 12 V socket, portable
navigation support supply.

F10 15 A Steering wheel controls.

F11 15 A Ignition, diagnostic socket, automatic gearbox
control unit.

F12 15 A Rain/brightness sensor, trailer relay unit, driving
school module.

F13 5 A Main stop switch, engine relay unit.

F14 15 A Parking assistance control unit, airbag control unit,
instrument panel, automatic air conditioning,
USB Box, HiFi amplifi er.

F15 30 A Locking.

F16 - Not used.

F17 40 A Rear screen and exterior mirrors demisting/
defrosting.

SH - PARC shunt.

Page 145 of 209

11
PRACTICAL INFORMATION
Engine compartment fusebox
The fusebox is placed in the engine
compartment near the battery (left-hand
side).
Access to the fuses

 Unclip the cover.

 Change the fuse (see correspond-
ing paragraph).

 When you have fi nished, close the
cover carefully to ensure the sealing
of the fuse box. Fuse table

Fuse N° Rating Functions

F1 20 A Engine control unit supply, cooling fan unit control
relay, multifunction engine control main relay,
injection pump (Diesel).

F2 15 A Horn.

F3 10 A Front/rear wash-wipe.

F4 20 A Daytime running lamps.

F5 15 A Diesel heater (Diesel), particle fi lter additive pump
(Diesel), air fl ow sensor (Diesel),
EGR electrovalve (Diesel), fuel pump (1.1i and 1.4i), blow-by heater
and electrovalves (VTi).

F6 10 A ABS/ESP control unit, secondary stop switch.

F7 10 A Electric power steering, automatic gearbox.

F8 25 A Starter control.

F9 10 A Switching and protection unit (Diesel).

F10 30 A Fuel heater (Diesel), blow-by heater (1.1i, 1.4i and
Diesel), fuel pump (VTi), injectors and ignition coils
(petrol), electronic thermostat and canister purge
electrovalve (1.1i and 1.4i).

F11 40 A Heater blower.

Page 152 of 209

11
PRACTICAL INFORMATION
Failure to observe this special
condition could result in damage
to certain braking components
and the absence of braking as-
sistance the next time the engine
is started. When towing with all four wheels
on the ground, always use a
towing bar.
When towing with only two wheels
on the ground, always use profes-
sional lifting equipment.
When towing with the engine off,
there is no longer any assistance
for braking or steering.
TOWING THE VEHICLE
Procedure for having your vehicle towed
or for towing another vehicle using a re-
movable towing eye.
Access to the tools
The towing eye is installed in the boot
under the fl oor.
To gain access to it:

 open the boot,

 raise the fl oor,

 remove the polystyrene storage box,

 remove the towing eye from the
holder. Towing your vehicle

 On the front bumper, unclip the cover
by pressing at the bottom.

 Screw the towing eye in fully.

 Install the towing bar.

 Switch on the hazard warning lamps
on the towed vehicle.

 Place the gear lever in neutral (posi-
tion N for an automatic gearbox). Towing another vehicle

 On the rear bumper, unclip the cover
by pressing at the bottom.

 Screw the towing eye in fully.

 Install the towing bar.

 Switch on the hazard warning lamps
on the towed vehicle.

Page 156 of 209

11
PRACTICAL INFORMATION
Depending on the country in
which the vehicle is sold, it may
be compulsory to have a high
visibility safety jacket, warning
triangle and spare bulbs avail-
able in the vehicle.
The fi tting of electrical equip-
ment or accessories which are
not recommended by CITROËN
may result in a failure of your ve-
hicle's electronic system and ex-
cessive electrical consumption.
Please note this specifi c warn-
ing. You are advised to contact
a CITROËN representative to be
shown the range of recommended
equipment and accessories.

"Personalisation": seat covers, leath-
er steering wheel, gear lever knob, satin
chrome or black gloss interior kit, alu-
minium footrest, alloy wheels, wheel
trims, sill protectors, chrome tailgate fi n-
isher, chrome tailpipe fi nisher, chrome
mirror shells, chrome door handles...

"Accessories": windscreen wash fl uid,
interior and exterior cleaning and main-
tenance products, bodywork touch-up
aerosol and pen...
You can obtain an "Enterprise" kit to
convert a trade vehicle to a private car.

Page:   < prev 1-10 11-20